Mazda 929

You do not remoye the lens from the front of the car. head lamp bulbs are removed from the back of the assembly from inside the engine compartment. Note that your car has separate high beam and low beam bulbs. the ones toward the outside are low beam. Tip;do not handle the replacement lamp by touching the glass bulb ,only touch the plastic plug.you can damage the surface or connection.

BECAUSE ITS DOING ITS JOB!!!!!!!!!!!!!.whats your next question. why does my Mazda have doors?

I did the same thing the other day, Behind the radio on the drivers side you will see two bolts, one really cose and the other on the other side. If you get them loose and get them off the radio will come out with just a push from the back.

The 2014 Mazda3 i SV sedan has a curb weight of 2,799 pounds. The curb weight of the 2014 Mazda3 i Sport 4-door hatchback is 2,815 pounds.

the engine oil dipstick is right in front of the motor between the motor and radiator, if factory it will have a bright yellow handle that is completely impossible to miss

Remove the two 12mm bolts with a socket and extension. Loosen the upper radiator hose from the thermostat housing. Pull out the housing, remove the old thermostat, and put in the new one. Be sure to get the steel gasket in the same way it came off. Replace the two bolts, tighten the hose and add water and antifreeze.

put ignition key into driver's door to unlock postion.

the s is a higher horse engine by about 30 horse I believe

you must remove the cd and tape deck starting with the plastic pop off round things at bottom rear of arm rest then work your way up under the seat warmer buttons are 2 more screws to undo . then you pry the black square from around the cd and tape deck the face plates will pop off they can be put on after . then undo all the hidden screws and take out the cd player and leather thing around it. on the top of the cd player under a cover is a 5 amp fuse it is blown re-solder a new one and re assemble, it will then work just did this to my 929 make sure the metal prongs from the face plate dont bend while re assembling with a proper tool the cdtapedeck will just slide out but good luck if you dont have on the unit clicks in . make sure to reassemble all parts in order because once the cd player clicks back in ,it aint commin back out unless you start all over.

And before you do this you need a 4 digit code for your radio and cd player. if you unplug them mite as well get a new one. Cuz if you don't know the code, and you try putting 3 differnt ones in then the cd player and radio will completely shut its self down. Its a security feature. So i hope you know your 4 digit code.

To adjust the idle on Mazda 929 from 1992-1995.......on the top side off throttle body

there is a idle air screw,turn screw cloclwise to reduce RPM.

Question...is idle always high when hot or cold?

it is on the rear driver side of the car just above the rear driverside cv-joint. Just jack the back of the car up and you'll see it, it's a black cylinder

The PCV valve is located on the passenger side valve cover, towards the front of the car, which should have a small rubber hose coming off of it.

I have a 1993 929. My husband just changed the transmission fluid in it. He said you have to completely drop the transmission and make sure the you replace the filter also. Then put the transmission back up and fill it with fluid. Mine took app. 6 quarts. ,Jennifer

Actually you do not have to remove the transmission, their should be a drain plug on the side of the transmission pan, if not you can loosen the transmission pan, which should have between 8 to 12 bolts on, you can change your tranny fluid, and filter from there and replace a new gasket. No need in dropping your transmission. Your getting into more head ache than you need. I Jennifer.

the front side of engine bay near the battery drivers side

open your trunk and it is located below your speakers there is a silver access panel. Disconnect your battery. open your fuel cap to release preasure. Remove the access panel. disconnect the fuel and return lines. disconnect the power connector and ground. remove the small screws (about 8 or 9). lift up and out. you will see the pump and the rest is EZ to figure out Hope that helps.

Underneath each side of the exhaust manifolds.

take out break peadle, put in reverse and acclerate down busy road, cruise control will take action at some point ( it works i tried it)

Over driver's side rear tire.

It's located on the right under side of the engine and easy to get to.

On most cars the thermostat is on the top hose, but not this one. Find the bottom large hose and trace it up, there you will find three bolts to remove the lower cup that holds the thermostat. Be carfull because the uperhose has water in it, and your working right below it.

It is behind the seat< in the trunk up under a metal plate on the driver side.

The Exhaust Gas Recirculation valve (EGR) is located on the rear of the intake manifoldup against the firewall and below the Dynamic Chamber. It is virtually impossible to access without removal of the dynamic chamber.

It's where the lower hose meets the engine!! follow the upper radiator hose to the engine, and it is under a dome where the two meet.

if it is auto look under the car, right at the back of the trans on the drivers side. its a little box looking thing it the side of the trans.

what letter or letters are in front of serial number

Call salvage yards in your area and ask if they have a locating service. A yard with a locating service will find one for you. I hope this helps you. Mark