0
GMC Sierra
The GMC Sierra is the latest series of full-size pickup trucks from the American car builder General Motors. The GMC Sierra is known for its luxurious interior, unique grille and four-wheel steering system.
2,525 Questions
If you get trouble codes 0740 0753 0758 0785 and 1860 what can cause all of these codes?
Before assuming its a trans problem search online. Gm put out a S/B in 2005 stating a problem with the electrical portion of the ignition switch. The switch fails and intemitently looses power to trans circuit causing numerous trans codes.
What make transmission is in a 1995 gmc sierra 1500?
typically it would have a 4l60e unless a hd. option truck or bib block the there is a chance it might be a 4l80e
What is does the code P0651 reads on a 2003 Gmc Sierra?
DTC P0651 Sensor Reference Voltage "B" Circuit/Open DTC P0651 Circuit Description The engine control module (ECM) provides 5-volts to the following sensors: The boost sensor The accelerator pedal position (APP) sensor 2 The exhaust gas recirculation (EGR) vacuum sensor, if applicable. The barometric pressure (BARO) sensor. The air conditioning (A/C) refrigerant pressure
Where is the oil sending unit switch on a 1997 GMC K1500 XCA with a 5.7 liter engine?
It is screewed into the top of the engine block right behind the distributor. It is hard to see and to get to.
How to reset the air bag light on 2005 Chevrolet Silverado?
Here are opinions and answers from FAQ Farmers:
- (BEST ANSWER) This tells you that the air bag system may not deploy in a collision. I suggest getting car to a dealer for inspection. This could be covered under warranty depending on age and mileage of the car.
- If you need to order safety airbags do not order them brand new because they are way to expensive.
(Additional entries may or may not apply to your specific vehicle.)
- In my auto, the air bag light comes on because the ignition switch is worn and not making good contact. Call the service manager at your local dealer. You could have a serious problem.
- It may also be a faulty SRS computer which could cause the airbag to deploy without cause. This would be true if your vehicle is a Honda civic and was a recalled item due to the matter.
- Do you have an airbag in your steering wheel? Does your horn work? If you answer yes then no it may be your clockspring in your steering wheel, which will cost about $100 or so to fix and you probably want to go to the dealership to fix it.
- Whenever a airbag light is on the system is disabled and will not function at all
- We recently had this problem on our 2002 Ranger. I took it to the Ford dealer and they said it was a problem with the driver's seatbelt pre-tensioner, and that it meant the airbag system was turned off and would not deploy in the case of any acccident. They had to remove the driver's seat to repair the probem, but now it works fine. As the vehicle was out of warranty, it cost $275 to repair, but hey, what's the price of safety?
- When the air bag light comes on, you should drive directly to the dealer and get it fixed. It may not work in an accident, or it explode when you don't need it too.
- Just last night this issue occurred with my 1995 Nissan 200sx. I thought that my battery was about to die and bought a new one. I installed the new battery and as an indication that something was still obvioiusly wrong my lights continued to dim and the airbag liht came on. Low and behold, my alternator needed to be replaced and was affecting my electrical system. So we are placing a new alternator in the car today to correct this issue
What is the approximate cost of the Power Control Module PCM for a 95 Intrepid?
I have heard new modules can run in the hundreds. I typically go to a junk yard and find a car that has taken some physical damage (preferably rear end damage) and pull one out of there. $20 from my local junkyard near St. Louis. If you pull yours, get the part number off of it so you can compare. Also, google it to see if any other cars made during that time frame also used the same PCM. It could give you a much greater variety of vehicles to pull one out of. Goog luck!
AnswerI have a 2001 Intrepid and I was told by the dealer that this replacement would run about $700. The problem with the PCM (Power Control Module) is that it has to be programed to your car for it to work. Even if you buy one some where else, you will have to have someone who has the correct software, program it to your VIN number and current mileage. I found a place online (www.allcomputerresources.com) where you can order the part for about $250 and give them your VIN, etc. and they will program the part before it is shipped to you. When you replace it, you can send them back the old one and then they will provide a lifetime warranty on the one you bought.What is the bolt pattern of a 2001 GMC Serria?
Question is too vague since there are MANY Bolt patterns just on the engine.
SPECIFIC questions can allow specific answers.
Where is the cabin air filter located on an 2005 sierra 1500?
Purchase a Purolator Cabin Filter. It comes with complete instructions on replacing the filter.
How do you replace heater core for 99 Chevy Silverado 4.3?
Drain the radiator. Disconnect the heater hoses. Remove the screws holding the heater core case and remove the whole assembly. Remove the core and install the new on in the case. Reverse the procedure to finish the installation.
How do you repair a driver's side door handle on a 1995 GMC truck?
The how-to will depend on the year and model. It is also necessary to know whether it is an inside or outside door handle.
How do you reset service engine soon light 1994 GMC Sierra?
Usually pulling the battery for 15 minutes will clear it... but you'll also have to let the vehicle relearn it's idle procedure and such. If you haven't remedied the situation that caused the light to go on in the first place, it will likely come right back on though.
How do you reset the oil change message on 2000 gmc?
Try turnig the ignition switch to "on" position without starting engine and depress accelerator 6 times to the floor
How do you replace the headlight bulb located on a 2001 GMC Sierra?
onpen your hood twist the to metal bras on the top of the head light then pull out the two metal bars your headlight should fall out then undo the wire and twist the old build conter clockwise and pull out redo backwards to put back together
How do you replace knock sensor on 2004 gmc sierra 1500 with 5.3 litter motor?
You will need to take the upper intake off and there are two sensors underneath that. When you do this job make sure to replace the wiring harnesses as well.
