0
Chrysler
This category is for questions and answers about Chrysler corporation vehicles.
1,889 Questions
You need a scan tool to program that remote. You will probably have to go the dealer.
How do you open a hood release on a 1994 Chrysler caprice classic when the cable is broken?
There is no such thing as a Chrysler Caprice Classic. Chevy made a car called the Caprice (I had a 1969).
Where is the fuel shut off valve reset switch on a Chrysler LHS?
Chrysler does not use reset switches.
How do you adjust the idle speed on a 1998 Chrysler cirrus?
Idle speed on a 1998 Chrysler is computer controlled and is not adjustable. If idle speed is incorrect, you have a sensor, actuator, or mechanical failure. Places to start are, check for engine fault codes. Check for vacuum leaks.
What car does an stp s016 oil filter fit?
Agco Tractors, Chrysler (70-91), Ford/Mercury (83-97), Kubota Engines, Land Rover (95-04), Toyota (68-90)
See link for more applications
How do I replace a MAF sensor on a Chrysler?
Auto Zone's website has on-line vehicle repair guides...the type you buy, but free and electronic. That's where I go for all my repair info.
No, the door is powered by wiring that runs along the bottom track.
What damage does a timing belt failure do on a Chrysler grand voyager 2000?
On the 2.4L the intake valves can hit the exhaust valves and bend.
What does it mean when my 2002 Grand Voyager check engine light comes on?
It means there is a problem with the emissions system on the vehicle. It can be as simple as a loose gas cap, or more serious. Take it to a professional and have the computer scanned with an OBD2 scanner. That will retrieve the stored code, which will help in finding the problem. You might try an Auto Parts store and see if they will scan it for free.
Can you show Chrysler 300 warning lights signs?
i have a chrysler 300 touring 2010 that has a light that looks like an engine on what does that mean?
That is the Check Engine light. It is on because the computer (ECU) has detected a problem with the emissions system. Seek the help of a professional in diagnosing and repairing the problem.
What would cause a 1995 Chrysler Lebaron GTC to not be able to shift from 2nd to 3rd while driving?
sounds like a tranny job may be just around the corner, ok..heres what I'd do... Get a can of Berrymans B-12Chemtool, and add to the Auto Trans fill... Ignore what the can says, because it used to say can be used for flushing engine oil and to free valve bodies of automatics... They changed the label because people would add the stuff then LEAV IT IN!! DO NOT DO THIS!! You will be adding a can and after a MELLOW SHORT DRIVE, you (or take it to the oil changers)will be draining the trans fluid and replacing the filter (A TRANSMISSION SERVICE) Your refill of the transmission will also include a can of KW brand TransFix, or Lucas Automatic Transmission Treatment...IDEALLY BOTH !! Check for leaks, and start driving....IF the problem is fixed, great, you've DELAYED the INEVITABLE---a trans overhaul... Heres, my email, in case I can be of more assistance, I don't ususally give it out, but I do this to repay bad Karma from my past life....:) tradertaippan@yahoo.com also Everyone should have a manual for their vehicle, and a professional shop manual should be available at your local library for diagnostic procedures etc, just make copies of the right pages, as they are usually REFERENCE only...read up and good luck :)
Is Chrysler engine a interfearance engine?
it depends on what year and model, i am not sure but i know a few are. if your engine gets off timing, then it will damage the valves, which is a pain to fix but is possible. if your worried about this happening then replace the timing belt at 100,000 miles. its only about 50$ but will save you a lot more money, time and effort replacing valves and all the other seals that go with it
Where is the battery for a 2005 Chrysler located?
Town and country : under the hood.
Sebring : inner fender/.
300 : trunk
How do you reset the tcm on a 1995 Chrysler 3.5L engine?
You can either use a scan tool, or you can unhook the battery for ten minutes.
Where the output speed sensor on 2006 Chrysler 300C nag1 transmission?
The NAG1 transmission uses the wheel speed sensors (at each wheel bearing) as the output speed signal.
You need to check the control system for codes.
Can you put neon SRT-4 motor in a 1996 talon esi?
In theory, you can put any motor in any car. You will be in for some work though, new motor mounts, new harness and ecu, hood clearence and centering issues, just to name a few. It can be done, but be prepared for a lot of work. Remeber, its a dodge motor in a Mitsubishi body so be prepared for a lot of fitting nightmares.
True but Un-true, the car came from the factory as a mitsubishi body with a dodge motor...their basically the same motor . just configured in the opposite direction of each other. save the money, re-build your 420a w/ a 2.4 crank and low comp pistons and you have essentially a srt4 motor
Where is the dome light switch for 1995 Chrysler?
It's on the left side of the dash. the switch that controls the brightness of the lights in the dash board. slide it all the way up and it'll click the dome light on. Click it down it turns the dome light goes off.
What is the tire size for a Chrysler 1994 Intrepid?
Listed on the driver's door post and in the owner's manual.
Where is the oil pressure sensor located at 2011 Chrysler 200 3.6?
The oil pressure sensor is under the intake manifold on a 3.6L.
Type of oil Chrysler Grand Voyager use?
uses 10 w 30 or 40 oil.Chek in you manual and it will tell you which one to use.If your in very cold state, then you will have to use 5w 40 for the van.Get a repair manual and it will tell you which ones you can use. Have fun
