Machinery and Tools

one-half inch socket

People that work on a metal lathe are called a Turner, a Machinist or a Lathe operator depending on their trade or qualifications.

You would need a metal working lathe, the correct steel for the frame, cylinder and barrel, steel of a different type for the springs, hammer and firing pin. A good set of plans would help, along with the ability to use machine tools. You would need to build a rifling cutter to rifle the barrel after you bored the barrel. Should not cost you more than $3-5,000 to build one from scratch.

An electric vibration engraver is the only one that works satisfactorily.

if delivery of centrifugal pump is stopped and and pump is running then suction will be stopped and no flow will take place there fore fluid in side the pump will be heated up and motor will be overloaded and finally will be short circuited.

Contact the manufacturer of the chop-saw by phone, snail-mail or e-mail. I'm sure someone will help you.If it's made in China, just buy another one.

It is liquid glass and copper filaments (for reinforcement). I used it in my 1998 Nissan sentra that had a blown head gasket and after 25k mi it still runs like a champ.

Be sure to flush radiator and change oil before using. Flush coolant really well.

deposition rate

how do you specify a milling machine

The applications of microprocessors are identical to those of any other programmable electronic digital computers, except due to its significantly smaller size and reduced cost compared to the other programmable electronic digital computers that preceded it these applications can now be computerized too in many places and systems where it was not practical to computerize them before the development of microprocessors.

An Engineering workshop can be found in most industrial areas of most towns and cities. Refer to Engineering\General in your local Yellow Pages.

A typical brass screw is a threaded rod with a head. It is not a slot at all.

It is possible to engrave with some types of CNCs like a CNC machine center or CNC milling machine but the cost of the operation would not justify it. CNC engraving machines are available for this purpose.

Yes. Another name for the Universal Dividing Head is the Universal Indexing Head.

only if you are looking to damage your eyes and get wicked sunburn to the rest of your face

Turn down ratio is the maximum to minimum heat output.Turn down ratio for direct gas fired burners is 25:1, which means that the burner can modulate from 4% to 100% of full fire. Indirect gas turn down ratio is typically 2:1, which limits the heat output from 50% to 100% of full fire.

Mukesh Yadav

A Backgouge consists of preparation of the second side of full penetration welds to the extent necessary to permit the proper deposition of weld metal.

So they can laso something if they see a animal running around

4.43 to 5.90 ft-lb. Please see the link.

it is trouble free and can work long hours, the only problem is the weight

6010 is a high cellulose sodium based electrode, which can be used to weld carbon steel pipes.

A small bench drill press often costs less than $90. The larger floor models with a thicker column and wider throat are about 400.

yes