0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
What causes your dodge diesel to lose power then pick up when it downshifts?
That would be the power curve accompanied by turbo lag and tall gears, once your truck downshifts the RPMS are higher, and more favorably situated in the power band, and this rush of exhaust gases quickly spools the turbo up creating more boost and a denser charge coming into the combustion chamber equaling more power and "pick up"
What is the labor time to replace water pump 2004 dodge caravan?
I did mine, first time on this vehicle, in an hour .
How do you turn on the door lock horn chirp on 2001 dodge ram?
you double click the lock or check your horn
Does '09 dodge ram heavy duty big horn 6.7 diesel have Allison transmission?
No. Ram has never offered an Allison transmission. The options in 2009 were 68RFE Chrysler transmission and as68rc Aisian Seiki transmission.
What is the serpentine belt routing for a 2004 dodge ram 4.7L with ac?
Open the hood and there will be a sticker by the radiator (right above the grill) showing belt routing.
Where is Dodge Ram actuator located?
Remove the 3 screws that hold the blower motor and remove. You will see the actuator up in where you remover the motor. It is a foam covered flaper door. It is about 6 nches by 3.5 inches.
What causes 2004 Dodge Ram 1500 SLT to shake and pull to the left when putting on breaks?
you may have a warped rotor which will cause the "shake" and the pulling to the left you have a brake caliper may be frozen not allowing the brake to grab or your pads have worn uneven due to the warped rotor. If the truck is pulling to the left check the right side for the wear. If the pads are thinner than the left then have the rotor turned at your local auto parts store before replacing your brakes
Where is 1998 Dodge Ram 2500 Cummins diesel coolant drain plug location?
Lower driver side of the radiator.
Where do you find the fuse box on an astra 16 sxi 02 model?
just by the drivers knee there is a little box for putting bits in, this box is held in by four quarter turn screws, once released this box will come out to expose the fuse box, at the bottom of the fuse box is a clip which when released will allow the fuse box to swing down.
How do you replace the head lamp bulb on a 1994 Ford Ranger?
(1) Open the hood; (2)unscrew the retainer from the back of the headlight; (3)pull the bulb socket out of the headlight assembly; (4)pull out the housing clips and remove the housing from the grill. NOTE:on later models there only 2 clips that are pulled up to release the headlight housing - one on each side. After pulling them up, simply move the headlamp housing forward from the vehicle. It may also be necessary to remove the headlight housing to change the bulb. - Haynes Repair Manual #36071; 1993-2005 Ford Ranger Pickups.
Under the carpet on the passenger side of my 2003 dodge ram 2500 is soaking wet why?
The most prosaic explanation is that something spilled there and the water soaked through the carpet.
Where is the heater core on a 1992 Dodge Dakota?
Open the hood on your truck, look at the back firewall. You will see two water hoses sicking out. That is where your heater core is located. As for getting it out through the dash? Good luck.
How many quarts of transmission fuild does a 1999 dodge ram truck hold?
Gas, automatic holds about 12 quarts when empty.
Diesel auto holds about 16
Why does your dodge ram 1500 uses a lot of antifreeze?
Could be a few things.
Does it leak antifreeze? if so, fix the part that leaks.
If not, you could have coolant mixing with oil inside the engine, which burns it.
check your spark plugs. If they are white, you are probably burning antifreeze - fix immediately.
your exhaust will smell "sweet" as well if you are burning antifreeze.
Turn the key from off to on, the quickly off on off on off on the codes should show up in odometer spot
Why wont your 5.9 cummins start if its not plugged in?
You need to have the intake heater grid tested.
Where is the 4 wheel drive actuator in a dodge truck?
The actuator is on the front axle towards the passager side. It has 2 vacume hoses comming off of it.
Sounds like you've got a bad driveshaft.
How do you change the camshaft sensor on a Vectra 1.8 16v r reg?
Remove the ignition cable cover from top of engine,then detach the wiring plug from the sensor. Remove the front cambelt cover and you can see the single bolt which holds the sensor in place. Undo this and pull the sensor out upwards.Refit in reverse order,do not overtighten the sensor bolt.(torque 6Nm)
That was a great help. I just completed this procedure myself as an absolute novice but for a 2001 Vectra 2.2 l the procedure is slightly more involved. The cam sensor (Part no 90458252 made by Siemens) can be replaced as above but in order to remove the cambelt cover you need to detach the sub frame that hold up the engine.
Place a jack underneath the engine sump with a block of wood and jack up the engine several turns (Don't lift the entire car!). This will remove the pressure off the sub frame.
The sub frame is bolted with 3 bolts to the engine through the Cambelt cover. Remove these bolts. Take it slowly and adjust the jack if pressure on the bolts is high.
The cambelt cover itself is attached by two bolds as far as I can see and a clip on the top. Remove these. This will allow you to pull back the cambelt cover far enough to access a small bolt that holds the cam sensor in place.
Undo this bolt. Now the cam sensor can be pulled up from the top. Once the cam sensor is removed you can undo the wiring. This is different from the above description because the plug is help in place by a spring clip. Also make sure to attach the plug and locking clip before you insert the cam sensor.
