0
Chrysler LeBaron
Chrysler LeBaron was a luxury car produced by Chrysler in the 1930s. It became the strongest competitor of other luxury car brands such as Packard, Cadillac and Lincoln
927 Questions
You can open a hood on a 1995 Chrysler LeBaron convertible gtc from the outside if your lever is broken. All you have to do is get a pair of vise grips and pull the cable which will release the hood.
Why does the Anti lock brake lite come on in a 1992 Chrysler LeBaron?
It stays on when the computer detects a malfunction and sets a trouble code.
What would cause the dash lights and the horn not to work on a '92 Chrysler LeBaron?
Hey Barbara==It could be as simple as a blown fuse. Check ALL of the fuses. Goodluck, Joe
Chrysler tied the cigar lighter fuse in with the park lamp circut go to the cigar fuse and replace it and it will be tadah, dash lights.
I had the same problem on my 91 convertible. Checked all fuses and replaced, still not working. I ran a hot fused wire under the console and attached it to the hot line for the cigar lighter. Horn and lighter now work great.
Hello there, I have a LeBaron Sedan. If neither the dashboard or the horn works, maybe it's a fuse the cause, or perhaps your electric system has a short circuit issue that you must attend before more electric-related systems fail. That's what happened to my car about ten years ago; first the radio when out, in a month or so after that the dashboard, later the directionals. If the fuse replacement doesn't work for your car problem, feel free to contact me at alg11@televicable.net.mx
It could be the horn relay located behind the drivers side kick panel next to floor or you can check it by turning the ignition on and pressing on the Two horn buttons and listening to see if the relay clicks as you press the button. If it doesn't click the horn relay needs to be replaced. Note: There are 8 or 10 relays on this relay block so you must use the diagram located on the backside of the panel that covers the lower part of the steering wheel.
Where is the starter located on a 1993 Chrysler LeBaron?
Four cylinder, it is on the rear of the engine below the exhaust manifold.
Six cylinder, it is on the front of the engine, behind the motor mount bracket.
Four cylinder, it is on the rear of the engine below the exhaust manifold.
Six cylinder, it is on the front of the engine, behind the motor mount bracket.
Where is the fuse box located on a 1987 Chrysler LeBaron?
Try looking in the glove box right hand side there should be there behind a panel or on the left hand side under the instrument panel by the steering column good luck Try looking in the glove box right hand side it should be there behind a panel or on the left hand side under the instrument panel by the steering column good luck
What is the spark plug gap on a 1994 LeBaron 6-cylinder?
Spark Plug Gap is .035, Torque then to 20 foot pounds.
What could be wrong if a 1995 Ford Contour will not start?
IT is not getting one or more of the following: spark, fuel or compression. Assuming it cranks. If it doesn't crank, it is probably an electrical problem such as starter, battery or alternater.
What size are the speakers in a 1994 Chrysler lebaron gtc convertible?
4 inch in the dash 6 inch in doors and back 4 inch in the dash 6 inch in doors and back
Where is the thermostat on a 1990 Chrysler lebaron?
Changing the Thermostat on a 1989 - 1995 Lebaron V6 3.0ltr
BUY..
A NEW THERMOSTAT FOR THE CAR 1ST
ANTIFREEZE
GASKET SEALER
Follow the top hose from the top left of the radiator back to the engine block, where the hose ends attached to a metalic dome (thermostsat housing), held inplace by a pair of 3/8 or 10mm bolts. Remove bolts and take em out of the holes (stops them flying off into the engine in a place where you cant get them back). Lift off the thermostat housing and remove old thermostat after checking which way it sits in place.
Use a clean rag to fill hole while you clean away any residual gasket debris. Fit new thermostat, Use gasket seal on the new supplied gasket replace housing.. and bolt down tight.. refill system with recommended antifreeze and run the engine and check for leaks and top up levels as required..
DIFFICULTY: Low 20 mins max
Location of hyradulic pump for convertible need diagram?
Don't have a diagram for you, but the pump is behind the back seat. Reach under seat on both sides and pull until bottom of seat comes up. Remove the seat belt bracket, and slide seat back off of the bolt. Pull seat up, and the hydraulic pump should be exposed.
Will a boot for a 1993 lebaron convertible fit a 1989 lebaron?
no boot for 93 is 90-95 look on eBay orchrysler parts for 89
Of course it fits, without any restriction, all boots are the same from 1987 up to 1995, but Chrysler uses other part numbers!
How do you manually operate the rear windows in a 1990 lebaron convertible?
The motors on the rear quarter windows are unreliable.. same thing happened to my lebaron. you have to push them down and move it back and forth. but be careful as to not break it or put too much pressure on it. That worked for me.
How do you install serpentine belt on 94 Chrysler LeBaron and what is the serpentine route?
go to autozone, they will print out a diagram for you, also...you can probably find it on the internet...just got done fixin mine..good luck!
Why does an electrical engine fan stop working on a 1990 Chrysler Lebaron?
Your engine fan is electrical and is thermostatically controlled. It isn't supposed to run continuously only intermittantly. If it doesn't run at all your fan is defective most likely. fan relay My 1990 engine cooling fan quit this past summer and the AC quit cooling at the same time. I found that the two are tied together with a relay that is located on the drivers side fender wall about center. If this relay fails then both quit working. I could not locate one at the local parts stores so I took mine apart and filed the contact points and reset them and it has been working fine. Hope this helps.
How do you replace the pulley tensioner on a 1994 Chrysler lebaron?
If you are lucky like me you spray a lot of WD40 on the hub and use wrenches to work it back and forth until you feel the spring action. otherwise, good luck . use PB Buster it is better than WD 40 It is made for freeing rusted bolts and screws
Why does the heater blow cold and temperature gauge stays on cold on a 1994 Chrysler LeBaron?
Most likely cause is a failed engine thermostat.
How do you adjust idle for 1992 Chrysler lebaron 2.5 liter engine?
Not adjustable, idle is computer controlled with an IAC stepper motor.
Where is the voltage regulator on a 1992 Le Baron?
The engine computer is also the voltage regulator
The engine computer is also the voltage regulator
Where are the freeze plugs on a 1989 Chrysler LeBaron?
Four cylinder, rear and transmission side. Six cylinder, front rear and transmission side.
