0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
What would cause the oil pressure gAUge to go up and down 2002 ram 1500 5.9l?
Replace the oil sender switch, its behind the right side cylinder head. Its alittle hard to reach, suggest buying a new one and matching a socket size to it.A socket and ratchet with exstention should get you to it.
What transmission fluid does a Dodge Ram 2500 use?
The automatics use ATF+4. The manual transmissions vary depending on the year.
What size tires 2004 Dodge ram 1500?
I have an 04 1500 and it came factory 265/70/17 tires.
If it has 20'' wheels it's P275/55R20 as standard, and P275/60R20 as the optional.
gauges don t work truck wont start
Yes as long as the bolt pattern on the new wheel is the same
What is the towing capacity of a 2003 Ram 1500 Hemi Quad Cab long bed 4x4?
Look in the owners manual.
How hard is it to put a 360 dodge out of a motorhome in to a 1967 dodge charger?
if your 67 had a 318 engine in it from the factory the 360 should bolt right in.
How do you add transmission oil to 1998 dodge ram 1500?
On the automatic it goes down the dipstick tube.
On the automatic it goes down the dipstick tube.
Where is the sensor located that causes error code P0720 on a 99 dodge PU with AT and 4 wheel drive?
Two wire sensor, driver side rear of the transmission.
Where is bank1 upstream O2 sensor on 1999 dodge ram van 1500 318?
It is the one screwed into the front of the catalytic converter.
It is the one screwed into the front of the catalytic converter.
Plymouth voyager brake lights stay on even when van is off what could be causing this?
check for a bad or misadjusted stop light switch at the upper end of the brake pedal under dash area
What vehicles have 5 on 6.5 lug bolt pattern?
Many Landrovers have a 5 on 6.5 pattern. Most 90's discoveries will have this pattern.
How do you put in a 2004 dodge ram 2500 water pump?
Will the rad need to be removed to make room?,or is it as easy as it looks by removing a couple bolts ? Will the rad need to be removed to make room?,or is it as easy as it looks by removing a couple bolts ? Will the rad need to be removed to make room?,or is it as easy as it looks by removing a couple bolts ?
Where is the fuel pump on a dodge ram B250 van?
Older one out side the gas tank.New one inside gas tank
Where is neutral switch on 97 dodge ram pick up 2500?
THE NEUTRAL SWITCH ON A 97 DODGE 2500 IS LOCATED ON THE DRIVER SIDE OF THE TRANSMISSION TOWARD THE MIDDLE JUST ABOVE THE OIL PAN. THERE WILL BE THREE WIRES GOING TO IT, WITH A BLACK PLUG. THE NEUTRAL SWITCH ON A 97 DODGE 2500 IS LOCATED ON THE DRIVER SIDE OF THE TRANSMISSION TOWARD THE MIDDLE JUST ABOVE THE OIL PAN. THERE WILL BE THREE WIRES GOING TO IT, WITH A BLACK PLUG. THE NEUTRAL SWITCH ON A 97 DODGE 2500 IS LOCATED ON THE DRIVER SIDE OF THE TRANSMISSION TOWARD THE MIDDLE JUST ABOVE THE OIL PAN. THERE WILL BE THREE WIRES GOING TO IT, WITH A BLACK PLUG. THE NEUTRAL SWITCH ON A 97 DODGE 2500 IS LOCATED ON THE DRIVER SIDE OF THE TRANSMISSION TOWARD THE MIDDLE JUST ABOVE THE OIL PAN. THERE WILL BE THREE WIRES GOING TO IT, WITH A BLACK PLUG.
05 Dodge pickup 4x4 1500 front cv joint removal?
Just did this literally two days ago. It's not that bad really. Once you get the rotor off just undo the bolts holding the upper control ARM and the tie rod (one bolt each). You mite need an air hammer to get that axle loose tho. Good luck
How do you install a drop hitch on a 2004 dodge ram 1500?
Install a receiver on the truck and then purchase a drop hitch of your choice. Receiver will cost you around $125 and the drop hitch around $35 with ball. A receiver type hitch is the only way to go. Towing off the bumper is a bad idea.
Where is the vacuum switch located on a 1998 dodge ram four wheel drive?
It is on the top of the transfer case.
Sounds like a faulty btsi solenoid (brake transmission shift interlock). Key on push on the brake and listen for a click by the shifter. If no click try wiggling the shifter and pushing forward.
How do you reset The malfunction light?
Take the Positive and Negative leads off the batterys for about 2 minutes. Than reinstall, and blamo your back to normal, I know this to work from experience.
