0
Chrysler
This category is for questions and answers about Chrysler corporation vehicles.
1,889 Questions
Where is the egr sensor in the 2006 2.7 Chrysler 300?
The EGR sensor is part of the EGR valve on the rear pass side of the engine.
The EGR sensor is part of the EGR valve on the rear pass side of the engine.
When does an extended warranty start on an auto?
You will need to read your contract, some start immediately and some have a 30 day waiting period. Also some contracts begin immediately and overlap factory warranties so you pay for double coverage and is not the best option or others start when the factory warranty expires. Vehicle Life Genuine Warranties start immediately upon approval if the car is not under factory warranty and starts after factory warranty expires. So if you buy a 2 year old car with 25,000 miles that has a factory 5 yr 60,000 mile warranty your coverage begins when the factory warranty expires...thereby not paying for coverage you cant use. visit http://vehiclelife.net or http://vehiclelifespan.com for their warrany solutions.
Where is the Cadillac converter located on a 99 Chrysler Town and Country?
Exhaust system, before the muffler. You will have one convertor and possibly 2 pre convertors prior to that that look like mufflers. If you need a new one go to a muffler shop. They charge like 150 and the dealer will charge 800
What does the engine light look like on the chrysler 300?
It looks like a little yellow engine.
It looks like a little yellow engine.
Your Chrysler voyager shudders sometimes when you accelerate why would this be?
Boy, there could be alot of reasons, I will list some Bad gas, water in the fuel system, dirty fuel injectors, possible transmission problem, cv joint going bad, bad spark plugs. Take it to a reliable mechanic for troubleshooting.
Where is the transmission solenoid pack located on a 2.7L Chrysler engine?
Sebring, On the front of the trans.
Concorde or 300, on the valve body inside the transmission.
Where is the ac drain tube located on a 1997 Chrysler Town and Country?
The air conditioning drain to on your 1997 Chrysler Town and Country can be found on the lower passenger side of the firewall.
How do you siphon gas from 1993 Chrysler?
To siphon gas safely, obtain a 5 foot length of PVC hose about 1/2 inch in diameter and another piece about one foot long insert both in the filling port, and seal off any air leak with a rag. Make sure the longer hose is at or near the bottom of tank. Blow into the short hose and the gas should come flowing out into whatever container you have prepared. Only perform this technique on your own car.
What does P1491 codes mean on a 2003 Chrysler minivan?
Trouble code P1491 means: Radiator fan relay control circuit
Where is the thermostat located on a 1999 chrysler 300m?
It is under the housing where the lower radiator hose hooks to the engine.
Chrysler check out this site its a bit outdated but its got the basics down.
How do you remove Town and Country rear brake drum?
They often stick, with emergency brake OFF, vehicle jacked and blocked, hold a small block of 2x4 against inside rim of drum, hit it with a heavy hammer, rotate drum and keep hitting on opposite sides.
You need to have the computer checked for codes. That will tell you what area the problem is in. It can be wiring, computer, or even an issue with the new transmission.
Where is the solenoid on a 92 Plymouth Voyager?
If your asking about the Starter Solenoid it is on the side of the starter which should be located on the front of the engine as you are looking at it. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For Information & Contact Details.
Where do you add transmission fluid in a 2005 Chrysler 300C?
The dipstick tube is located in the passenger side rear, under the hood. That is where the fluid is added. The dipstick itself is a special tool that the dealer and some independent shops will have.
Where is the speed sensor located on a 1997 chrysler?
It is on the output end of the transmission.
It is on the output end of the transmission.
How do you remove a stereo from a 2001 Holden Astra CD?
You can remove the stereo by purchasing a pair special set of removal tools. These tools are inexpensive, normally around $8 to $15. You can find them on ebay, e.g. http://search.ebay.com.au/search/search.dll?from=R40&_trksid=m37&satitle=astra+radio
How do you bleed the hydraulic clutch system on a 2001 PT cruiser?
You would bleed a clutch just like you would bleed brakes. Pump the pedal and then open the bleeder valve. Usually the bleeder valve is located on the slave cylinder. I'm not sure if the PT's have a bleeder, in which case you'd need to replace the clutch slave cylinder. They usually come with the reservoir and it's usually filled. They basically aren't serviceable anymore. You just replace them.
ANSWER
IF THERE IS NO LEAKS ON THE SYSTEM,VACUUM BLEEDER IS THE KEY IS TRUE THEY SAY,IF THERE IS NO LEAKS AND ALL INSTALLED,PRESS THE MASTER CYLINDER BYY HAND JUST TO GET FLUID INTO THE SYSTEM ONCE THE MASTER RESERVOIR IS EMPTY REFILL ,THEN REMOVE THE SLAVE CYLINDER AND DISENGAGE FROM THE FORK THAT IT IS FREE THEN VACUUM BLEED FROM THE TOP NOT BOTTOM THE GOOD THING ABOUT IT IS NO PRESSURE INVOLVE LIKE THE OLD SCHOOL STYLE,MAKE SURE WHEN YOU BLEED IT THE VACUUM PUMP RESERVOIR SHOULD BE FULL THAT SHOULD BE GOOD ENOUGH BLEEDING ON THE SYSTEM
