answersLogoWhite

0

Ford Bronco XLT

The Bronco XLT is one of the three models available for the 1996 Ford Bronco; the other two were XL and Eddie Bauer. The Bronco XLT features anti-lock brake system, a full-size spare tire and a driver airbag.

2,925 Questions

Will a frame from a 79 bronco fit a 79 f150 short box?

nope, but if you're good with a welder, you can put the truck cab on the bronco frame, make a short flatbed, and have a ridiculously short half-ton pickup.

What is the fuel tank capacity on a manufacturer stocked 1987 Ford Bronco II?

25 Gal.

that's the standard size tank but they only accept 23 gallons sometimes less because the inlet has no down flow it sits horizontal to the tank.

What is the lug pattern on a 1996 ford bronco?

The bolt pattern on a Ford Bronco or 1/2 truck (F150) is 5 on 5.5 (5/5.5).

What is the gear ratio on an 89 bronco fwd full floating axle tag on door says 19?

http://www.off-road.com/trucks4x4/bigbroncos.tech/Bronco-Rear-Axle-Codes-and-Ratios/ArticleStandard/Article/detail/304644

your gear ratio is 3.55

How do you replace a heater core on a 1985 Chrysler Fifth Ave?

The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

Will a ford 460 fit in 1985 bronco engine bay?

Yes, this is a common swap as it is a much larger engine than the 351 V8 that came in Broncos, especially since the front of a Bronco is identical to the front of the F-series trucks the 460 came in.

A donor truck with a 460 in it should have everything needed for a swap. If not, several sites sell 460 conversion kits.

What is a sharp smell?

A sharp smell aroma. Is one that is strong or makes your eyes water!

How can you override a kill switch on a 1999 Chevy Silverado?

I had a problem with my 1999 silverado bacause of a faulty fuel pump it was causing my truck to cut off after running for a minute or two. After getting under the truck and listening to the fuel pump whine I was then able to determine that the pump was in need of replacement. The truck runs great now that I have replaced the pump. I didn't know what to do for my truck to get it running right so I replaced ignition coils, control modules, and even straight wired my ignition so the relay's wouldn't cause my truck not to crank properly.

How do you change coolant sensor 96 firebird?

the cool sensor is located under the throttle boby on the front of the engine. disconect the wiring harness and use a box wrench (19mm) to remove it

What is the lug pattern for 1990 ford bronco?

is it a full size or mid size... full size is a 5x5.5 i dont know the mid size(bronco 2)

The gas gauge on your 1984 300 ZX doesn't work how do you fix it the rest of the panel works just fine?

it could be one of a couple things. First, check the connections to the gauge at the back of the cluster bezel. Second, it could be the float on your fuel pump might be stuck or the sending unit might be damaged. Lastly, if it is not any of these you should just replace the gauge with an after market one, if you are concerned about making it look stock/original, go to a junk yard and get a new gauge or cluster bezel, if they try to charge you to much at the junk yard, eBay it.