0
Nissan Quest
The Nissan Quest is a minivan produced by Nissan since 1993. It was a successor to the Nissan Axxess and Nissan Vanette. The fourth-generation Nissan Quest features a continuously variable transmission and a 3.5L VQ series engine with 260hp.
792 Questions
Is Nissan engines an interference engine?
Most Nissan engines are interference motors, especially you vg(300zx) and your vq(350z&G35).
How do you remove a Nissan Quest rear window wiper?
Simply remove the bolt that holds the assembly on, and you may have to use a little force, but pull it off. It may take a bit of muscle since it's been a while.
What causes a squeaking noise in the front of a 1997 Nissan Van when you first start it up?
Loose belts
How do you change the thermostat on a 1993 Nissan Quest?
Follow the lower hose from rediator to engine. The hose is connected to the thermostat at the engine. Remove the hose,(collect fluid) take out the two bolts, remove the thermostat and clean the old gasket off the engine. Use blue gasket seal and install the new thermostat.
Where is the EGR valve on a 1995 Nissan Quest?
The EGR valve on the Villager/Quest is located at the top-rear drivers ride of the intake plenum. You will see 2 parts that look almost identical. They look almost like 2 little flying saucers. One is the BPT and the other is the EGR valve. A common problem on these vans, is the rubber tube that goes between the two parts. This hose usually cracks and splits or becomes plugged with carbon. This will trip the check engine light and an EGR code will be present. Replace the little rubber hose (its usually in stock at your Ford or Nissan dealer) and you should be good to go. Good Luck!
Where is the windshield washer in Nissan Quest?
open the hood, and its on the far left in the lower corner
How do you tune up a 1998 Nissan Quest?
Replace the spark plugs,spark plug wires, fuel filter, oil, and oil filter. Mr.brown
How many gallons does the gas tank in the 2006 Nissan Quest hold?
The gas tank on the 2006 Nissan Quest holds 20 gal..
Is the 2001 Nissan Quest 3.3L engine an interference engine or non interference?
It is an interference engine according to the Gates website ( they make
timing belts etc. )
How many spark plugs does a Nissan Quest have?
it has 6 ; 3 on the front of he intake manifold, and 3 on top of the intake , by the fire wall, follow the wires from the distribuitor, wich is on your left, passenger side of vehicle.
How do you change the license plate bulbs on a 1999 Nissan Quest van?
Ok, the screws are rubber or plastic and when you go to unscrew they just spin or strip. So get needle nose pliers and pull them straight out ! Replace the bulbs and use screws as plugs and plugs them back in. yea Knowing is half of the battle.
Where is knock sensor of Nissan quest 1998?
its under the intake manifold and yes every nissan i checked always had this as a first code. most people use regular fuel which wll make engine ping a second under load. there is nothing wrong the sensitivity paramerters are set to close in the prom chip. dont waste a dime on this code,try better fuel
How do you siphon gas from a 2000 Nissan Quest?
You do not because there is a check valve in the filler to prevent gas spillage in case of a rollover.
What is the mission statement of Nissan corporation?
Bill Collins Ford in its dealing with customers, suppliers,
and employees, is committed to promoting: absolute
integrity through honesty and fairness, dedication and loyalty,
creativity and innovation, and enrichment of our community
through leadership in participation in civic and charitable endeavors
How do you replace a tire on a 1994 Nissan Quest?
remove the jack. remove the hubcap. loosen the lug nuts. Raise the vehicle. remove the lug nuts. remove the flat tire. replace the tire. tighten the lug nuts. lower vehicle. tighten the lug nuts again. replace the hubcap.
Correct way to install thermostat in a 1997 Nissan Quest?
it took me 3 times to get it right without leaking .there's hardly any room ..the springs on the thermostat go in the housing of the part u unbolted ..i call it goose neck..or housing..prep it ..first put the thermostat in with the little nipple thing at the top that's on the thermostat...put it in the housing..coat the gasket with sealer on the side that goes over the thermostat put it on over the thermostat let it set up for over an hour . i put some sealer on the thermostat also just to hold it in place around the edges that meet the gasket ..cause the two times before that i installed it ...it would always fall off and get dirt and oil on the sealant not good.after it's set up put the sealer on the other side of the gasket that meets the engine block... than carefully turn it to where the port for the holes goes on make sure that's at the top and weasel it under the AC line ..try not to bump it at all.... then install it..hope that helps..P.S don't forget to bleed it after your done to get the air out of the coolant system
How do you replace knock sensor on 2001 Nissan Quest?
On a 2000 Quest it is buried in the V between the front and rear cylinder banks.
I would make sure it is the real problem before replacing. the sensor alone is $175 and the gaskets are $50. I was quoted 5 hours labor, so apply an appropriate labor charge and it is not inexpensive.
In my case, a misfire only when the engine was hot resulted in an error code for the knock sensor. I replaced the sensor and still have the same problem.
I erased the error code for the knock sensor and it has not come back, but a new error code implied the crank position sensor ($30) was bad. I replaced that sensor but the misfire when hot is still there.
now there are no error codes so I have no clues as to the real problem.
If you go to a dealer, I would insist on ;
a. getting a print out of any and all error codes currently stored in the ECM
b. allowing only the work which you have personally approved
c. getting a written guarantee that the work will fix the problem
too many dealers do not do a good job of analyzing the real problem, fix something unrelated and then say, well, it needed replacing anyway.
How many gallons does the gas tank in the 2013 Nissan Quest hold?
The gas tank on the 2013 Nissan Quest holds 20.0 gal..
Is the 3.0 liter engine in a Nissan Quest a non-interference or interference type engine?
According to the history of the Nissan Quest Vg30e engine from 1993 thru 1998 these group of engines were non-interference engine, so if the belt breaks it will not damage the valves. This feature was demanded by FORD from Nissan before FORD agreed to used this engine in their ViLLAGER and Nissan Quest vans in the time of their joint venture.
What is theTorque specs for axle spindle nut for 1994 Nissan Quest?
The torque specs for the 1993-2002 Nissan Quest FWD is 203 Ft-Lbs or 275 Nm.
