answersLogoWhite

0

🚗

Dodge Ram

The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.

13,744 Questions

What is the real horsepower of a 1988 mustang?

The horsepower on the 1988 Mustang was # 90 horsepower 2.3 liter engine # 225 horsepower 5.0 liter engine

How do you idenify the oil pan?

It is the big medal pan that is bolted to the very bottom of the engine.

The upstairs blow the cool air at 70F down stair at 60F and also upstairs keep running all the time What is the possible to cause this problem Thanks?

I'm taking for granted that you know that cool air is heavier than warm air so it will naturally go to a lower level thanwram air and thusly displace warm air upward The problem you havedescribed is a very common one , indeed. In most homes, the thermostat is located in the upper level of the house. It places the order for your air conditioner to supply cool air and maintains this order until the temperature around it is satisfied. Because the air goes under the warm air , it races downward by any path that is available to it. Your options are to block its path by installing a door at the stairways or to have the thermostat at it's lowest point. The latter option is really not feasible because your downstairs will be the desired temperature and the upstairs will be too hot. Your best option is to block the path of the air flow downstairs and shutting off all or most of the vent outlets downstairs so that the majority of the cold air is routed to and remains upstairs as long as possible. you could also insulate your floor to isolate air filtration although this would be expensive and a bit on the "overkill" side. Hope this has been of some help. Signed, Been there...done that.

What would cause a low power condition on a Cummins 5.9L ISB engine when under load?

A few things can cause this problem, stuck open wastegate, excessive blow-by or an air leak on one of your intake hoses.

What are 5 pros of being an auto mechanic?

You can always find a job.

You can repair your own vehicles and save money.

You can do repairs on the side to earn extra cash.

You will know if you are being overcharged for repairs done by a garage.

You will have friends you never knew you had.

How do you change the light bulb and or push in lens on the headliner of a 2003 dodge ram pickup truck?

2003 Dodge Ram 1500 dome, trunk or cargo area lamp replacement procedure: Purchase the correct replacement dome, trunk or cargo area light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information and full light bulb part numbers list. Then consult your owner's manual for the dome, trunk or cargo area light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations.

Where is the oil sending unit on a 1990 2.5 liter s10?

I have an 87 2.5L and the sending unit is located just in front of the distributor and perpendicular to the cylinders. It does however aim just a little towards the back of the truck and the electrical connector slides right on and off. It does not have a locking tab on the connector. My specific version has three prongs on it. Hope this helps!

Have you had any issues with the caliper on your Dodge?

The Dodge Caravan and Dodge Ram have reportedly had issues with the caliper needing to be replaced. This can usually be done yourself and step by step instructions found on the internet by doing a Google search.

Where is the oil sending unit on a 2000 Ram 2500?

It Depends on the engine

The 5.9 or 5.2 V8 it is on the rear below the distributor above the transmission bell-housing

On the Diesel it is mounted on or near the oil filter.

How do you replace the right rear blinker-brake light bulb on a 2000 Dodge Ram 1500 pick up truck?

Put your tailgate down and take the screws off on the inside of the taillight. The screws are Torx screws, so you will need Torx head screw driver. Then just give it a tug and the cover will pop right off. You will be able to change out the bulb.

Note: Torx srews are different from Philips or flat-head screws so they require a Torx screw driver which has a star-shaped head.

Where is the Throttle Position Sensor located in a 1999 24 valve cummins turbo diesel?

It is on the back side of the unit that the cables hook to on the front driver side of the engine.

It is on the back side of the unit that the cables hook to on the front driver side of the engine.