0
Chrysler
This category is for questions and answers about Chrysler corporation vehicles.
1,889 Questions
Where the output speed sensor on 2006 Chrysler 300C nag1 transmission?
The NAG1 transmission uses the wheel speed sensors (at each wheel bearing) as the output speed signal.
Can you put neon SRT-4 motor in a 1996 talon esi?
In theory, you can put any motor in any car. You will be in for some work though, new motor mounts, new harness and ecu, hood clearence and centering issues, just to name a few. It can be done, but be prepared for a lot of work. Remeber, its a dodge motor in a Mitsubishi body so be prepared for a lot of fitting nightmares.
True but Un-true, the car came from the factory as a mitsubishi body with a dodge motor...their basically the same motor . just configured in the opposite direction of each other. save the money, re-build your 420a w/ a 2.4 crank and low comp pistons and you have essentially a srt4 motor
You need to check the control system for codes.
Where is the dome light switch for 1995 Chrysler?
It's on the left side of the dash. the switch that controls the brightness of the lights in the dash board. slide it all the way up and it'll click the dome light on. Click it down it turns the dome light goes off.
What is the tire size for a Chrysler 1994 Intrepid?
Listed on the driver's door post and in the owner's manual.
Where is the oil pressure sensor located at 2011 Chrysler 200 3.6?
The oil pressure sensor is under the intake manifold on a 3.6L.
How good is a 7.5hp Chrysler outboard motor?
It is not a good choice at all. For a very different reason. Almost no original parts are available. What might be available is a visual substitute which may or may not work properly and even these substituted parts are difficult to identify or cross reference. Few shops will even tackle a repair on these motors because of that.
Type of oil Chrysler Grand Voyager use?
uses 10 w 30 or 40 oil.Chek in you manual and it will tell you which one to use.If your in very cold state, then you will have to use 5w 40 for the van.Get a repair manual and it will tell you which ones you can use. Have fun
What is the mpg of the Chrysler LeBaron 1995?
I have a 1993 Lebaron with 3.0 Liter and Automatic. I get between 23-26 mpg.
What years did Rolls-Royce use Chrysler engines?
I doubt that Rolls Royce ever used a Chrysler built engine but I know they used custom built automatic transmissions based on the Chrysler 727. And no the parts don't interchange.
Where is the fuse box for Chrysler neon?
open the driver side door, near the hinges there is a plastic piece with what looks like a slot in it, pull it out theres your box. or under ther hood next to the battery lable relays and fuses
Where is Coolant temperature sensor in a Chrysler 1990 Le Baron?
Two wire sensor very near upper rad hose and thermostat housing.
What does code P1789 means on a Chrysler?
Trouble code P1789 means: Hydraulic Pressure Switch: OD/2-4
Does chrysler voyager 2000 have a timing belt?
The 4 cylinder has a belt that MUST be replaced every 120,000 miles. Warning: This is an interference engine.
Where is the transmission control module tcm located on a 1998 chrysler lhs?
Near the windshield fluid washer resovior, under the speed control servo.
Where is the electronic throttle control on 5.7 liter hemi dodge?
The throttle body is controlled by the engine computer, which is located on the firewall.
Where is the central locking fuse on a Chrysler voyager?
The central locking fuse on a Chrysler Grand Voyager is in the fuse box under the bonnet, but strangely enough it's labelled 'fuel heater'. Mine regularly blows!
Location of PVC in a Chrysler town and country 2005?
My pcv valve on the 3.8 motor appears to be on the drivers side under the power steering resevore next to the coil pack. How do you get the power steering reservore out.
The clutches are engaged using hydraulic pressure. The input shaft from the engine to the transmission runs the hydraulic pump which causes EVERYTHING to happen inside the transmission. A section of the transmission called the valve body is responsible for routing pressurized oil to engage the different clutches. Any point that results in low hydraulic pressure will cause the clutches to slip or fail to completely engage. Low hydraulic pressure can be caused by: low fluid level, a worn hydraulic pump, leaking seals in the valve body or even a partially blocked transmission fluid filter. Unfortunately, a blocked filter usually means clutch debris has built up to block the filter which causes the clutches to wear rapidly. Bottom line, once your transmission reaches the point you describe, it's probably done. If it's caused by anything other than low fluid, you need to either rebuild or replace the transmission. Even if it's low fluid the transmission could be permanantly damaged. I wish I could offer better future.
What type of transmission fluid is used for 1998 dodge stratus?
Mopar atf+4 do not use dextron/mercon
What would happen if you put the wrong brake fluid in your Chrysler voyager?
It would ruin the master cylinder, wheel cylinders, and calibers. Your vehicles uses DOT3. Look on the top of the master cylinder fill cap.
Chrysler town and country 2009 reset oil change warning?
Here's the procedure for reseting the indicator:
1. Turn the ignition to the on position, but don't start the vehicle
2. Fully depress the accelerator pedal fully 3 times within 10 seconds
3. Turn the ignition switch
to the off position
If it doesn't reset on your first try perform the procedure again, it's somewhat tricky the first couple times you do it.
