0
Chrysler Sebring
The Chrysler Sebring is a range of middle-sized cars manufactured by American carmaker Chrysler between 1995 and 2010. It is one of the few practically priced automobiles available in sedan and convertible body styles.
2,284 Questions
What is the problem when the fan speed only works on high for a 2008 chrysler sebring?
The blower resistor has failed.
The blower resistor has failed.
How do you change the mass air flow sensor on a 1999 Chrysler Sebring?
A 1999 Chrysler Sebring does not have a mass airflow sensor.
When do you change a timing belt on a 2004 Chrysler sebring?
Change the timing belt every 100,000 miles.
How do you replace the battery on 1996 Chrysler Sebring Convertible JXI?
It's located in the front wheel well. Remove front left wheel, then unscrew battery door. Actually, there's no reason to remove the driver's side front wheel, just turn wheel to left and right behind the wheel you'll find an access panel, remove this and there's your battery. Recommend removing negative post first to prevent "short circuit" when removing positive terminal. Good Luck!
Could be a wheel bearing
Where is the drain plug located on the transmission for a 2005 Chrysler sebring 2.7 v6 engine?
Chrysler doesn't use drain plugs on they're transmissions. so it isn't there
Why do you have an occasional lack of spark in a 1997 Chrysler Sebring?
my original response to your question is below.. but it may be a spark plug, which would cost a lot less than the coil/cap combo. but its a good idea to replace coil/cap/wires every 100k miles.
Your Coil/Distributor Cap is going bad, replace it now before it dies and your car wont start. generally if you're at 100k miles they should be replaced, but mine lasted till 130k (it would misfire on acceleration and then it just stopped running). The Cap/Coil is located under the intake valve on the intake manifold, it is rather hard to get to without removing the intake manifold or the brake fluid resivoir. This is also a 250-300 dollar part(i know... owwie), but if it runs good otherwise its a good investment.
if your car doesnt have 100k miles on it this probably isn't your problem unless you've somehow shorted your ignition system out.
Why does the 20 amp fuse for the starter-fuel keep blowing on your 2002 sebring convertible?
It is very common for the starter to be the cause of that fuse blowing.
Where is the oil sending switch on a 2004 Chrysler sebring 2.7?
It is on the back of the engine, above the oil pan, behind a heat shield.
It is on the back of the engine, above the oil pan, behind a heat shield.
How to remove the governor on a Chrysler sebring?
The "governor" on this car isn't a part that can be removed. The vehicle's ECM is programmed to cut the fuel supply once the vehicle reaches a pre-determined speed. For my 2005 Sebring, that speed is set at 190 km/hr. In theory, it is possible to reprogram the ECM, and there are companies that offer power programmers for certain higher performance vehicles, such as a Magnum, or 300. However, to the best of my knowledge, no programmers are available for the Sebring. You'd have to be a programming genius, and rather stupid, at the same time, to attempt any kind of modification to your ECM on your own.
What can cause a knocking noise in a 1997 Chrysler Sebring?
depends on what type off knocking it is if its a loud one that you can hear while standing outside the car: u need to get a tune up!!! it could just be a loose spark plug or just in need off an oil change really bad.. hope this helps you...
2007 Chrysler sebring recalls?
These are the possible recalls I found. RC-H11-08 Customer Satisfaction Notification H11 - Radio Software Update RC-H07-08 Safety Recall H07 - Tire Pressure Monitoring System Electrical Connectors RC-G12-07 SUPERSEDED BY :RC-G33-07(Safety Recall G33 - Front Door Latch Cables) RC-G33-07 Safety Recall G33 - Front Door Latch Cables RC-G23-07 Emissions Recall G23 - Reprogram TIPM: Transmission Default RC-G14-07 Safety Recall G14 - Seat Track Position Sensor RC-F50-07 Revised Safety Recall F50 - Reprogram ABS Control Module RC-F51-06 Safety Recall F51 - Reprogram HVAC Module RC-F45-06 Safety Recall F45 - Hood Latch Striker
The noise you're hearing is likely the power steering rack and I'll bet the outside air temperature is cool or cold - yes? If so, your problem is power steering oil pressuring its way past the seals in the rack. The other cause is that the serpentine fan belt is worn and is slipping on the power steering pump pulley at extreme left or extreme right - those times when the pump output is at its greatest demand! Check the fanbelt, or if you're like me it's the original one from 150,000 miles ago on my Sebring, and look for normal wear - shiny look on top side of the belt (opposite side from grooves) and checked or pitted look on grooved side of belt. The steering wheel will also be "jerky" when you hear that accompanying noise - yes? Try the belt replacement first - the more expensive option is the replacement of the power steering rack with a rebuilt one. Oh, don't forget to check the fluid level in the power steering pump too! Good luck!
Where is the crank shaft sensor on a 2000 Chrysler Sebring jxi?
The sensor is under the car on the back of the engine on the left side on the 2.4L.
On the 2.5L it is on the top rear of the transmission bell housing.
This is a fairly common problem. If you do a search at www.sebringclub.com in the "how to" section you should find your answer complete with pictures. Irritating isn't it. Anon
97 sebring you have tail signal lights but no brake lights at all?
if you have checked all your fuses and they are ok this has happened to me already.... more than likely your brake pedal switch has gone bad. sometimes your cruise control brake override goes out with this but more than likely not. replacing this is somewhat aggrivating if you have large hands. you have to unhook the connectors while it is still connected to the brake pedal brace and then pull it out of the pedal brace bar. then you have to put the new one in its place and reconnect it after you make sure it is being contacted by the brake pedal when it is not depressed.
Where is the thermostat in a 2004 Chrysler Sebring convertible?
The thermostat for a 2004 Sebring Convertable is in under the water outlet for the BOTTOM radiator hose. This is behind the alternator which will have to be removed, after you remove the belts. Plan on an afternoon of work. Hope this helps.
Where is the oil plug drain on the 2004 Chrysler Sebring Touring 2004?
If you can't find the oil drain plug - take your car to a professional. Any automotive maintenance is above your skill level. On the oil pan. Open the book that came with the car. It is called the owner's manual. Here you will find answers to almost any question about your car. The plug is on the passenger side in the back side of the waffle looking silver colored oil pan. The plug is small at 13MM
How much does it cost to replace the engine in a Chrysler Sebring?
The cost to replace the engine in your Chrysler Sebring will range between $2000 and $6000. Replacing with a used engine will be the cheapest and replacing with a brand-new engine will cost the most.
Where is the brake fluid reservoir on the 1997 Chrysler Sebring convertible?
under the hood on the drivers side towards the firewall.
What drives the oil pump in a 2006 Chrysler sebring?
The oil pump sits on the nose of the crankshaft under the timing system.
How do you change the air filter on a 2002 Chrysler Sebring with the 2.7 liter V6?
Unscrew the large air hose from the air filter housing at both ends using a screw driver. It is tight, and you may have to disconnect the electrical wires above it for room. Once the large hose is loose, pull it away from the housing, and pull the round tube style air filter straight out. Replace and make sure all connections are reconnected.
