0
Honda Accord LX
The Accord LX was launched in 1978 as a 3-door coupe and was later re-designed as a 4-door hatchback and 4-door sedan. The latest model is available as a 4-door sedan powered by a 2.4 liter engine.
4,658 Questions
What does code P1167 mean for a 1998 Honda Accord?
o2 sensor My list shows P1167 Invalid Test,throttle not depressed
Why won't a 2002 Ford Escort shift from park to drive?
Most likely it is the shifter interlock witch locks the shifter so children or even a n adult dose not mistakenly knock the shifter out of park. some cars that the interlock dose not release when in park or when key is in the run position will shift in the acc. mode where you can listen to the raido but not use things like power windows or wipers. I would try that then put it in neutral and try starting the car with the parking brake on. if it comes out of par then it is the interlock and you can use the steps I mentioned before to start the car till you get it to a mechanic. good luck hope this helped.
When to change plug wires cap rotor on 1999 accord lx vtech?
I recommend you change them at 100,000 miles unless the engine starts to run rough, miss, or get poor fuel economy before that.
What would cause a 1991 Honda Accord automatic transmission to not shift out of third gear?
The transmission may need a flush and filter, or in my 92 accord I solved the problem merely by changing the transmissions computer.
Where is the throttle position sensor on a 2000 Honda accord LX?
On the back of the throttle body, up against the firewall. On the the '00 LX they are riveted on though, and I haven't heard of a way to avoid replacing the entire TB. Good luck.
Where is fuelpump on 1992 Honda Accord?
Inside of the gas tank. The only way to get to it is by removing the tank from the car.
You will find that inside the trunk underneath the carpet there will be a cap you can remove, this is not the fuel pump, I promise you. It is the float for the gas meter. I don't recommend removing this, I did and it resulted in a strong smell of gas every time I fill up.
Where do you add Brake fluid to a 1988 Honda Accord?
At the master cylinder brake fluid reservoir located driver's side next to the firewall on top of the master cylinder. Use DOT 3 fluid.
It may be. Although the most common culprit is a warped rotor, I'm sure the sway bar link is not helping the problem at all. They can be extremely inexpensive (approx. $5-15 each, though some designs can run up to $100 [rare]), so I would suggest replacing it.
How do you fix diagnostic trouble code 24 on 1997 Honda Accord lx?
I have never heard of a code 24 on a Honda.
How do you remove a 2004 Honda Accord ABS sensor broken inside the axle?
it can easily be removed my using a 14" black dildo
How do you repair or replace the spark plugs in a 2001 Mitsubishi Galant V4?
Spark plugs are rarely repaired on a car. It is easier to replace them and have the confidence of having dependable transportaion. If you look at the top of your valve cover(place wheve you put oil) towards the rear, you'll see a series of cords to 2 circular and 2 square black connectors. The circular connections are directly to your plugs and the square connectors are to your coil packs. Be sure to note which coil pack controls which plug. The easiest way is to replace is to first remove the coil pack(held on by 2 bolts 10mm in size, I think), replace the plug and then replace the associated plug. CAUTION!!! If you are replacing the plugs because of emissions and a check engine soon light... It very well might be a coil pack that has failed. It took me two months, an EGR, spark plug wires, 2 sets of plugs, an oxygen sensor and diagnostic testing to figure this out. One symptom is if your car loses power and stalls; especially on hills or high stress situations.
In the trunk there should be a small cable with a tag attached to it in the same area of the fuel door, this is the emergency fuel door release
What is good mileage for a 1994 Honda accord?
Try to stay away from anything over ten years old you will just have a headache figure an average of 12k per year.
Obviously you'll want as low of mileage of a car as you can afford to buy. Don't be afraid of it necessarily because it's 15 years old. These cars are well known to last 200,000+ miles. Test drive it carefully with the radio off. Make sure it shifts well, and does not overheat. Listen for noise from the front drive axles, and check the condition of the rubber boots. Look for general condition, rust, tire wear on the front tires, no home-made wiring, etc. If those things are all ok, you'll be fine.
How do you spray starter fluid into your intake?
Its best to take the tubing off to get a clear shot to the intake. Also be warned if you have someone helping you start the car dont stand too close to the intake because I have seen a burst of flames come out a few times
How do you change the fast idle sensor valve on a 1991 Honda Accord EX?
well the fast idle thermo valve ,is on the top of the motor right on the intake manifold,it has two screws on the top, let engine warm up , take the screws out. put finger over and gently push ,with engine running. If no air flow replace valve,or unscrew the plastic top of valve, and with sand paper placed face up on a flat surface sand down bottom of valve. This will let the heat reactive part of the valve shut of sooner blocking the excess air from entering the intake manifold and raising idle.
How to get into the trunk of a 96 Geo Metro the key does not work?
Sometimes you can remove the back seat and access it that way.
What does a flashing S symbol on the control panel indicate on a Honda Accord DX?
Problem with the auto tranny.
How do you reset the ecu on a lancer 98 glxi 4g92?
Just remove the Battery for 15 sec. (+) then it is reset already, Rizal
What kind of transmission does the 2006 Honda Accord have?
The 2006 Honda Accord has a 5-speed manual.
How do you replace the headlight bulb located on a 1997 Honda Accord EX?
I am assuming this headlight is on the passenger side. I own a 96 Accord which is the same as a 97. the right headlight (low beam) is located in front the intake ( a black plastic part) which is right next to your battery. To change the low-beam head light bulb, remove the intake plastic cover (it is actually a tube), then remove the bad bulb by disconnecting the 9006 connector and twist the holder. After replacing the bulb, twist the holder back and reconnect the 9006 connector, install the intake cover and you are done. It is recommended to change both bulbs at the same time, however this is not required.
More Information:
The directions are above are great. except when twisting the holder it may stick. I found that taking a screwdriver and placing it on the little protruding black plastic piece and hitting it gently with a hammer will loosen the holder up. When looking at the holder from the front of the car it will turn to your right.
Responses from people who used this answer:
This was extremely helpful. I also had to tap the connector with hammer and screwdriver to remove it from the 9006 bulb connector wire. The rotating lock washer will not rotate the unlocked position while the connector is still on the 9006 bulb. Thank You.
Thanks to all ! These answers worked for me, I have a 96 Accord EX with a passenger side lamp out, I follow these suggestions and it was changed with in minutes with a little elbow grease. The hammer and screw driver suggestion was invaluble. Thanks again all !!!
This worked quite well for me. One thing to note: the 9006 lamp (bulb) itself won't turn, but the larger, dark gray locking ring does turn to release it. In other words, the connector for the bulb is initially pointing downward toward the ground, and it will remain that way after you turn the locking ring a quarter turn or less.
One answer above, the user talked about using a screwdriver to gently tap off the connector, while other users were talking about tapping off the lock ring. Works for both as I just did it for both. Also, if not sure which way the lock ring rotates, take a gander at it. There is a white or gray tab that sticks up in a curved slot. When the ring is in the locked position, the tab will be at one end of this curved slot that travels around it. Lastly, this lock ring doesn't come off to remove bulb, it simply rotates to the unlocked position, then the bulb will come right out. Easy job.
I signed up for this just to say thank to everyone for this info. The manual doesn't explain that you have to tap the circular locking mechanism with flat head and hammer. I spent 20 minutes trying to muscle the bulb to turn. You gotta love the internet. :)
Can you get a stereo wiring diagram for your Honda Accord DX?
Try modifiedlife.com
You can find the diagram for any year Honda there.
Is there a special air bleed procedure when you replace antifreeze in a 1992 Honda Accord?
After you drain and refill, turn on the heater all the way hot. Then after 5 minutes open the bleed bolt on the thermostat housing to bleed the air out. - - - - - The way I always do it is to open the bleed bolt (12mm deep well socket), turn the heat on full, then add coolant to the radiator while watching the bleed bolt. When coolant comes out of it, add just a little more to the radiator, and close the bleed bolt. Don't get stupid with the torque; it's an aluminum bolt screwed into an aluminum fitting, which means it can't take a lot of force. Just get it snug. Put on the radiator cap and you're done.
