answersLogoWhite

0

🧩

Shotguns

Ask questions here about shotguns produced by various manufacturers such as Lefever Arms Co, Iver Johnson Arms, and Harrington & Richardson.

10,990 Questions

Where can you get parts for a 12 gauge Rev-O-Noc side by side shotgun?

There are some sources for Crescent shotgun parts, but it is very possible that parts will have to be repaired/made.

What is the age and value of a 12 gauge Ithaca side-by-side shotgun serial 85410?

It's a Lewis or NIG model, built in 1903. Value is from $50.00 for a wallhanger to $1000.00 or more for one in new condition.

Where do you find parts for a AA Arms Tech 9?

AA arms does not make the tec 9, intertec or interdynamic did. AA arms makes the ap9. you can often find parts on gunbroker.com

Can you tell you the approx age of a single barreled 12 gauge hammer gun with the Essex name?

A big hammer mounted on the side? Probably 1890-1915. A smaller hammer in the center of the receiver? 1910-1945.

Where can you find information about the 22 caliber Savage Model 3D single shot?

--------SAVAGE 3 SERIES Rifle Information-------- There were several variations of the Savage model 3 rifle made. The basic version is a single shot bolt action, .22RF chambered rifle. It appears that all variations of the M3 were single shot and that the added model variation such as

What is the price of a miroku serial No 35147pz?

More information is needed. Is this a Browning? What model and what condition?

Where can you find informatioon about the Hanover Arms Company?

Gary,

No other markings? If not marked with the manufacturer's name or trademark it may be impossible to make a positive identification. If you can post pictures on the Gun ID & Value board at www.shotgunworld.com, someone may recognize it from the style. However, lacking such an identifying mark does indicate that it is most likely a utility-grade gun and as such the going price would probably be about $150 assuming it is complete and undamaged but not in like-new condition. And if gggranddad bought it new, we know it is 108 years old. If second hand, it could be 30-35 years older than that. (It is a breech-loading gun? If percussion muzzle loader would be c. 1810 - 1875, flintlock even older.)

Folsom imported most of these Belgian shotguns from about 1893 to WWI. I doubt if any factory documents still exist to determine the exact manufacture date.

Any information on a double 18 inch barrel hammerless knickerbocker?

Your Knickerbocker shotgun was mad by the firm Cresent firearms Co.They were in business between 1880,s up till 1932.This firm made many shotguns under different hardware store names,of which yours is one.These were utility grade shotguns made for the general public and many farm owners of the day.there price was resonable for the working familiy,s of the time.

Stoeger model 2000 semi-auto12 gauge?

Stoeger is a Turkish made semi- auto shotgun. It is based on benelli's inertia system which has proven to be extremely reliable in harsh hunting conditions. As opposed to a gas systems which use gases from the firing of the shotgun to cycle the action, the inertia systm uses the recoil and the actual force from the discharged shell to cycle it. Since there are no gases escaping or being used they are known for being extremely "clean" guns. Meaning they can go long periods without cleaning. Some people feel there is more felt recoil than in a gas gun but trade that off for the reliability. Similar guns are the benelli m2 and franchi I12. Both are considerabley more expensive and made in Italy.

Where can you find information about a 22 S-L-LR Ranger Model 103-13 shotgun?

This is a Marlin model 81 wearing a Sears & Roebuck brand name. Can't locate production dates for this model, but somewhere around 1940.

I have an Over & Under "Ranger 103, 12 guage Shotgun. I haven't been able to find it in any of the books.

I thought that Marlin made it but it wasn't listed as that either.

Do you know anything about it?

Bernie - The 103.13 is a Marlin 81. Made in the 1960's. It is a rifle, not a shotgun. It should be a good 'plinker' or small varmint gun, but has no significant value. Probably around $80-$100 in Very Good condition.

Who made the Western Field model XNH-804?

I believe the company that actually made the model XNH-804 was called Noble.

How do you take the barrel off a Sears Roebuck model 300?

First, unscrew the magazine tube cap, located at the end of the forearm. Then pull the action back to about half-way, then you should be able to pull and jiggle the barrel and forearm free.

To reassemble, slide the barrel and forearm back on, and pull the action back until the barrel slides into place, then rescrew the magazine tube cap.

What kind of information can you give you about sears roebuck and co double barreled shot gun model 1017?

Try www.wisnersinc.com Store Brand houseguns . Iwas chasing down info on a Laurona imported for sears when i found this site .Hope it helps ,papa

What is the value of the Savage Model 1917 32 Calibur Automatic?

i dont know but i am guessing not over 500 dollars because that what all the other models are not over 500$ the reason i kno is because i have the same gun you have in good condition about 400 in great about 600 or 700 depending on which model year it is and if you still have the box add on a few hundred

Who made the Hawthorne Viking 450 shotgun?

The Hawthorne Viking 450 shotgun was manufactured by High Standard Manufacturing Company for the Montgomery Ward department store in the mid-20th century. It was primarily used for hunting and sport shooting.

Where can you find a forearm for a Batavia 12ga shotgun?

The standard recommended parts houses of Numerich gunpartscorp.com

Jack First jackfirstgun.com

Bob's Gun Shop gun-parts.com

may be able to help. I don't recognize that brand.

How do you determine how many zeros are on front of any buckshot size in comparison to it's diameter?

Buckshot comes in many sizes:

SizeTypeWeightDiameter#TriBall(12 Ga.)Buck20.41 g (315 gr.)15.24 mm (0.60")#0000Buck5.51 g (85 gr.)9.40 mm (0.380")#000Buck4.54 g (70 gr.)9.14 mm (0.360")#00Buck3.49 g (53.8 gr.)8.38 mm (0.330")#0Buck3.18 g (49 gr.)8.13 mm (0.320")#1Buck2.62 g (40.5 gr.)7.62 mm (0.300")#2Buck1.91 g (29.4 gr.)6.86 mm (0.270")#3Buck1.52 g (23.4 gr.)6.35 mm (0.250")#4Buck1.34 g (20.7 gr.)6.09 mm (0.240")#FFBuck1.18 g (18.2 gr.)5.84 mm (0.230")#F (TTT)Buck1.05 g (16.2 gr.)5.59 mm (0.220")#TTBuck0.98 g (15.1 gr.)5.33 mm (0.210")#TBuck0.89 g (13.7 gr.)5.08 mm (0.200")#BBB

0.66 g (10.2 gr.)4.82 mm (0.190")#BB

0.57 g (8.8 gr.)4.57 mm (0.180")#B

0.48 g (7.4 gr.)4.32 mm (0.170")

Will a 410 gauge rifled slug kill a whitetail deer and if so what is the maximum range?

http://wiki.answers.com/Q/Will_a_410_guage_rifled_slug_kill_a_whitetail_deer_and_if_so_what_is_the_maximum_range"

Yes a 410 gauge with slug will kill a whitetail deer. In fact if you are under 50 yards or less, this gun is very effective. One problem seen by Division of Wildlife officials is that many hunters, out of the gun season will shoot a deer with this type shotgun, then stick a arrow into the carcass to try to fool everyone. But a trained eye can usually detect this.

Yes, a 410 gauge rifled slug will easily kill a deer. Make sure your marksmanship is great and stay away from the shoulders, or other bones. They loose their energy quick so get to practicing and have fun.

What is the value of a 20 gauge Tristar side by side?

The mfg. suggested retail is around $1350 or even a tad higher, but a gun in "new" condition (read "unfired") would likely have a real world value of $850 to $950. That is what a gun dealer in the Dakota's, for instance, may ask for a brand new Brittany. If one were to advertise in a newspaper classifed section, one might get that much, but folks usually seek some kind of a bargin outside of true retail setting. Therefore, I'd ask $750 for an unfired gun, and go downward from there, depending on the condition of the gun (if it has been used). You may want to consult the Blue Book of Gun Values for the increments of used gun pricing for this model. The gun is a wonderfully durable and verstile model, mfg by one of Spains most solid and prolific manufacturer of double guns, Hermanos Zabala, and is imported by Tristar. Tony Petres Rapid City SD

You own a tradewind model h-150 that was made in Italy where can you find parts?

n Gun shop, gun show, on line auction, estate sale, garage sale, for sale ad, want ad, pawn shop, egunparts