0
Chrysler
This category is for questions and answers about Chrysler corporation vehicles.
1,889 Questions
You need to have the computer checked for codes. That will tell you what area the problem is in. It can be wiring, computer, or even an issue with the new transmission.
Where is the solenoid on a 92 Plymouth Voyager?
If your asking about the Starter Solenoid it is on the side of the starter which should be located on the front of the engine as you are looking at it. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For Information & Contact Details.
Where do you add transmission fluid in a 2005 Chrysler 300C?
The dipstick tube is located in the passenger side rear, under the hood. That is where the fluid is added. The dipstick itself is a special tool that the dealer and some independent shops will have.
Where is the speed sensor located on a 1997 chrysler?
It is on the output end of the transmission.
It is on the output end of the transmission.
How do you remove a stereo from a 2001 Holden Astra CD?
You can remove the stereo by purchasing a pair special set of removal tools. These tools are inexpensive, normally around $8 to $15. You can find them on ebay, e.g. http://search.ebay.com.au/search/search.dll?from=R40&_trksid=m37&satitle=astra+radio
How do you bleed the hydraulic clutch system on a 2001 PT cruiser?
You would bleed a clutch just like you would bleed brakes. Pump the pedal and then open the bleeder valve. Usually the bleeder valve is located on the slave cylinder. I'm not sure if the PT's have a bleeder, in which case you'd need to replace the clutch slave cylinder. They usually come with the reservoir and it's usually filled. They basically aren't serviceable anymore. You just replace them.
ANSWER
IF THERE IS NO LEAKS ON THE SYSTEM,VACUUM BLEEDER IS THE KEY IS TRUE THEY SAY,IF THERE IS NO LEAKS AND ALL INSTALLED,PRESS THE MASTER CYLINDER BYY HAND JUST TO GET FLUID INTO THE SYSTEM ONCE THE MASTER RESERVOIR IS EMPTY REFILL ,THEN REMOVE THE SLAVE CYLINDER AND DISENGAGE FROM THE FORK THAT IT IS FREE THEN VACUUM BLEED FROM THE TOP NOT BOTTOM THE GOOD THING ABOUT IT IS NO PRESSURE INVOLVE LIKE THE OLD SCHOOL STYLE,MAKE SURE WHEN YOU BLEED IT THE VACUUM PUMP RESERVOIR SHOULD BE FULL THAT SHOULD BE GOOD ENOUGH BLEEDING ON THE SYSTEM
Where is the crank sensor on a Chrysler voyager?
if it auto transmission ,it in bellhousing ,takes reading off torque converter . i replaced mine when my van not start ,but did no good !! sensor in timing cover was the bad one ! on my 2001 Chrysler voyager
Yes, there is a Sun sensor on the top of the dash near the base of the windshield.
Where is the transmission computer located on a 1996 Plymouth voyager?
It is on the passenger side inner fender, under the hood.
It is on the passenger side inner fender, under the hood.
Why is the Chrysler PT Cruiser engine light on followed by one chime?
The engine light on followed by one chime in a PT Cruiser is a notice to the driver that something is wrong in the engine. The chime sounds only to make sure the driver notices the engine light.
What happens if transmission fluid is used in place of power steering fluid in Chrysler cars?
Later models use type 4 in both.
Where is the fuel pump located on a 1987 Chrysler conquest?
Mounted on top and inside the fuel tank. Look for an access panel to get to the pump without removing the fuel tank. If there is none, you will have to remove the fuel tank.
Decode VIN on a Chrysler Crossfire?
VinLink.com is VIN decoder...Decodes VINs from 1981 - Present day.
Send me your VIN (kobyjames4u@gmail.com) and I'll decode your VIN using my account.
What you the purpose of ignition off draw on a Chrysler product?
It provides power for radio and other computers memory.
What is the Chrysler 3.0L V6 oil filter part number?
Oil filter numbers vary by brand. Here are a few: Pennzoil- PZ34 Fram- PH16, DG-16 (Double Guard), HM-16 (High Mileage), TG16 (Tough Guard) Bosch Standard 72138, Bosch Premium 3402, Mobil M1204 K&N HP2004 Hope this helps/ These are numbers for a 93 Chrysler Lebaron with the 3.0. Will fit many models. To check for sure id go to shop.oreillyauto.com and enter your vehicle information. From that you will be able to pull up a reference chart of what it is.
How do you set the timing on a 1971 Chrysler 440 V8 engine?
Most of these older Mopars like to run at 10 BTDC. Unplug the vaccum line to the distributor, mark the harmonic balancer with a little white paint on the 10 BTDC mark and hook up your light; loosen the distributor, move the distributor a little at a time. I hope this helps a little.
How do you replace a tail light bulb on a 2004 Chrysler Pacifica?
My wife drives a 2005 Pacifica, so I assume that the procedure is the same, if not similar. Check the owners manual to be certain. (The procedure is outlined in the manual.) 1. Open the tail gate. 2. Remove the two bolts that hold the tail light assembly to the body. 3. Carefully rotate the assembly out (parallel to the ground) until it snaps free from the body. (Place a small piece of cloth at the apex of the horizontal V shaped edge where the ball-jointed peg is attached to the body. This will help to prevent the assembly from scratching the paint job.) 4. You then have ready access to all of the bulb connectors from the back side of the assembly. 5. Rotate the bulb connector counter clockwise to free the bulb connector. 6. Pull the bulb straight out of the connector. 7. Align the new bulb as the old bulb was aligned, and gently, yet firmly, push the new bulb into place. 8. Return the connector to the empty hole in the assembly and rotate it clockwise to secure it. 9. Push the ball-jointed peg into its receptacle in the body, and reconnect the assembly to the body with the two bolts remove in step 2.
Chrysler is not a part of Nissan. Chrysler is a part of Daimler-Chrysler which is the Mercedes-Benz company. Chrysler also makes Dodge, Jeep, Mitsubishi, and formerly Plymouth and Eagle.
to improve on answer....He was right its Chrysler is not apart of Nissan. no longer apart of Diamler-Benz Chrysler did make Plymouth and eagle...Discountinued.....As far as Mitsubishi goes they made parts for Chrysler and Bodies. Now its just chrysler, Dodge and Jeep. Mitsu....still makes cars and parts for Chrysler...
Chrysler is now part of Fiat.
Where is the air intake temperature sensor in a 1998 Plymouth breeze?
its by the under side of the radiator
Where is the engine oil drain plug on a 2007 Chrysler Pacifica?
It is on the back side of the oil pan. Use a thirteen mm wrench to remove it.
2005 Chrysler 300 what does the red lightning bolt warning light on dash mean?
Thr engine computer has detected a problem and set a code for the electronic throttle system.
What is the cylinder configuration of a 2007 Chrysler 300 2.7 engine?
Pass side 1-3-5
driver side 2-4-6
firing order 1-2-3-4-5-6
How do you reset the anti theft system on a 1998 Chrysler Town and Country Lxi?
Lock and unlock the passenger side front door using the key three times.
Attempt to start the engine.
If it doesn't start:
Attach a battery charger and turn it on.
Put key in ignition and turn to on/run position.
Wait 10 hours without touching anything. You can go do something else during this time.
Turn key to off, then start engine.
