0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
check your battery or you spark plugs
If power windows in 1993 Olds Cutlass Ciera don't work what's wrong?
If power windows in a 1993 Olds Cutlass Ciera don't work there may be a loss of electrical current. Check the battery and fuse. The power motor in the door may need replace.
What is the horsepower of a 1984 cutlass salon?
I own an 84 cutlass myself. It's all original with a powerfulk 5.0l I recently took it to intell dyno and it pumped out a whopping 132 horsepower and 146 pounds of torque.
The 0-60 times are around 9 seconds and it runs the quarter mile in about 18 seconds.
I just found out how much they suck. I'm pissed off because i recently raced a Honda preice and it blew my doors off. I bought it for around 3500 and found out it only retails around 800 dollars.
If you really want power don't go with Oldsmobile... it's exactly how it sounds, OLD.
Oldsmobile are not fast and can never be fast even with the 442.
Why wouldn't you have brakes on a 1990 cutlass supreme?
Loss of fluid is the typical reason, Master Cylnder failure is another. Brake failure is very typical in these vehicles...there was a lawsuit against GM in the 90's to reimburse owners.
Where is the brake light switch located on a 1994 ford bronco?
Usually it is located at the top part of the brake pedal unit. This is usually where other Ford products are located. If it isn't there it is possible that it is located on near the master cylinder unit near the vacuum assist canister. Hope this helps.
How do you remove a knock sensor in an Oldsmobile cutlass ciera?
where is the knock sensor located on 93 cutlass ciera
Will the hood from a 1967 Oldsmobile Cutlass fit on a 1966 Cutlass?
They wouldn't match up in the front due to the 67's wider headlight design
What is the fuel pressure for a 1994 3.1L GM 3100 6 cylinder engine in a cutlass ciera s?
The 1994 GM A Body vehicles with the 3.1 requires 41 to 47 psi for fuel pressure.
How do you set ignition timing in 455 olds?
Buy a timing light at any auto parts store.
Hook it up as the instructions show (the number 1 cylinder is the front one on the drivers side).
Loosen the distributor hold down enough to be able to turn the distributor by hand (but no too loose!)
Disconnect and plug the vacuum advance line.
Start the engine and let it warm up.
Point the timing light at the timing indicator on the front of the engine, and pull the trigger.
Observe where the mark on the harmonic balancer is in relation to the numbers on the timing indicator. Sometimes it helps to put a little dab of white paint on the mark on the harmonic balancer, so you can see it easier.
If the mark does not line up with the correct timing number, slowly turn the distributor one way or the other, until the mark lines up with the correct number.
Tighten the distributor hold down, and double check the timing.
Turn off the engine, disconnect your timing light, and re-connect your vacuum advance.
If your distributor has points in it, you may also have to set the dwell for best performance.
94 GMC Cutlass Supreme charging system not working?
replace the alternator if your system isn't charging.
possible ignition modual, what is your fuel presure, does car restart immediatly or after it sits for a while Possibly clogged fuel filter, or bad fuel pump.
How do you change a drive belt on a 1997 Oldsmobile cutlass?
Insert a 3/8 breaker bar or wrench into the notch on the tensioner and pull upwards (towards back of the car). Then you can change the belt.
How to fix spongy brakes on 1996 cutlass cierra?
Could be a few causes of that symptom, but most likely air in the brake lines or moisture in the brake fluid. Start by replacing the brake fluid in the reservoir and bleeding the brakes.
How much horsepower does a stock 1971 cutlass have?
mine had a 2 barrel carb and had 125 hp with the 350
Where is the crankshaft sensor located on a 1990 Oldsmobile cutlass ciera 2.5 l?
if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...
Where is the transmission filter on a 1990 Oldsmobile Cutlass?
Inside the transmission attached to the valve body, under the trans pan, which must be removed to gain access.
Will 20 inch rims fit on a 1981 cutlass without raising the car?
Yes they will work as long as you run 245-35 series tires.
Why would your 1984 cutlass not idle and die at stop signs and sputter while driving?
bad oxygen sensor bad map sensor
Why is the cutlass stalling when idling but rides fine when you hit the gas?
Is it carburated? If so I'd check that out, might need to be retuned or something.
How do you replace the water pump on a 1993 Oldsmobile Cutlass?
water pump has some (2) pins into the block...it needs to be pryed stright off.
