Volvo S80

The 2006 Volvo S80 has a drag coefficient of 0.28 Cd.

Get a new one from "rockautoparts" over the Internet for about $40.00. There's no other way around it. The labor is about 1 1/2 hours.

how do you disarm a car alarm on a volvo s80 2000

This must be done at the dealership. I did not have a spare and lost my only key. Key had to be special ordered. The car towed to the dealership and programmed. $400.00 for new key and keyless remote.

First, make sure to clean off any crud build up around the general area where the valve cover meets the head. Doing this will prevent too much crud from falling into the top of the head when the cover is removed.

Next, you will have to remove the two nuts holding the air filter housing onto the valve cover. There should be two nuts holding this bracket down. Don't loose the two metal caps that sit on top of the rubber washers. Without them the nuts will bear down into the rubber washers which will wear them out quicker.

Remove the (3) nuts holding down the valve cover. Be sure to save the metal bracket that holds the clutch cable, if you still have that bracket.

With a flat-head screwdriver or other flat object, gently pry around the junction of the valve cover and head to free the valve cover. If this is the first replacement of the valve cover gasket the head surface under the gasket should visibly show where the gasket was leaking.

Be sure to use a putty knife to thoroughly clean off any gasket remnants from the surface. You can use a little solvent to try and help free some of the residue but DO NOT allow any of this fluid to mix with the oil or get on any of the rocker assembly.

Now's the hard part, getting the old gasket off of the valve cover. If yours is anything like mine was then it's rock hard and a complete pain in the butt to get off. I had to use a small flat-head screw driver or a phillips-head to kinda chisel out the gasket from the groove it was lying in.

After removing the gasket and thoroughly cleaning the surface down in the groove I removed the rubber washer type seals where the valve cover bolts come through the top of the valve cover. This will most likely need to be replaced too. To save money make sure you buy the gasket with the replacement rubber washer type seals. I can't remember exactly what they're called but you should be able to recognize them when you see them.

Thoroughly clean the inside of the valve cover from any crud and you might as well clean the outside too while you have it off.

Place a small bead of silicon gasket maker into the groove of the valve cover where the gasket will sit. Also place a small bead on the top of the head where the gasket will sit. DO NOT put so much that it will bleed into the rocker assembly and mix with the oil when you tighten down the valve cover.

After you place the new gasket onto the valve cover place the cover back onto the head. Put the new rubber washer type seals in their three holes and put the nuts on finger tight. DO NOT forget to put the clutch cable bracket back on or your ground wire that came off the right side of the cover.

With your 10mm socket tighten down the middle nut first and then your outside nuts. Make sure it is tight and secure.

Put the air filter assembly bracket back on and be sure to put the steel caps on over the rubber washers so that the nuts do not bear down into them. Be sure everything is tightened down and you're done. Congradulations!!!

The rubber washer type seals are termed "grommets". There's a valve cover gasket w/ grommets kit that is sold and is cheaper to purchase than purchasing them seperately.

Your headlight control knob (the round one you twist on the dash board) is set to auto, or manual. I forget which setting won't allow you to "click" on the high beams with the left indicator lever. It only took me 4 years owning one before I figured that out. Its in the owners manual too.

Ray's Answer- - You also have to have your lights turned on on the car so the high lights come on!!!!

Can not find answer for a P0455 code for my 1999 S 70 Volvo (check engine light), with a buddies meter, trying to save money, can anyone give a clue, is it serious or is Volvo Dealer blowing smoke. If you could also provide re-setting technique, it would be highly appreicated.

I'm am afraid to report that you need a new unit - ask your dealer about a refurb unit.

I need change the stop light in my Escape 2001 but I don't know remove the cover plastic

The PCV valve is located in the engine area on the 99 Volvo S80T6. It is important to carefully study the user manual which has an illustration of the same.

Bring your vehicle to an Auto mechanic for an engine diagnostics test to determine which area of your engine has cause the service engine light to appear illuminated.

The results could be as simple as a sensor going out, or component failure which puts you at major risk.

The 2005 Volvo S80 has a 5-speed automatic.

Mercedes vito Service Reminder Reset

They are located on the top of the engine opposite side of the engine belts and at the end of the double overhead cam. The are located inside black plastic housings, just look for the electrical leads going to them.

They rarely fail, if you are getting cam position sensor codes, make sure the timing belt hasn't slipped.

The 2003 Volvo S80 runs on premium unleaded (required).

Battery is in trunk, but in front under hood there is a fuse box next to it there is a cover with a "+" sign. lift and connect positive cable there. connect neg cable to frame(I use the strut bolt).

The 2014 Volvo S80 has a 3.2 L base engine size.

An oil pan cover from a Volvo s80 can fit in a Volvo s60.

You need to be more specific. Where is the FM antenna on what? The FM antenna at a radio staion could be on a mountain. FM is called line of site transmission. Meaning, it shoots a beam , or wave, in a staight line to your antenna on your car or house. So, FM can be heard even if you are going through a tunnel, provided there are no mountains to block the signal. It is also called Frequency Modulation. AM is Amplitude Modulation. It is bounced up and down between the atmospere and the ground, until it hits your antenna. So, AM can even be heard if mountains block your signal. It simply bounces over and on top of them to your antenna. Where is your car?

The gas tank on the 2012 Volvo S80 holds 18.5 gal..

The gas tank on the 2015 Volvo S80 holds 18.5 gal..

to remove the spindle and four bolts hold the bearing assembly to the "A" frame. remove the wheel, remove the control arm, remove the lower "A" frame , and remove the CV axle. then you will have acess to the 4 bolts that hold the bearing assembly. you will have to buy the whole assembly.

The SRS light is on because there is a malfunction. The malfunction may prevent your airbag from deploying properly in a crash. The light will not go out until the malfunction is repaired. The best thing is to take the car to an authorized repair facility where they will connect a scan tool to the SRS system and diagnose the malfunction. It could just be a loose wire or connector somewhere.

The maximum tosing capacity of the 2005 Volvo S80 is 3300 lbs..