0
Chevy Avalanche
Chevy Avalanche is a sport utility truck produced by General Motors that has five or six seating capacity. It is distinguished by its removable rear window and back seat open bed which can be opened via a folding panel.
1,380 Questions
How do you replace a serpentine belt on a 2000 Infiniti QX4?
On the 2000 QX4 you will have 3 belts. Starting from the fan blade back to the engine block, look to the left of the fan blade. There will be a tension pulley which looks like a smooth wheel with no pump or motor behind it. Release the lock on it by loosening the bolt in the center of the wheel (just until the bolt becomes loose or can be turned by hand). Above and slightly behind it is a bolt facing down that moves the wheel up or down, creating the belt tension. Loosen this bolt until the belt can be slid out. Next is a similar set up to the right of the fan blade. This will control the pulley for the 2nd belt. Finally, crawl underneath for the power steering belt (the last belt). Remove the black splash-guard to get access. Looking up on the pump, there will be 2 bolts. The one on the left, conveniently placed against the firewall, and one on the right, which mounts the p/s pump bracket to the engine. Break the tension on the right bolt so the bracket can move up and down, then tighten the bolt on the left (which commonly can be turned about 1/16 of a turn because of it's location - be patient!) Tightening will push the pump towards the engine, allowing the belt to be slid off. Replace the belts and manipulate the nuts in the reverse order of removing, inspecting that they're on the pulley correctly and in the correct place. Replace the splash-guard.
Note: When removing the belts, many of the bolts may be very hard to begin turning. Once you have broke the tension on them, they should turn relatively easy. Once you've broke the tension on the binding bolt (the center of the two pulley wheels and the bolt closest to the engine on the p/s bracket), the belt tension bolts should turn easily. If the belt tension bolts become difficult to turn, consider loosening a bit more to the opposing bolt which might be putting tension on the bracket you're moving or checking that you're not tightening the belt.
Tools required: You can complete the entire job with a metric 10,12,14 standard depth socket with a couple extensions. Also have a 12 and 14 open end wrench.
How do you replace a serpentine belt on a cadillac deville 1994?
Probably one of the most simple maintenance jobs a do-it-yourselfer can perform...
The only tool needed is a 1/2" breaker bar. To the rear of the power steering pump you will see a belt tensioner that has a square cutout that the breaker bar fits into. Pull the breaker bar towards the front of the car (or up) and the tensioner will move so you can pull off the old belt. Pay attention to the routing of the belt--make a diagram if the decal is missing from the underside of the hood! Put the new belt in place, use the breaker bar to again move the tensioner and slip the belt under it. You're done! Takes all of maybe ten minutes.
How do you remove a front door speaker grill on a 1998 Chevy Corvette?
First remove the trim from around the handle. Use a flat blade screwdriver for this. The pop the small plastic peice from behind the grab handle. There are two Torx screws there. Then you will need to POP the plastic retainers loose that hold the panel to the door itself. They make a loud snap noise but don't be scared they usually don't break. Then once the panel is loose disconnect the wire for your switches from the back side of the panel. The speaker itself has about six 7mm head screws holding it in place. Dave
How many gallons does the gas tank in the 2013 Chevrolet Black-Diamond-Avalanche hold?
The gas tank on the 2013 Chevrolet Black-Diamond-Avalanche holds 31.5 gal..
Where is the signal flasher located on a 2008 chevy avalanche?
The turn signal flasher on a 2008 Chevy Avalanche is located inside a panel close to the gas pedal.
What is the fuel pressure in a 2003 Chevy Avalanche?
the proper pressure will be 55-62 psi on regular 2wd 5.3l if it is a e85 system it will be 45-52 psi.
What is the horsepower of a 1999 Ford Ranger 4.0L V6?
According to the 1999 Ford Ranger owners manual , the 4.0 L OHV engine is rated at 160 horsepower at 4200 RPM and 225 lb-ft torque at 2750 RPM
How do you replace the headlight bulb located on a 2002 Chevrolet Avalanche?
the light above the headlamp snaps out after releasing a small plstic tab. This then will let you see two small diameter rods on top of the lamp assy. lift these up and the headlamp assy will come out inyour hands. Then the bulb replacement is obvious. P.S. use a paper towell or something to prevent the oil from your hands contaminating the new bulb. Any oil transfer will cause a hot spot and the replacement bulb will not last long.
How do you change the alternator in a 1998 ford 150 5.4 engine?
losen and pull off belt by using the tensioner( right above AC if you have it) dont do it wile the truck is running. disconect wires unbolt aternator, then do it backwrds with the new one instead
Why does abs and stability message come on 2005 Chevy Avalanche?
Sounds like your pads might be bad on one or more wheels.
How do you change cabin filter Hyundai xg350l?
To remove existing filter: 1. Open the glove compartment, locate and remove the spring-loaded stop cord on the right hand side of the glove compartment. This is done by slightly pulling the cord into the glove compartment then feeding it back through the hole. It is spring loaded but will park in an easily reachable position. 2. Locate and remove the rubber stoppers on each side of the glove compartment and remove by pulling them out on the leading edge and slide them toward you. 3. Swing the glove compartment door down to the floor. 4. Locate and remove the 10MM bolts one each side of the lower portion of the panel behind the glove compartment. 5. Locate and remove the Phillips head screws one on each side of the upper portion of the panel behind the glove compartment. There is also one on the lower right side.
6. Locate and remove the 10MM nut located in the center portion of the panel. 7. Carefully pull out the glove compartment panel releasing the two locking clips and disconnect the two electrical connections. 8. Remove the bottom panel by carefully releasing the two locking clips and a tab that hooks onto the front lip of the blower housing. 9. Locate the filter access door and remove by pulling down and outward on the bottom lip. 10. Pull the dirty cabin filter out by the small handle located in the center of the filter. 11. Install the new filter paying close attention to the airflow directional arrows. 12. Reverse the procedure to complete assembly
What truck has a 4L60e transmission?
A Chevy truck 92 was the change over year from a 700r4 to the 4L60E
Is the Chevy Avalanche being discontinued?
Yes! I just bought an 09 AV from Andeanchevy.com in GA and they said 2011 is the final year for the AV. Perhaps a redesigned or new version will surface in 2012. They ordered double stock of the 2011 AV in anticipation of a sales rush!
Can you tow a Chevrolet Avalanche with a motor home having a Caterpillar 250 diesel engine?
probably yes. The caterpillar engine would have no problem pulling it. You will notice slight power loss because of the added load but no problem towing it. You should observe all precautions involving the automatic trans in the Avalanche. You should use a dolly or something to prevent the wheels from turning the driveline as the automatic doesn't get lube when being towed with the engine not running.
What features are standard on a Chevy Avalanche?
The standard features include front Air Conditioning, Auto On Headlights, Cruise Control, Keyless Entry, , Power Locks, Power Windows, Privacy Glass, and many many more features that can be found in a number of places.
How do you change the cabin filter in a 2001 Nissan Frontier?
The cabin filter was introduced to Nissan Frontier's in 2002.
How do you disable the seatbelt warning buzzer on a 2007 Honda CR-V?
Just connect the two cables that are in the female slot of the seat belt coupler.
How to change a Chevy Avalanche battery?
just unblot the top corner brace(4 bolts, 2 fender side and 2 front window side), which is over the battery, then just disconnect the positive and negative post and take the battery out!
Where is the oil filter located on a Chevy Avalanche 2500 8.1 liter v8?
LOOK UNDER AND YOU WILL SEE THE BIG FILTER RIGHT UNDER BEFORE YOUR TIRE.
2003 avalanche shut off while driving. has battery and electrical working. wont turn over?
Depends on the model. 1500 fuel pump or ignistion switch. If it wont start at all expect the fuel pump. If it is intermittant expect the switch.
What is the door speaker size in a 2007 Chevrolet avalanche?
They are 6 1/2" speakers. However, they are specially designed to fit the avalanche door. The speakers are formed into a teardrop shaped housing. Standard round 6 1/2" speakers won't fit into this housing. You have to either screw it directly into the door frame, or you can get some adapters made by Scosche. Best buy had them.
Also, you'll have to tap into your factory speaker wires, as they won't plug directly into stereo shop speakers.
I just replaced mine, and until the brackets get here, I cut the bad speakers and their supports out of the plastic housing and sandwiched the new ones between the bracket and the door and put the screw back in. It works fine temporarily.
Crankshaft sensor location on Chevy Avalanche?
It's easy its just above the starter remove the starter with 1/2" socket your crank sensor is right there one 10mm socket
How do you replace the serpentine belt on a 1997 Ford Thunderbird?
Remove your idler pulley first. it is the pulley right next to the alternator.
