Hyundai Excel

To change the license plate bulb on a 2007 Hyundai Sonata, first, open the trunk and locate the license plate light assembly. Use a flathead screwdriver or a similar tool to gently pry off the lens cover. Remove the old bulb by turning it counterclockwise, then insert the new bulb by turning it clockwise into the socket. Finally, reattach the lens cover and ensure it is secure.

If the fuel gauge in your 1997 Hyundai Excel isn't working, it could be due to a faulty fuel sending unit, a broken wiring connection, or a malfunctioning gauge itself. First, check the fuses related to the fuel system for any issues. If the fuses are intact, inspect the wiring and connections at the fuel tank and the instrument cluster. If all else fails, consider consulting a mechanic to diagnose and repair the problem.

To replace the rear shock absorbers on a 1996 Hyundai Excel, first, safely lift and support the rear of the vehicle using jack stands. Remove the rear wheels to access the shock absorbers. Unbolt the top and bottom mounts of the shock using the appropriate socket and wrench, then remove the old shock absorbers. Install the new shocks by reversing the removal process, ensuring all bolts are tightened to the manufacturer's specifications, and then reattach the wheels before lowering the vehicle.

To replace the fuel pump in a 1994 Hyundai Excel, start by disconnecting the negative battery terminal for safety. Remove the rear seat cushion to access the fuel pump access cover, then disconnect the fuel lines and electrical connectors from the pump. Unscrew and lift out the old fuel pump assembly, then install the new pump in reverse order, ensuring all connections are secure before reassembling the seat and reconnecting the battery. Finally, check for any leaks and ensure everything is functioning properly.

On a 1998 Hyundai Excel, the fuel pump relay is typically located in the engine compartment fuse box. To access it, open the hood and locate the fuse box near the battery. The relay may be labeled, so refer to the diagram on the cover for identification. If you're still having trouble, the owner's manual may provide additional guidance.

The 1995 Hyundai Excel GLX typically comes equipped with 4-inch front speakers and 6-inch rear speakers. These sizes are standard for many compact cars of that era, providing basic audio performance. For optimal sound quality, upgrading to aftermarket speakers is often recommended.

I'm attempting the same thing in my Mother-In-Law's 1996 Hyundai Accent. I've found that you need to start by removing the ashtray to expose the 2 screws on either side of the ashtray (inside). Remove these screws, then gently pry the center dash away (some of the clips might spring, but you can replace these later.

That's as far as I have gotten so far. There seems to be another fastener someplace in the lower left portion of the center dash that holds it in place. I am working to get this removed, but to no avail.

This Might sound simple but it's a pig..... Good LUCK.

Remove the Ashtray, Remove the 2 screws in the ashtray compartment! Now you need to undo the heater control clips 2 under the drivers side then 1 behind the glovebox.(this took me 2 hours to find!!!!!!!!! Then slide center control unit out. You then have to undo the stereo retaining screws and slide the stero out.... You might have to take the cables off the clock and hazzard lights too. Replace in reverse order and hay presto you are done!!!! Shame I didnt have this info before starting!!!!! Oh well it's done now!!!!!!!!!!!!

I could not see the 2 clips until I removed the cover plate under the steering wheel. Once I could see the heater control cables it was obvious what was being said. I disconnected them and the one behind the glovebox and all proceeded as stated above.

I paid a mechanic to do it for me when buying the head unit, it took him an hour including installing two speakers because he had to remove the entire heating unit... so he says to take the stock CD player out and install the new one.

under the manifold, left side of the motor. 2 bolts is all you need to undo it. You may have to take some hoses off to get to it

I do believe that 91 and 94 are the same procedure.

have to remove the door handle and the window handle. there is a clip that holds the window handle.

There are three screws that hold the unit (window regulator)in place. You will have to get the window up and out of the carrier and, pull the unit out.

put the new unit in and,place the window in the carrier but, make sure the window is at the full closed position (that is where you need another set of hands) then, you tighten up the screw in the unit.

The window is seated at the full closed position therefore when you tighten the unit up is wont twist. when I got someone else to replace the window regulator they had that window in the down position and the new regulator lasted about 2 weeks and then broke again... thanks mr mechanic....grin

Take the bolt to a machine shop and they can tell you . if you dont have it most metric auto bolts have a 125 thread pitch but i dont know the diameter.

Mounted on top and inside the fuel tank.

Plug on the upper side of the transmission. Use only the proper lube as outlined in your owner's manual.

On top of the middle console on the right. This button needs to be removed to take out the middle console, so it happens the plastic click systems fails and the button wont go back on.

Too much oil, only thing I can think of. Either that or your seals on the cap are worn.

Perhaps the A/C is drawing too much power from the engine, could be the engine is idling too low.

The code is based on the car's serial number, not the model- each code is different. However, you can get radio code calculators online (you should buy them from the reputible sources online, not download the identical software for free from torrent sites or p2p networking clients... ahem)

In order to get the serial number you need for the calculator to work, you'll have to remove the radio.

Most car radios (at least from that era) are held in place by two or four locks that you can see as 4 holes in each corner of the front panel of the radio. Many car acessory stores will carry the tol to unlock this, but you can make your own with any strip of metal that fits into those holes (I used an old TV Ariel and cut two lenths of metal off of it).

Then, put the metal into all 4 of the holes at once and push them away from the radio (i.e. push the apart) and pull. Your radio should be romoved and the seriel will be printed on the top or the back somewhere. After that, you have everything you need to unlock the radio.

Drain hole is underneath on the fan belt side, loosen the bolt and out it comes, be ready. There is a diagram in the service manual, google one if you don't have one.

how much we should put oil in engien in Hyundai excel lx.

A fuse box diagram for a 1994 Hyundai Excel is found on the fuse box itself. Underneath the cover of the fuse box will be a sticker labeling all the fuses.

1-3-4-2

Push the door panel in around the window handle and use a screwdriver or a piece of wire with a hook to pull the clip off....it's in behind the handle.

hiunday excel 3 doors engine 1500cc