answersLogoWhite

0

Ford Falcon

Manufactured between 1960 and 1970, the Ford Falcon was a huge success for Ford, surpassing its rival compacts from General Motors and Chrysler. It was produced in various body styles, such as 2-door and 4-door sedans.

937 Questions

How to start 1996 el falcon Falcon el wont start?

Firstly, check that the interior roof lamp is working. The smartlock system works off the same circuit, and if the fuse is blown, the car will not have any spark. If that fails to be the issue, test the coil, distributor individually. Coil may have hairline crack, ignition module of distributor may be at fault.

Ford Falcon air conditioning ticking sound?

depends on where the ticking sound is coming from, if it inside the car and related to fan speed, the most likely cause is a leaf stuck in the fan, which is located on passengers side foot well, the easiest way to fix is start car, turn vent control from fresh to resirc, this allows the resirc flap to open in passenger foot well, get an air blower into fan housing and blow, usually repeating this procedure several times will dislodge leaf. If the noise is in the engine bay, its the compressor, from past experience if ac working ok, leave it, due to price of new compressor,

What does inhibitor switch do?

Inhibitor switch reduces engine power to avoid shock while automatic transmission changing gears

Where is the fuel pump on a 1961 Ford Falcon?

It is bolted to the side of the engine block next to the ignition coil.

What is the gas mileage of a 98 Pontiac Sunfire?

It should be pretty darned good!

My '96, with 199,000 on the odometer,

does right around 28-32 with the AC off.

Naturally it drops a couple MPG with the AC on.

Bear in mind, that your mileage may vary ;)

Keeping your engine in good tune, and watching

your tires for proper inflation will make a big

difference.

FriPilot

How do you change front indicators BA falcon?

To change the front indicator lights on a BA Falcon one must turn the wheel inward in order to access the front of the splash shield. The lower three screws can now be removed and the bulb can be changed.

How valuible is a 1965 Ford Falcon futura convertable?

1-depends on the condition, body panels, top, floor boards, 2-is it a "driver" or show car, 3-what options it came with, AC, PB, radio, trim package, engine size, PS, etc..

I've seen them go for any where's from $1500, needs work, to 12,500, condition #3 car, according to the above .

Check out this site also,

http://www.nadaguides.com/Classic-Cars

92 ford falcon you just changed the radiator and thermostat and filled with coolant as you broke down due to over heating now your car is blowing black smoke and the enging is shaking?

Overheated engines often cause the head to warp, resulting in a blown headgasket. If the engine blows out the coolant, you have a bad head gasket/warped head. If you're getting coolant in the oil, same thing. If one or two cylinders have very low compression, same thing.

It's not news that anyone wants to hear, but I'd check that first since it's a very common condition after an engine overheats.

What is the ticking noise in your Ford Falcon behind the washer tank?

it's not the leaves stuck in the heater fan by any chance when the fan is working. and i don't mean the fan in the engine bay. im refering to the fan in the cabin behind the glove box. usually leaves get sucked in and they clog up the fan. either that or i know the cruise control unit is underneath the washer tank. you have to remove the washer tank to see it. never heard them tick though.

Where is transmission dipstick ina 96 el Ford Falcon?

To my surprise, there isn't one!

These "new" transmissions are not meant to ever need topping up and the hydraulic fluid is not meant to ever break down.

However, if there is a leak, there is a top up "bolt" or plug located on the top of the transmission pan (underneath the car). The fluid level must be level with the plug hole when the engine is warm (running from cold for no more than four minutes) but NOT hot as the fluid will overflow through the hole and you won't be able to get the correct level.

Best of luck!

Where is the remote control sensor in a XH falcon ute?

i think your refering to the BCM or Body Control Module. it's located behind the dash near the hand brake.

Do they make a Ford Falcon Hot Wheels car?

Yes they do. I just bought on. It's a 1964 Falcon Sprint. Blue with a black strip. It is their 40th anniversary edition.

What frame will fit under a 62 Ford Falcon?

Frame is part of the body on old Falcons and is held together by welded cross members. You have to repair it with patch panels.

Where is the transmission under the bonnet located to fill with transmission fluid?

Some later model cars have gone away from auto dipsticks. You can usually find the "plug" situated at the transmission. Ford Falcons have them situated on the right hand side of the transmission nestled behind the exhaust. you need a 16mm spanner or a 16 mm 3/8" drive socket with a 6 inch extension to get in from the side.

Where is the temp sensor on a 1960 model ford 144 cubic inch engine located?

It is locaed on the rear of the engine block, below the valve cover, close to the firewall on the driver's side. It's the only thing back there that's screwed into the block with a wire attached, so it's easy to spot.

Can anyone tell me why my brake lights do not work on my 2000 falcon I have checked the bulbs and fuses.?

The brake lights propbably don't work because the brake light switch (found at the brake pedal) has failed. A problem with falcons all the way through. To check them, disconnect the switch wiring. get a length of wire with a 10A fuse in line with it. basically what your trying to do is bypass the switch. if the brake lights come on when you complet the circuit, the switch will be the fault.

How do you loosen the drive belt for an alternator change au series111?

Tension pulleyAs you look at the motor from the front - on the top right had side of the belt (opposite side to the power steer) you will notice a small pulley that has a bolt head only on it - This is the pretentioner pulley, you will need to get a shifter or similar to grip this, pull down then carefully while holding the tension, remove belt.

Refitting belt is opposite to this how do I instal the belt

How do you reset a Ford Falcon forte audio system CD player when it says err?

How do you reset a ford falcon forte audio system CD player when it says err?

A: When the display shows a flashing "err" you would have entered an incorrect code three times - this method should fix it.

Note: You'll still need the correct radio security code...

  • Switch the ignition to accessorory mode (first stop), and LEAVE IT until it changes to "code"- this can take anything from 20-80 minutes.
  • Enter the radio security code.
  • Worked for me!
Good luck!

How do you change automatic transmission fluid?

Depends on the vehicle-some have a plug at the transmission pan (NO FILTER REPLACEMENT REQUIRED) Others and most common - youhave to drop the transmission pan to access the filter Change filter clean, pan, magnet, replace pan gasket.

How do you remove drivers seat from 03 BA Falcon?

remove the plastic trim covering the 4 mount points, 2 front / 2 rear

the plastic trim is clipped on, so requires motivation to remove

(be careful for the front middle, as mine snapped away from the clip & i had to use epoxy to glue it back together)

remove the 4 T50 torx bolts

remove the 3 wiring connectors at the base

use the knob on the side to move the seatback forward as far as possible

lift the seat out :)

How do you fix remote central locking on a peugeot 206?

depends on the prob but most likely with 206 replace the central locking motors