0
Mercury Villager
The Villager was a minivan manufactured by Ford Motor Company from 1993 to 2002, and was a rebadged version of the Nissan Quest. Designed by Moray Callum, the Villager featured a five-speed automatic transmission and a front engine, front-wheel drive layout.
1,605 Questions
Why does the parking brake light go on when turning in 1994 mercury villager?
You may be low on brake fluid. If you are low on brake fluid you may be ready for some brake work or you have a leak somewhere in the system, have it checked soon!
How much antifreeze does it take to fill radiator in 1993 mercury villager?
The radiator itself probably holds a half gallon. The car as a whole would hold about 2 gallons.
Where is a crank sensor located on a 1999 villager?
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
How do you replace the shift indicator bulb on a 98 Mercury Villager?
The instrument cluster must be removed to replace the light bulbs on it.
What is the cost of a brake line replacement to a 1999 mercury villager?
That kind of question is hard to answer without knowing more about where the exact problem is. If it is one of the flex lines they are easy to replace and not expensive. If it is a hard line that runs all the way under the car it could mean several hours of work, and could be fairly expensive.
What would be the reason for the heat to not blow on a 97 mercury villager?
Low coolant? Bad thermostat? Heater core restricted, plugged or airbound? Temperature control not working? Water pump not circulating coolant?
Does the1999 mercury villager 3.3L HAVE a timing belt?
Yes , the Gates website ( they make timing belts etcetera ) has a timing BELT
listed for the 3.3 litre V6 engine in a 1999 Mercury Villager
Where is the factory amp in a 94 Mercury Villager?
hidden back drivers side storage compartment, passengerside should have your Jack etc.
Where is the top speed sensor on a 91 lumina v6?
Never heard of a top speed sensor. Vehicles are usually governed by the computer. The only way to remove the governor is to have the computer reprogrammed.
What are the causes of distributor signal interrupt in a 1999 Mercury Villager?
this happened to me on the 3.3 v6 all of a sudden it was the photo sensing module that has a thin film inside heat is a enemy had to replace whole dist.$500 just for a $50 part
Can you test to see if coil is bad on 2000 mercury villager?
If there is no spark either the coil or ignition module has probably failed. These components are part of the distributor assembly and are not sold separately.
Why would cigarrete lighter let out sparks and blow a fuse on 1997 mercury villager?
If it does it when you push the lighter in, you probably have a shorted lighter. If it blows the fuse as soon as you install it, probably a short in the wire.
Where do you locate the low side ac port on a 2001 mercury villager?
Find your AC compressor. You'll see two lines - one will be larger, and one will be smaller. The larger one is the low pressure line going into the compressor inlet. You just trace that line back until you find the schrader valve (if your AC is a fixed orifice tube system, it's likely to be on the accumulator).
How do you replace a CV shaft 96 merucy villager?
Because of the complexity of this kind of job, it is strongly suggested that you buy a repair manual that explains it in detail. You need to loosen the axle nut with the car on the ground, raise the car, remove the wheel, unbolt the lower ball joint, tie rod end stud, strut lower through bolts, remove the brake caliper, then you can tap the CV shaft stud back and pull the spindle assembly free of the CV shaft. The driver side CV shaft can then be popped out of the transmission. The passenger side CV shaft has a carrier bearing with three bolts holding the shaft to the bearing. Do not try to take the bracket off the engine, it is not necessary. Installation is the reverse of removal.
How do you remove the back hatch of a 1994 Mercury Villager?
A 1994 Mercury Villager, also known as a Dodge Caravan, can have its rear hatch removed by detaching the pistons which hold it to the body of the van. The pistons will be held by screws and removing them will allow the hatch to easily come off.
it could be a vacuum leak,low fuel pressure,faulty throttle positioning sensor(tps),weak ignition, or a cloged air filter
How do you replace a timing belt for a 99 mercury villager?
You will need to buy a manual, since this is a complex procedure that would take many pages to explain. Removing the crank pulley will require special tools that the average mechanic may not have.
Where is knock sensor location on 2000 gmc Yukon 5.3 liter engine?
From the videos on YouTube. They are under the intake.
Where is the thermostat on a 1997 villager?
Follow the upper radiator hose to the engine. That is the thermostat housing. You may have to remove the upper drive belt cover to gain access.
When do you change the timing belt on a 2002 villager?
Recommended is 106,000 miles. My 2001 presently has 114,000 miles.
Where can you get a free vacuum-hose diagram for a 1993 Mercury Villager?
In my area (grand rapids mi.) we have access to "Chilton's" through our public library online. Just need a library card. Check your local library's website and see if they offer it to you as well.
How do you find the PCV valve on 1998 Mercury Villager with a 3.0 V-6 engine?
It is located on the back side of the upper intake plenum under the cowl.
98 Mercury Villager check engine light?
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
Where is the middle oxygen sensor on a 1997 Mercury Villager?
I wasn't aware that there was a middle oxygen sensor. I have a 1997 Villager that was vandalized and the catalytic converter and O2 sensors were stolen. From what my mechanic tells me and Auto Zone there are only 2 sensors, one in front of the catalytic converter and one behind it.
