0
Oldsmobile Ninety-Eight
The Oldsmobile Ninety-Eight (98) was a full-size automobile manufactured by General Motors from 1941 to 1996. This model featured the highest-grade exterior and interior trim, as well as the Twilight Sentinel.
412 Questions
How do you change coil pack 1988 olds 98 regency?
To change the coil pack on a 1988 Oldsmobile 98 Regency, first ensure the engine is off and cool. Disconnect the negative battery cable and remove any components obstructing access to the coil pack, such as the air intake or engine cover. Unplug the electrical connector from the coil pack, then remove the mounting bolts and take out the old coil pack. Install the new coil pack by reversing these steps, ensuring all connections are secure before reconnecting the battery.
How do you remove and replace the radio in a 1992 Oldsmobile 98 Regency?
To remove and replace the radio in a 1992 Oldsmobile 98 Regency, start by disconnecting the negative battery terminal to ensure safety. Carefully remove the dash trim surrounding the radio using a trim tool or flathead screwdriver to avoid damage. Unscrew the radio mounting screws and gently pull the radio out, disconnecting the wiring harness and antenna. To install the new radio, reverse the process by connecting the wiring, securing the radio with screws, and reattaching the dash trim.
Where is the door lock relay on 1994 Oldsmobile ninety eight?
On a 1994 Oldsmobile Ninety-Eight, the door lock relay is typically located in the fuse box, which can be found under the dashboard on the driver's side or in the engine compartment. You may need to consult the owner's manual for the exact position of the relay and its identification. It's advisable to check for any labeling on the fuse box cover for guidance on the specific relay for the door locks.
How much is the Weight of a 1992 Oldsmobile?
The weight of a 1992 Oldsmobile varies depending on the specific model, but it typically ranges from about 3,000 to 3,500 pounds. For example, the Oldsmobile Cutlass Supreme has a curb weight of approximately 3,200 pounds. Always refer to the owner's manual or manufacturer specifications for precise information on a specific model.
Where is the flasher fuse in a 89 Oldsmobile 98?
In a 1989 Oldsmobile 98, the flasher fuse is located in the fuse box, which is typically found under the dashboard on the driver's side. To access it, you may need to remove a cover panel. The specific fuse for the turn signal and hazard flashers is usually labeled in the fuse box diagram; consult the owner's manual for the exact location and amperage. Always ensure the vehicle is off before checking or replacing fuses.
Where is 96 Oldsmobile 98 fuel pump shut off switch location?
The fuel pump shut-off switch on a 1996 Oldsmobile 98 is typically located in the trunk, near the fuel tank. It can often be found on the driver's side, behind a panel or under the carpet. If you have trouble locating it, consulting the vehicle's service manual may provide more specific guidance.
Where is a guide for the maxi-fuse relay center on a 1995 98 Oldsmobile?
The maxi-fuse relay center for a 1995 Oldsmobile 98 is typically located in the engine compartment, near the battery. It is housed in a black plastic box that contains several fuses and relays. To access it, you can remove the cover by unlatching the clips. For specific fuse diagrams and relay functions, refer to the vehicle's owner’s manual.
1995 olds 98 upper intake manifold torque sequence?
Well, honey, the torque sequence for the upper intake manifold on a 1995 Oldsmobile 98 is a piece of cake. You start in the middle and work your way out in a criss-cross pattern, tightening those bolts to about 89 inch-pounds. Just make sure you're using a reliable torque wrench and you'll be good to go, darling.
Why does a 1992 Olds Ninety-eight stall after it has been driven awhile?
have your oxygen sensor checked or replaced. we had the same issue on ours and replacing the o2 sensor fixed the problem
Where is o2 sensor in 1996 ols ninety eight?
on back side of engine by tranny by bottem of trans axel on exuste on top
How do you put a 1995 Oldsmobile 98 3800 series 2 in time?
The timing is controlled by the onboard computer and cannot be adjusted without modifeing the computers programming. If you are certain that it is your timing that's the problem put your attention towards a possible stretched timing chain or a faulty crankshaft sensor.
How do you replace the voltage regulator in an 98 Olds regency 1986 model?
It's inside the alternator. If you haven't already done one (and evidently you haven't) it would probably be best for you to just replace the whole thing. Some special tools are required and it can get a little overwhelming for the first timer.
Where is the blower motor relay located on Oldsmobile 98 1991?
on the right side of the engine firewall on a relay brackt.
which one?
Driver side blowing hot air and passanger side blowing cold air on a 95 0lds nine eight?
its your blend door actuator behind the glove box most likely Mine did the same until i replaced it
Where is the flap that opens and closes to receive heat and air located on a 1988 Oldmobile 98?
the flap is located at the top of the plane
What fusible link would stop 1996 98 Oldsmobile from starting?
there is a fusible link on the starter solenoid somewhere
What is the belt diagram for a 1985 Oldsmobile Ninety-Eight?
belt # 15436 which is a small belt goes to the alternator & fan pulley ,belt # 15445 which is a small belt also goes to the center pulley behind the fan pulley then the power steering pump and on the bottom outside crank pulley below the fan-water pump pulley.the final belt # 15585 which is a larger belt goes to the air condition compressor fan pulley far inside groove t,crank pulley far inside groove toward engine block and then emission pump. I bought one belt @ AutoZone and the 2 small ones were made by Goodyear,But as long as the numbers & belt size match you should be able to get them anywhere. I hope this helps as I had to track down another Delta 88 Royale as none of the parts stores were of much help either.
Why does Oil pressure sender keeps coming on?
I've got a 92 98 road touring and it did this and all it was, was the sending unit. It is got an end cap on it and it was broken
Where is the 02 sensor on a 1992 98 Oldsmobile and how easy is it to replace?
It mounts in the rear manifold at back of motor just after the 3 cylinders piping converges into the single outlet - there will be a silver cover on it and a wire (usually black that comes to a connector about 6 " away. You can use a wrench (about 1" size) or a specific tool to remove it. Do this with engine cold or the threads will risk being damaged. The new sensor comes with special beaded lubricant for thethreads on the O2 sensor. Be sure to use it BUT be careful not to get any on the sensor itself. The job can be bit aggravating but not too terribly difficult.
Where is the horn relay located on a 1989 Oldsmobile Ninety-Eight?
under kick panel on passenger side
Where is power train control module located on olds 98?
Power train or ECM? Most have been behind the passenger side kick board between door and firewall. you may have to remove cover beloe glove box first.
