0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
Why does the gen light stay illuminated in my 1972 Oldsmobile cutlass supreme?
Your alternator is NOT putting out enough voltage to keep up with the amount being used. This can be casued by: The belt slipping on the alternator pulley The alternator is going bad. I woudl see if the belt is tight and is NOT slipping. If you haven't bought a new belt lately, its a cheap investment. If the belt is tight and the alternator light stays on, take the car to Autozone or Pep Boys and have it checked while on the car. If you have a multimeter you can check it by seeing how many volts are comign out of the alternator by placing the leads on the alternator to see what current is being generated by it. Anythign less than 12 I would buy a new alternator. Most cars need over 12 volts to 14 volts to operate. Most of my cars run 13-13.9 volts. Also, check the voltage regulator which is located on the fire wall below the left windshield wiper. This a cheap part which often fails on that model.
It is not so much how it affects the sensors themselves, but how much it affects the engine management computer (ECM). The sensors will notice the change in the exhaust gasses and the computer will try to compensate for the change. This often results in poor running, reliability issues, and poor gas mileage. There are however, o2 sensor simulators available aftermarket, though I have no experience with them.
Where is the fuel pump relay for a 1989 Oldsmobile Cutlass Ciera?
Underneath your hood, behind the passenger side headlight, behind the core support
Can 5 holed rims from and Oldsmobile cutlass fit a Chevy Corsica?
Most Oldsmobile rims that have the same bolt pattern as the Chevrolet Corsica use a different size rim and tire. The only one that used the same size rim, with the same bolt pattern is the '92 and above Olds Achieva.
Other vehicles you could try though are the '90-'96 & 2000 + Toyota Celica, '89-'91 Plymouth Acclaim, '96 Plymouth Breeze. and '95 and above Pontiac Sunfire, which should all have rims with the same bolt patter and size as your Corsica.
Removal of door trim panel 1992 cutlass driver side door?
http://www.bodyshopzone.com/archives/trim/door_panels/Oldsmobile/Cutlass_93/remove_dp_Cutlass.html
What is the value of old timer schrade-Walden 150 T?
What ever you can get for it. They go on eBay from 57.00 to 125,oo for a perfectly new one.
The swap isn't a direct swap. At the least you'll need to move the frame mounts. These cars came with multiple engine options throughout the years. So a lot of engines will bolt in without too much trouble. For sure the Chevy 350, the Olds 350, and since the Grand Prix came with a 301 Pontiac at one point, the Pontiac 350 should also fit. You'll just need to figure out where to move the frame mounts and get the correct engine mount. Depending on the engine chosen you may need to change transmissions also.
Where is the ignition switch located on a 86 Oldsmobile Cutlass Ciera?
It is on the upper left side of the steering column, low down, near the similar looking low-high beam switch. Both of those are manipulated by rods instead of being in the upper column.
Your 94 cutlass ciera bogs down when accelerated what could this be?
mass air flow sensor clean it with Qd electronic cleaner worked for me had he same problem with a 93 cutlassciera. runs great now
There's a very nice picture in the article in the link below.
What would make a 1988 Oldsmobile cutlass ciera start and then die right away?
What would make a 1899 oldsmobile cutlass ciera start and then die right away?
What order does the distributor caps have to be in a 93 Oldsmobile cutlass sierra?
What do you mean by what order. Go here pick the proper engine and you will get your answer. http://autorepair.about.com/library/firing_orders/bl-oldsmobile-firing-93.htm
What is the gas mileage for an Oldsmobile 1992 Cutlass Cierra?
Expect 26 city, 34 highway in realworld. EPA estimates and different driving styles may cause variation.
What is the firing order for a 79 Oldsmobile cutlass 3.8L V6 and what side is odd- even?
The firing order is 1-6-5-4-3-2 Rotor turns clockwise. Cylinders are numbered on the driver side front to rear 1-3-5 and on the passenger side front to rear 2-4-6.
Is the Hood on a 68 cutlass the same as a 442 hood or w-30 hood?
All 1968 Cutlass two doors had Chrome Louvers on the hood. All others did not. The Hurst/Olds had painted louvers.
http://www.who-sells-it.com/cy/brothers-automotive-products-4264/oldsmobile-cutlass-442-parts-fall-2009-20699/page-22.html has the part if you need it.
What is the firing order of a 1985 Oldsmobile cutlass v8?
Almost all v8 engines have the a firing order of 1;8;4;3;6;5;7;2. the rotor rotates counterclockwise. so, as long as you follow the firing order...it doesn't mater where you point the rotor!
Turn signal is not shutting off after turn 95 cutlass ciera?
You need a new turn signal cam. It's inside your steering column, requiring you to remove your steering wheel (that requires a special $15 tool). I'd just live with it.
hold out on handle another person tap on frt. of the hood
How many PSI should the fuel pressure be in a 1992 Oldsmobile Cutlass Ciera with a 3.3L?
The Pressure Has To Be Arround 30 to 40 psi
Where do you add freon on a 1998 Oldsmobile cutlass supreme?
Low pressure line Larger line running from compressor
