Hand Tools

Jewelers screwdrivers are very small examples of normal screwdrivers, watchmakers use them too.

That depends on the hammer and brand, most standard sized hammers are 1 foot. The reason behind this is your depth perception at this length is practically maximised therefore you can hit a target, such as a nail, nearly dead on from length.

A gimlet is a small pointed tools for marking or making holes in soft material like leather.

You have not told us for what bolt or nut ?. There will be almost a whole page of torque settings for that vehicle. Oilpan bolts may be as little as 12 while cylinder head bolts will be around 65-70 . We have no clue unless you name the bolt.

Torque wrenches depend on a modern generalisation of Hooke's Law. The deformation of an elastic material (even the steel out of which parts of a torque wrench are made) is proportional to the stress to which it is subjected.

When you use a torque wrench part of it follows the thing your turning and part of it does not. That part of the torque wrench twists slightly; it's being deformed and obeys Hooke's Law. The more twist, the more torque is being applied. The needle amplifies the amount of twist so that you can read the torque on the gauge.

i think it is not a compound machine

A monkey of course! Seriously, a monkey wrench would probably be used mostly by plumbers but anyone could use one as you would use an adjustable wrench. A monkey wrench came along with the original tool kit that came with your new model T or model A Ford way back when.

The inventors name as CHARLES MONCKY( that's where the name for the wrench came from

In its simplest forms and before there were any modern humans early technologies for obtaining and preparing foods improved our ancestor's diet, permitting the support of the large brains of modern humans as the brain evolved to help develop even better technologies to do those and many other things.

There's a world of difference. A torque wrench is a hand tool used to tighten fasteners to a preset torque specification. An impact wrench is a power tool which uses power actuated hammers to tighten a fastener for high torque applications.

The most common and cheapest is a fluid you can buy and paint it over the suspected crack which then shows up in outline. The other methods all employ X-ray or similar and are not generally available to the individual.

I think that one is a 3/8 Allen.

If the nut or bolt is really stuck, the impact will crack a conventional socket.

hexagon

115 Nm

It is a hacksaw, which is a narrow fine-toothed blade set in a frame.

These can be found at industrial tool stores and my experience has shown there are 2-3 of these in almost every community.

You press R1 or R2 and square button at the same time.

a place where crows go to get crunk and meet other crows

No, although having the extension makes it easier to inadvertently hold it crooked, which can make it less accurate.

A wrench in which One side has a 15 degree head and the other is 80 degree. Same size on the both usually. For bolts that arebhard turn in a ackward spot.

It's about 8 1/2 inches long with PxC in the middle-The manufacturer-made of forged steel with a grip from the head till about 1/2 inch from the end. Anyone that has seen a ratchet knows that it has the tip on the head where you can put a new piece or setting on; well on the original its just a hole with a specific size you can't switch out the setting or sizes. It was creud, but it worked at the time.

Stripper, crimper soldering iron, cutting pliers, a small hammer sometimes.

It looks like a cheap, tubular socket made out of stamped steel, often with a thick wire handle

No, it is a device for setting torque.