Where is the voltage regulator located on a 1984 dodge ram?
Inside the rear of the alternator
It is on the firewall.
What is the highest amount of horsepower a diesel engine can produce?
dimitri millars lb7 duramax turbo diesel in his Chevy truck put down 1,702 hp on the dyno. but huge diesels can have past a million hp
Dodge ram 1500 5.9l multiple cylinder misfire?
check spark plugs cap and rotor, and ignition coil. check gaps on spark plugs.check
for blue fire getting through plug wires.if
so check egr
valve could be stuck open. check for intake manifold leaks. if egr
is good and no leaks are found check fuel pressure from pump. if fuel pump and filter are good check each injector for operation. they should open when interjized.
Can you put a 1995 dodge 3500 van transmission into your 2001 1500 Ram Truck?
It may bolt in but it will not shift. The 1995 is hydraulic, while the 2001 is electronically controlled.
How do you set the timing on a 1997 dodge 2500 with a 318?
The distributor is set to 0 deg. Align the rotor to the line in the pickup plate in the distributor when the crank is at tdc. The dist. is then fine tuned with a scan tool.
How do you replace the distributor cap and rotor on a 1998 Toyota RAV4?
there is no distributor on a 98 rav. therefore no cap or rotor. replace the plugs and wires and the tuneup is done
Where is the oil pressure sending unit on 1989 Toyota Supra?
It should be on the passenger side of the engine in front of the oil filter. Should look something like this http://info.rockauto.com/SMP/SMPDetail3.html?PS186.html Hope This Helps.
What is the purpose of the bypass hose on a dodge ram 5.7Litter 1994?
To allow coolant circulation through the engine when the thermostat is closed.
How did they get the power in the 2009 5.7 hemi versus the 2004 5.7 hemi?
The newer hemi, is more powerful because it has variable valve timing. Different engine managment systems, fuel system, and camshaft design.
The engine can advance the timing and retard the timing based on the demand of the driver.
What size wrenches are needed to change a starter on a 2000 Dodge pickup 1500 4x4?
The bolts on the starter take a 5/8 inch wrench. The battery cable is a 13mm wrench.
The piece you describe could be the piece that goes on the backside of the panel you removed to install the keyless entry (in front of driver's knees) It is used to protect knees in an accident.
What inch is a 85 big wheel wheels?
I got that snitz on my g6. They big as all dookey bread. old money.
Where is ecu on 1990 dodge ram charger located?
It is located on the driver side fender right behind the battery.
Why did my Tahoe quit running and it wont start?
I didn't realize it was posting the question, I thought it was searching the database.
I was driving along and my 98 Chevy Tahoe just quite. I assume it is the fuel pump and was looking for related discussions.
Do you have to use push rod guide plates when using roller rockers?
To my understanding, the answer is "yes" according to http://www.compcams.com/Technical/Instructions/Files/151.pdf. Comp state guideplates must be used with these type rockers.
Check fuel pressure, and check for codes. You will need a scan tool to read the cam and crank sensors while cranking, to see if they are working.