0
Kia
Kia Motors is the second biggest automobile manufacturer in South Korea, selling more than 1.6 million units in 2009. It was established in 1944, making it the oldest car company in the country.
869 Questions
What type of brake pads does 2013 KIA Optima have?
The 2013 KIA Optima typically uses semi-metallic brake pads, which provide good performance and durability. However, some models may also be equipped with ceramic brake pads, which offer quieter operation and less dust. It's important to check the specific trim and brake system of your vehicle for the exact type. Always consult the owner's manual or a professional for the best recommendation.
Where is the horn located for 2015 kia sorento?
In the 2015 Kia Sorento, the horn is located behind the front grille, near the front bumper. To access it, you typically need to remove the grille or the front fascia, depending on the specific model and configuration. It's advisable to consult the vehicle's service manual for detailed instructions if you need to replace or repair the horn.
aap bilashuba apne baal or nakhun kaat sakte hain. agar aisi koi pabandi hoti to wo log kya krte Jo apne qurbani ke janwaron ko qurbani ki umr se pehle hi khreed kr palte hain .
Mostly South Korea;
Here are the locations of there plants:
Hwasung Plant, Kooni, South Korea
Sohari Plant, Nearest to Anyang, South Korea
Kwang-Ju Plant, Gwangju, South Korea
Seosan Plant, Seosan, South Korea
Slovakian Plant, Žilina, Slovakia
New Plant being built in West Point, GA USA (opening January 2009)
What is Kia Motors' email address?
On KIA Sportage 2000cc Diesel, what is th Diesel Particulate Fillter( DPF ), and where is it located?
Where can you purchase a used KIA keyless entry remote?
A used keyless entry remote for a Kia might be available at a scrap yard. Cars that are crushed have extra parts that a scrap yard is going to save to sell.
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
What happen if you remove the thermostat?
your car will over heat and you might blow your head gasket
How do you remove 99 kia carnival alternator?
you have to pass it through the wiper motor loosen all the bolts of the wiper motor remove it slowly from the base then loosen the 2 bolts of the alternator one below and the other upper left then pull all the hoses and there slide it up to the wiper motor. if you have problem with the belt you have to locate where the tensioner is where you can push or slide it up with a wrench. same thing you have to do to put it back double check the belt if they are properly attached. have fun
You can take it to a local mechanic or car shop and they should be able to get it out for you. I wouldn't try and do it yourself.
How do you get a stuck CD out of a car stereo?
oh that has happend to me just take it to the place you got it and they will fiix it im not sure how much it will be
pH that's happend to me just take it to the car place that u got it from and tey will fix it
Does Water leak from under dashboard?
Yes, water can leak from under your dash. There are seams on the outside sides of the wall. You would have to remove some body panels to get to the seams.
This is what happened with my Honda civic. here are some instructions
Answers.com From Seam Under Corner of Dash
(Supersedes 92-050, dated May 15, 1995)
SYMPTOM
A water leak into the footwell from under the left or right corner of the dash.
PROBABLE CAUSE
Not enough sealer on the cowl side of the panel-to-bulkhead seam.
CORRECTIVE ACTION
Apply sealer to the seams where the side panel joins the bulkhead. Refer to section 20 of the appropriate Service Manual for removal and reinstallation of body components.
1. Look for a leak from the lower comers of the dashboard while an assistant runs water over the windshield and cowl. Confirm which side is leaking.
2. Remove the Answers.com arms and the cowl cover.
3. Remove the side sill, the inner fender, and the front fender from the side that is leaking.
4. Insert a scraping tool through the access holes, and remove all loose sealer. For better visibility, shine a flashlight through the holes.
5. Before you reseal the seams, clean them with a wax and grease remover such as Prepsol.
6. Apply a generous amount of 3M Ultra Pro Seam Sealer (see REQUIRED MATERIALS) to the seams on the inner panel. Make sure you seal all of the seams.
NOTE : You may need to fasten a length of rubber tubing to the sealer spout when applying sealer to the upper parts of the seams.
7. Inspect the area at the bottom of the A pillar and around the hood hinge. Seal any gaps that you find in the sealer.
8. Driver's side only: Inspect the grommet around the hood release cable, and seal it if needed.
9. Retest the area for leaks.
10. Reinstall all removed parts.
REQUIRED MATERIALS
3M Ultra Pro Seam Sealer (order from 3M dealer):
P/N 051135-08302 (5 oz tube)
P/N 051135-08380 (310 ml foil pack, requires P/N 08398 flexible applicator gun)
Where is the knock sensor located on a 2000 kia?
The knock sensor is on the right side of the motor on the block .It runs under the manafold.I can not get the retaining clip off.MIKE
Where are the glow plugs on Kia carens?
the glow plugs are situated on the rear of the engine above exhaust manifold at a 60% angle took some time to find mine but they are there
How do you deactivate permanently the flashing hazard lights when door is open on a KIA Picanto?
There is no way.
How do you remove the backseat of 2001 KIA Sophia?
on the front of the bottom cushin there are two buttons
Where is the spark plug location for a 2001 Kia sprtage?
AFAIK kia Sportage doesn't have any sparkplug at all since its a diesel. probably your asking for the glow plug which also heats the engine prior to starting the engine.
