Nissan Pulsar

The first thing I would do is to take the shift lever cover off to make shure it is not broken. Then crawl under the car to make shure the linkage is not broken where it connects to the shifter under the car. next i would look at the top of the transmission on the driver to check the other end of the linkage. if the linkage moves when you shift gears then the problem is in the transmisssion. At that point push it down a hill into the weeds and buy a new car.

42

There are six numbers on stereo panel 1 2 3 4 5 6. to enter code only need first 4 number buttons. ( 1 2 3 4 normally used to change ch. ) if your code is eg 6745 first press 6 times using nimber 1 button 7 times using number 2 button 4 times for number 3 and 5 times for number 4. that's all. if your pannel says err you have to wait 1 hour yes 1 hour till the pannel display "code"

at the front of the boot x

Standard pulsar n16 alloy wheels are 14x6 with a 45+ offset with 4/114.3 stud pattern

you have to find your belt tenstioner they are all different but they are fairly simple to adjust loosen too remove belt it should only have one

When the dash lights dim on the Nissan Pulsar SS 99 with the use of the turn signal, it is usually an indication of a bulb burned out in the turn signals. It can also mean that the flasher is bad and taking too much juice.

Because each lifter is worn differently on each cam lobe. No lifter are cam lobe is wore the same. If you don't put the lifters back in the same spot that they were installed in when they were NEW then it will cause the cam lobes and lifters to wear out like FAST.

If you are installing new lifters on an old camshaft then it does not matter were they go. THEY MUST GO BACK IN THE SAME PLACE.

The 1998 Nissan Pulsar S-RV typically has a fuel tank capacity of approximately 50 liters (about 13.2 gallons). This size allows for a decent driving range, suitable for both city and highway driving. Always refer to the owner's manual for the most accurate specifications.

To adjust the handbrake on a 1998 Nissan Pulsar, first, ensure the vehicle is on a level surface and securely raised with jack stands. Remove the center console trim to access the handbrake mechanism. Locate the adjustment nut on the handbrake lever; turning it clockwise increases the tension. After adjusting, test the handbrake to ensure it holds the vehicle securely when engaged. Always consult the vehicle’s service manual for specific instructions and safety precautions.

To change the reverse idler bearing on a 1988 Nissan Pulsar NX, first, ensure the vehicle is safely raised and supported. Remove the transmission by disconnecting the necessary components, including the driveshaft, shifter linkage, and electrical connections. Once the transmission is out, disassemble it to access the reverse idler bearing, which may require removing the retaining clips and gears. Replace the old bearing with a new one, reassemble the transmission, and reinstall it in the vehicle.

The rear windshield of the Nissan Pulsar CJ1 and the Nissan B14 Sunny are not directly interchangeable, as they have different dimensions and designs that cater to their respective body styles. While both vehicles belong to the Nissan family and may share some design elements, the specific curvature and mounting points of the windshields differ. It's always best to consult a parts catalog or a professional for accurate compatibility information.

The Nissan Pulsar CD player is typically manufactured by Nissan itself, as part of the vehicle's audio system. However, specific components, such as the CD player, may also be sourced from third-party suppliers or manufacturers that specialize in automotive audio equipment. The exact maker can vary based on the model year and market.