0
Honda Accord EX
Introduced in 1984 with a 1.8 liter engine, Honda Accord EX was marketed in New Zealand, Australia, Canada, and the US. The EX replaced the LX-I and SE-I models during the 1990s.
5,157 Questions
Where is the flasher relay on the 94 accord?
its right above the kick pannel on the drivers side there are 3 relays its the one on the far left
Squeak to 1998 accord front end?
i had the same issue for over a year and my mechanic could not find the problem since the sqeaking only happened while i drive but finally this week the problem got worst and it ended up being the front left ball joint being stiff. cheap repair, cost 100 dollars.
How do you retrieve your radio code with serial number?
Applies to HONDA factory radios:
First: Check the owner's manual. If you're lucky, sometimes the dealer or former owner will have written down the security code number somewhere in the manual (inside the front cover, or on the page that describes the radio operation, are favorite places). Also check the interior of the glove compartment - sometimes the dealer will affix a sticker containing the radios serial number and/or security code, there. IF NOT: You will need to retrieve the radio SERIAL NUMBER. On SOME radios you can do this by holding down both the number 1 and the number 6 buttons simultaneously as you turn the radio on. If you have one of those radios, the serial number will appear in the tuning window when you turn it on. IF NOT: You will need to loosen the radio and slide it far enough out of the dashboard in order to read the serial number off the plate that is affixed either on the back, or the bottom, of the radio case. When you have gotten the serial number - either call the Honda Customer Service 800 number, or stop by your local Honda dealer and give them the serial number and they should be able to give you the anti-theft security code for your radio. WRITE IT DOWN SOMEWHERE WHERE YOU WON"T FORGET IT! This will happen every time the battery is disconnected or goes dead.
How do you reattach the front driver's side window on a 1995 Lincoln Continental?
I had to do this recently when the glass came out of the track. First remove the trim panel and carefully lift out the glass. Then remove the two attachment pieces from the sissor arm. After taking careful measurements use some Goop or other glue to attach the two pieces to the glass. After the glue dries you can then carefully reinsert the glass into the door and attach it to the sissor. I waited a couple of days before operating the window to make sure the glue was dry. .
How do you change the 3rd brake light on a Honda Pilot?
If you look at the middle brake light, you'll notice two (2) notches on the left and right of the light. (This is looking at the brake light from the outside of the car, not the inside of the hatch.) Using a flathead screwdriver, pry the two screw covers off (they are plastic just like the rest of the brake light cover). Unscrew the screws and presto, you find the back to the light...you should be good from this point.
Additional Information:
Applies to: 2003-2008 Model Years only.
The two screw covers (notches mentioned above) are integrated into the brake light itself on each side but can be pried of using just fingers if needed exposing two (8 x 1") Phillips screws that, when backed out allow you to pull out the entire third brake light (CHMSL) assembly out of the roof spoiler. The bulb is a 921 incandescent bulb in a twist-lock socket. Since this bulb is inserted on a severe (almost 90degree) angle, a replacement incandescent or a 921 LED bulb that has a 360 degree pattern would work well, even if it is longer than the standard 921 bulb.
Where is the thermostat housing located on a 1999 Honda Accord LX with a 2.3l?
On the top end of the LOWER radiator hose. Under the air intake hose.
Show Vacuum routing 1998 Honda Accord?
Go to:
http://www1.autozone.com/addVehicleId,2404901/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c1528003a240
Scroll down to your year, this is for a 2.3L.
This link starts at http://www1.autozone.com/home.htm
Then "Repair Info"
Enjoy,
Bryon
What does the fast idle thermal valve for a Honda b16 engine work?
mechanical compensation for idle air flow to match a predesignated parmeter
How do you install a CD player in a 97 Honda accord?
You have to take out the arm rest there is a little plastic plate covering it two screws all youll need is a Philips screw driver and theres a metal protectan behind the radio I recommend going to Circuit City to get the dash kit and the harnessesI don't recommend cutting any wires at all.Answer You may also check the below link that may helps you:
http://www.installdr.com/InstallDocs/Honda/PDF/466037.pdf
How do you reset radio for Honda Accord?
Enter the 5 digit code into the radio using the presets. If you do not know the code click the link I will post and register your vehicle at the Honda Owners Link. There you can get the code for free.
Does a 1995 Honda Accord V6 have a timing belt or timing chain?
The 1995 Honda Accord V6 has a timing belt that must be changed every 90,000 miles. Also replace the cam belt driven water pump at the same time. Warning: This is an interference engine. If the belt breaks you will have serious internal engine damage.
How do you replace the rear motor mount on a 91 Honda Accord LX?
don't know but the salvage yard has you to pull them of your self so I guess you could remember the steps in the opposite order.
The rear motor mount is easily accessable with an aproximately 2 foot socket extention from the top of the engine behind the intake manifold. First, raise and support the car on jack stands. place a block of wood on a shop jack and gently support the motor under the oil pan. loosen the 3 bolts holding the mount to the frame. Then remove the the single bolt going through the center of the rubber bushing. It may be easiest to access that bolt from beneath the car.
How do you install an oil pan gasket?
Drain the oil then jack the car up and unbolt the the oil pan and take the old gasket off. Take a razor to it if there is still some pieces of gasket material on it but be sure not to cut into the surface where the gasket goes on (the pan) be absolutely sure that you use gasket sealer (one coat on one side of gasket, one on the other) or it will not seal good. Then bolt it back up do not overtighten the any of the screws when the rachet gets a bit harder to turn STOP right there! It would be best to do this when you do an oil change
How do you change the driver's side brake light on a Honda Passport?
Changing a tail light on the Passport/Rodeo isn't really as difficult as I have seen some people make it out to be. I have a 2000 Passport, so I'm assuming that most other years for the Passport/Rodeo are similar. To change the bulb you have to remove the rear light fixture. You DO NOT have to remove anything on the interior of the vehicle. There are three screws to get the fixture off. The first two are on the side of the fixture in the small recesses that look like vents in the lights. They are diffuclt to see, but if you look closely, they're right there. Take them out. The third screw is located on the rear of the car, between the bumper and the fixture. It's hard to see without a flashlight. Loosen the screw until it turns very easily and gently pull back and up on the fixture. The assembly should slide right out. There is a pressure fit plastic piece that lines up the fixture. Be careful not to snap it like I did. After that, it's easy. Remove the snap fit electrical supply to the fixture and you're home free. Change the bulb and you're done. Getting that bottom third screw back in can be tricky. I found it easiest to put the screw back in and cover it with a thin piece of tape to hold it in place. Once the fixture is lined up you can secure the sides and screw the bottom in by puncturing the tape with the screwdriver. Took me an hour to figure it out the first time, took five minutes the next.
How do you replace a 92 accord driver side inside door handle?
There is a cap covering a screw in the middle of the door handle plastic, remove the cap then remove the screw. Next you need to slide the door handle plastic to the left or the right (I am not sure ) until it becomes loose. Then pull out the side with the power locks switch and disconnect the connector. Then swing the plastic all the way out so you can disconnect the rod for the door handle. This is done by sliding the plastic clip off of the top of the rod then pulling the rod up...
How do you replace the alternator on a 1984 Honda Accord?
This is a very difficult repair. The lower cross member must be removed. Raise the front of the car and put it on jack stands. Remove the left wheel of the car. Put a jack under a stable part of the engine that can hold the weight. Unbolt the left side engine bolts and lift the engine a few inches. Remove the alternator bolts and disconnect the wires. I have an '86 Accord that I had to replace it in so it should be the same steps. Good luck and I hope this helped. You might want to buy a Chilton manual also for reference. i did this job once by twisting and turning the alternator over towards the passenger side of the car behind the engine. it can be done! i wouldn't have believed it would work....but the car is running again today. easier than undoing large engine bolts... but not an easy job.
How do you tell if wheel bearings are bad?
Most of the time you can hear a bad wheel bearing but the only 100% sure way to know is to remove the bearing and inspect it.
Most of the time you can hear a bad wheel bearing but the only 100% sure way to know is to remove the bearing and inspect it.
What is the rear hip room of the 2013 Honda Accord?
The 2013 Honda Accord has 54.7 in. of rear hip room.
Where is the firewall located on a 1991 Honda Accord?
It is the panel between the engine compartment and the passenger's compartment.
What does distributor cap and rotor do?
Distributes the spark energy from the coil to the spark plugs in the correct firing order.
You flipped your car and left before the cops came?
That's leaving the scene of an accident and can be considered a felony. They can run the plates on the car and find you anyway. It's best to turn yourself in.
If anyone was injured, you may also be charged with leaving the scene of an accident with injuries and/or failure to render aid.
