0
Plymouth Voyager
The Plymouth Voyager is a nameplate used in two different vans produced by Chrysler Corporation (later DaimlerChrysler AG) from 1974 to 2000. The name was also used in Plymouth’s minivan in 1984.
1,288 Questions
Where is the power window switch on the driver's side of a 2001 Plymouth Voyager minivan?
the switch is on the door panel approx four inches from the window, this is the only switch that sends power to the window regulator motor (window motor).
How do you reset service engine soon light on 96 voyager?
You repair the cause of the code, then reset the code with a scan tool or by unhooking the battery.
How do you put a serpentine belt on a 1994 Plymouth Grand Voyager?
there should be an automatic tentioner on the serp. if not look at the alt it will have slotted holes to loosen up
Power window fuse for a Plymouth Voyager 1993?
LOOK AT YOUR MANUAL AND YOU WILL SEE THERE IS NO FUSE. LET ME GUESS BOTH FRONT WINDOWS INOP?
What do engine codes 12 35 and 32 mean in a 1994 Plymouth grand voyager?
12 Battery or computer recently disconnected 32 EGR gases not working 35 Cooling fan relay circuit open or shorted
How do you change headlight in 1994 Plymouth Voyager?
To change out the HEADLIGHT ENCLOSURE (the plastic lens & reflector unit that the headlight bulb installs into from the back): (This sounds like a long process but it only takes about 5-10 minutes. REQUIRES A TORX driver.) (To change JUST THE BULB go all the way to the bottom.) * Open the hood and remove the two Phillips head screws securing the chrome & black trim piece directly above the headlight. Then pull the side of the trim piece forward (off of the plastic peg along the side of the car facing forward), and then pull the piece sideways out of the tab in the grille. * Next remove the single countersunk screw on the SIDE of the parking light assembly. This will be facing outward on the side of the car along the black strip in between the amber colored side marker (below) and the clear side lens (above). * Next remove the TORX-head screw in the grille that is JUST INBOARD of the parking light assembly. (There are 4 total screws holding in the grille - you need to only remove the LOWER screw on the side of the car of the headlight you're replacing.) * Next remove the long "post-like" screw that sticks up just under the very front corner of the hood. It takes a TORX driver and unscrews upward, then pulls out about 4-5 inches. Set this aside. * Next carefully slide the entire parking light / side-light assembly out sideways (toward the side of the car). Leave the wiring attached and just let it gently hang below the headlight. * Next locate the three plastic retainers that hold the headlight assembly into the alignment fixture. These are black plastic and can be seen looking toward the front of the headlight straight back. There is ONE ON TOP and TWO BELOW the headlight. Use a pair of pliers or needle-nose pliers (much preferred) to ROTATE THESE PLASTIC TABS 90 DEGREES CLOCKWISE so the BUMPS ARE UP AND DOWN vertically instead of side-to-side on each of these tabs. Then pull the headlight assembly forward; it will snap free. * Finally disconnect the headlight wiring connector on the back (if not already done). * Reinstall in reverse order but rotate the headlight retaining tabs 90 DEGREES CLOCKWISE again after snapping the new headlight assembly onto the posts/tabs. * Reinstall all other parts in reverse order. TO CHANGE JUST THE BULB: Open the hood, locate the back of the headlight assy. Remove the electrical connector (lift the clip and pull backward on the plug). Unscrew the bulb retaining collar with your hand (turns only part of a turn), then remove the collar and set aside. Grasp the bulb connector and pull out backwards. Reverse all steps to install the new bulb.
Leaking rear main seal on a 2000 voyager?
The rear main is on the end of the crank shaft. The transmission and flywheel have to be removed to service.
Where is the water pump located on a 1999 Dodge Caravan 3.0 V6?
The pump bolts directly to the engine block, directly behind the timing belt assembly. Therefore, if you have a need to replace the timing belt, it's probably a good idea to consider changing the water pump as well (and visa-versa).
What is the screeching noise coming from the front tires on a pymouth voyager?
most probably the early warning sensors on the front brake pads, letting you know it"s time to change your front brake pads.
Where is the body control module on a 1993 Plymouth Voyager LE?
located under the right side of the steering column under dash
Where would transmission fluid leak in 1997 Plymouth Voyager?
the grand voyager 96-99 has a fair amount of places it can leak from. The main place I have had trouble with is the external CV axel housing. That's the cone like shape that the cv axel goes into on the passenger side of the transmission. the other places are the differential cover gasket, transmission pan gasket, and the side pan gasket. A common place I have not had leak is in the front there is a box (don't know the name) I havn't had leak on me yet, thankfully. A common reason for the CV axel seals to leak is the motor mounts being bad. I puts stress on the axels creating preassure on the seals in all the wrong ways, if you replace the cvaxel seals... it could be due to bad motor and transmission mount issues.
It lets the computer know where the crank shaft is at all times, and yes it can cause a no start.
Where is the thermostat located and how do you replace it on a 1999 Plymouth Voyager?
Need to know which engine you have.
What function is performed by a BT Voyager 1055?
The BT Voyager 1055 is a USB stick used for computer storage. The USB stick can be purchased from various websites and can be purchased from various local hardware stores.
Where is the belt tensioner for 93 Plymouth Voyager?
Has anyone ever really been far even as decided to use the belt tensioner on 93 plymouth ranger even go want to do look more like?
How long can a V-6 engine idle on a gallon of gas?
Depends on afew things, if there is any types of fuel savers on the vehicle, if the engine has decent compression, if there is any sludge build up and what not... id say tho probably 30-40min... maybe even longer, my Dodge Spirit with a 2.5 can go probably about an hour or more, idling on a gallon of gas.
Where is the ABS Pump located on a 1997 Plymouth Grand Voyager?
It is just below the Master Cylinder and the Power Booster assembly.
Where is the starter relay on a 1996 Plymouth Voyager?
THE STARTER IS LOCATED A THE FRONT OF THE VEHICLE DUE TO FRONT WHEEL DRIVE. JUST BEHIND THE RADIATOR...
How do bleed Plymouth Voyager brakes?
start with the front left brake then go to the fornt right then rear left then rear right, takes two people. pump the brakes till the pedal feels stiff,thrn hold it loosen the bleed screw then retighten it.continue this step on all four brake cylinders until you get steay fluid(no air) coming out of the bleeder screw
A 5 pin din connector is used on which motherboards?
at motherboards which are not used nowadays, atx motherboard has ps2 connectors which were replaced by usb keyboards
Where is the fuse for the radio in a 2001 Plymouth Voyager?
The fuse will be either located in the fuse box in the car (usually in the driver side left panel, or under the hood), or it is located on the back of the radio itself.
