Chrysler

The power distribution center is the fuse box under the hood.

The power distribution center is the fuse box under the hood.

all Chrysler transmissions are prone to fail early

^^ incorrect. only the overdrive trannys are problematic. change the fluid and filter every 20K and you'll be fine.

The flasher unit for the indicators. Pressing and releasing the foot brake for the brake lights. Turning the light switch on and of for the others.

If it is not any of these then there is an electrical fault, possibly a loose connection.

2.4L has a belt, all other engines are a chain.

There are several reasons for the Chrysler error code 0016. Some of the possible reasons are dirty engine oil, misaligned timing gear, and bad crankshaft sensor.

Look for a manufacture that supplies a mechanical gauge and check directions for location it depends what the size fittings they use.

Inside the transmission, on top of the valve body.

The dealer might be able to turn it off with their scanner. Other than that there is no way.

ok this sounds like a tranny cable wire - on your throttle body their is a plastic piece that holds the cable on the throttle that probably fell out -put a metal clip to hold the wire and if you can make sure the wire is set right to shift the tranny DO NOT DRIVE THE CAR YOU WILL FRY THE TRANSMISSION!

This happened to my car and I lost my overdrive gear and the shop said i would probably lose my other gears but i have been driving about 200 miles ever couple weeks for 3 or 4 months now with no problems

Yes. There is a lug nut adapter for the Chrysler Aspen.

A ticking sound at startup can be a couple of things. It can be a worn drive belt, especially if it does not go away fairly quickly. It also can be a valve lifter noise. Check the drive belt and replace if necessary. Change the oil and try using a different brand oil filter. Purolator, AC/Delco, Wix, Motorcraft, are all good. I would use an OEM type filter to start with. If the car has solid lifters they may need adjusting. If it has hydraulic lifters and changing oil/filter does not help, purchase a can of Seafoam Motor Treatment. Often lifter noise in hydraulic lifters is often due to dirty and gummed up oil passages, varnished lifters and buildup of gum, varnish and carbon. Seafoam is an excellent product used by many auto technicians that will help clean the lifters. It can be purchased at most auto & marine parts stores. Follow the directions on the can to the letter. It is also an excellent Fuel Injector cleaner.

No, just a can of sealant and an air compressor.

The dipstick is a dealer only special tool.

How would you know about my car? Get literate!

The friendly answer is worn engine mounts or to high idle speed.

Belt on the 2.2 DOHC engine, replace at 120,000 miles. It is an interfernce engine. If the belt breaks, serious engine damage will occur.

.044

if you mean the one on the front holding on the damper its right.its just real tight

Unhooking the battery would reset it. A USA radio does not use even FM numbers.

It contains two potentiometers.

Ain't No Love, in the Heart of the City by Bobby Blue Bland

The version in the commercial, is slightly remixed, as used by Jay-Z in his version, but the basic song is originally by Bobby Blue Bland and is used in the film The Lincoln Lawyer, and can be found on the films soundtrack.

The release clutch on the motor may be malfunctioning.

It is on the back of the transmission.

To get away from the engine heat.

Grey key, yes. Black key, no.

It uses regular power steering fluid.