0
GMC Envoy
The GMC Envoy is a mid-sized sports utility vehicle (SUV) from the GMC brand of General Motors. It was launched as a luxury counterpart of the GMC Jimmy in 1998. The car features a front engine and four/rear-wheel drive.
1,161 Questions
Can you grease an 2002 envoy front sway bar links?
They do not have grease fittings on the factory bushings or end links but after market greaseable polyurethane bushings and end links are out there at your local auto supply or Off Road store.
The soft bushings and non grease end links that are installed from the factory are a bit too soft anyway and should be changed out.
www.trailvoy.com - all the answers for your Trailblazer from true enthusiasts!
How do you replace the hub assembly on a 2002 Montana AWD?
you must first remove the brake caliper and rotor, remove the large axel retaining nut (usually a 36mm. deep socket required), gently tap axel back making sure not to damage the threads, disconnect ABS sensor wiring harness at all retaining points, remove hub retaining bolts (on inner side of steering knuckle). Hub assy. is usually a press fit but with a small hammer and some patience it will come out. Make sure to thoroughly clean with a file and wire brush where the hub will contact and insert into steering knuckle....reverse removal and torque ALL fasteners.....not sure without lookig them up, but your parts supplier should have this info availible.
Where can one purchase a cheap GMC Envoy Denali?
There are a few places to purchase inexpensive GMC Envoy Denalis. One great place to start is a local used car dealership, but be sure to call beforehand to make sure they have one in stock.
How do you assemble the headlight on a gmc envoy?
Check out the link - All questions can be answered here! It's FREE because we are enthusiasts!
What is a 14R3 axxess key used for?
I have a spare key and i think it's for my old motorcycle.the was a 2002 suzuli gsxr 750. the key says axxess+14r3 on it.could this key be the one for that bike? Thank you. RICK hey i just found a key that is a axxess+14r2 and i dont think it went to a bike but i dont know what they went to.
How do you repair a 1993 Lincoln Town Car trunk latch that will not close completely?
Two options that I had to do to fix mine.
First Option - Remove the part of the electric motor that is in the trunk. - Get some test leads and make the mechanism turn all the way down to the bottom of the stroke using the cars battery. When you touch the leads to the batter on the connecting clip, the motor will move the mechanism up or down. If it goes the wrong way, reverse the wires - Use your key to unlock the trunk until you can do the Second Option.
Second Option - Go to a junk yard and get all the parts from a dead Town Car. That means everything from the trunk lid (switch, solenoid, etc...) and from the inside of the trunk. You won't need the lock because you can still use the old one. - Replace your broken stuff with the stuff from the junk yard. Cost - about $10 - $15. If you go to a Lincoln dealer, be prepared to pay over $150.
Tools you will need: Small sockets, maybe a screw driver, and test leads.If the only problem is not closing fully there are a couple of other options.One is to loosen the bolts holding the lower latch in place and adjusting them to their limits. They should have adjustment play side-to-side and up-and-down.Another action that has worked for me, especially when installing a lower latch from another vehicle, is to turn the threaded latch rod (worm gear) up or down as required before installation/reinstallation. This establishes a new start point for the travel of the lower latch during closure. This is a trial and error procedure as the two latches must also hook up for closure..By the way, a cadillac latch will also work.
MY MOTOR WAS GOOD< SWITCH WAS BAD..........
I have a 93 Town with same issue. After troubleshooting it I found the motor was fine but the switch on the motor assembly was the problem. Part Nr. 16601101. I did some searching on the internet but could not locate a replacement. I drilled out the brass rivets, opened it up and cleaned all the contacts. It was easy to see the problem -17 years of dust/dirt/wear. It's now working again. Not sure how long it will last. Some of the contact strips inside were a bit worn. I'll have to hunt up a new switch next time it goes.
Which fuse is for the power windows on a 1993 buick lesabre?
Its the Bulky looking ones. Number 3. there a chromish color looks more like aluminum.
Where oil is coming from in 2002 envoy engine?
Mine was leaking from the Oil Sensor/Oil Switch. It can be found right above the oil filter on the IL6. I used a 1-1/16 deep socket to remove it.
Why does 05 envoy someimes act as if it is running out of fuel while driving?
I had the same problem, most of the time at low speeds. I replaced the upstream (before catalytic converter) oxygen sensor and the problem was fixed. you might want to have auto zone do a free diagnostic code check to find out exactly which o2 sensor it is.
Where is the starter on 2004 gmc truck?
It is on the passenger side, Bottom rear side corner of the engine.
Envoy ambient air temperature sensor location?
Behind the grill top drivers side. Little grey thing with a green connector.
How do you replace sway bar links on a 2001 Chevy Tracker?
Couldn`t be any simpler.Just requires a wrench 13mm maybe don`t recall and a socket and ratchet same size and vise grips.The links are avaible separetly or as a kit.Get the kit as I fixed 1 side then other side broke 4 weeks later.Just loosen top bolt then bottom one.You may have to grip broken lower end with vise grips to stop turning.Then just reassemble.Very simple and a world of difference no clunks
Easy access over tire if you turn hard right for left side and left for right side.
Where is the neutral safety switch located on a 2004 Envoy?
The neutral safety switch is located, on your 2004 Chevrolet envoy, on the side of the transmission next to the shifting linkage. The safety switch also has a fuse in the fuse box.
What kind of spark plugs can be used in a 2002 gmc envoy?
For the Inline 6 cyl - 4200 vortec all aluminum LL8 engine
AC DELCO Iridium. #41-103
The only plug for these trucks that has been 100% reliable
If you don't have a manual how do you program garage door opener for 2003 Kia Sedona?
Call a dealer, someone in the service/parts dept. should know how to do it. If you have a HomeLink system (built into overhead console), you can find programming instructions at their website: http://www.homelink.com/training/train.taf
Where is the location of the secondary air injection on a 2004 trailblazer?
Its under the car right under the drivers seat.
how do we fix/replace/repair it
Where is low side port on 2002 gmc envoy air conditioner?
The low pressure port of the A/C system usually has a blue or black dust cap and is located either on the larger diameter metal tubing typically found between the evaporator and compressor, on the compressor itself, or on the receiver drier (orifice tube systems only). The high pressure service port is found either on the smaller diameter tubing or the compressor and is larger in diameter. Only charge through the low pressure port. There is a web site with a lot of help full information about your auto a/c system check out the link below.
How do you change blower motor resistor on 2002 trailblazer?
The blower motor resistor is easily accessed through the glove box in combination with under the passenger side floor area.
Remove the kick plate on the bottom of the dash. Pull the tab of the glove box to the side to allow the glove box to fall forward out of the way.
Follow the wires from the blower motor to the spot on the air duct where you see two screws holding the module in place on the air duct. Remove the screws and install the new one. Unplug the end at the blower motor. Plug in the new one. Should take about 15 minutes.
We have pictures and a full how to on our enthusiasts website
www.trailvoy.com
