Chevy Impala

adjust the climate control to the right temp that you want it, then all you need to do is adjust where you want it to blowl. on some impalas you may have to push the button with the snowflake on it to turn the AC off, then you need to change your flow to circulation, which is located on the other side of the AC button.

The 2003 Impala uses between 4.5 and 4.75 quarts of oil during an oil change. Use the dipstick after getting the oil level close to add more as needed to fill.

The 2001 Chevrolet Impala has hook-end wiper arms. See the Sources and Related Links section below for wiper blade installation videos and correct attachment/length wiper blade sizes. Also, if you purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through. Very simple.

just over 3700 LBS

I have an 03 Impala LS with the 3.8 liter engine and it has made that sound for years. My mechanic says it is water running into the heater core in the dash. He says not to worry about it. SO far it has not caused me any problems.

1 5 3 6 2 4

r-134a

Cooling Fans Fuses and Relays are in the Underhood Fuse Block #2. See page 6-67 of your "Owner's Manual for details...

There are a few ways to this. You can take the window out or leave it in.

1.) remove the door panel and pull back the sticky paper.

2.) After you do this, push the window up, clean the class and clean the two clips on the aluminum arm

3.) Use a silicon or if you want an epoxy to fill the two clips the window sits in and lower the window back into these two clips.

4.)use the window button to close the window and let the epoxy or silicon cure. I usually wait 1-2 days.

5.) You should be good to go until the next time it happens

1,50"

Go to nada.com and look under classic cars.

Hi, the color or paint code is not in the VIN number. There should be a sticker on the under side of your trunk lid. It has the VIN and also several other groups of numbers. The color code is a number, at the bottom of the sticker and normally begins with "U" my impala is blue and the code is U 353E.

i own a 1996 impala ss and i have the original window sticker that says that it gets 17and26 not bad for a 4200 pound car with 260 hp

The Chevy Impala has been built since 1957. You cannot expect an answer without listing the year and engine size.

under the truck

it weights about 750 lbs without the transmission

It's located on the driverside under the hood in front of the engine compartment.

5x115

No. The crank sensor reads the crankshaft location and speed. The cam sensor reads the camshaft.

sse

Remove the 1 screw behing door handle and the 2 on the armrest. Then pull outward on the bottom of the door panel. There are 8 to 10 plastic retainers holding the plastic to the metal.

I just bought a color 1966 impala wiring schematic on eBay that covers bumper to bumper. Read their full add in case u have extra options that the basic diagram may not cover. I am about to finish rewiring a whole 66 myself. Good luck, Oldskool Art Customs. 818 414 1968

yes , but pressure sensor from older transmission needs to be install in newer one

Ontario, Canada

It is to the left and slightly down of your throttle body. Follow your air filter box all the way to the throttle body and to the left of that on the block is the sensor you can not miss it their is wire clipped on top of it. If you unclasp that wire you will see three prongs and that is your sensor/switch. Very easy to replace.

rear tail light fuse