0
Honda Odyssey
Produced by Honda since 1994, the Odyssey was conceived to fill the needs of a typical family. Depending on the model year, this five-door minivan is available with either a 2.2 liter or 3.5 liter automatic transmission gas engine.
1,668 Questions
How do you fix when gear shift get stuck in park in Honda Odyssey?
What to do when the gear is stuck in park on a Honda 2001
What size wiper blades fit on a 2006 Honda Odyssey?
The 2006 Honda Odyssey takes a 26" drivers side, 22" passenger side and a fairly specialized 16" rear wiper that is difficult to find in the stores. See sources and related links below for more information. Since there are currently over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
Do all Honda Odyssey have a DVD player?
Many Honda Odysseys will have after market DVDs installed, not having been equipped with one from the factory. Therefore you must look at each individual Odyssey to be sure. From the factory the Odysseys in the EX trim (upper level trim) will have leather added making it a "EX L". At that point, you can get the Odyssey with a factory DVD added. In Honda terms it then is a "EXL RES", which stands for an EX with leather interior and a Rear Entertainment System. The next level up is the Touring model. All Touring models currently come with DVDs.
How to change motor mounts on a 1990 Dodge Caravan?
Place a hydraulic jack under the motor.. preferably between the trans and motor for replacement of front motor mount. Proceed to remove the bolts attached to the underside of radiator. Next remove the bolt between the mount. Total removal is 3 or 4 bolts? Make sure the jack is just resting under the transmission as to allow for the new mount to just slide in to the bracket in the same place it was removed. . I don't claim to be a mechanic.. just have had extensive dealings with all of my mounts. Just remember.. you don't have to remove the entire bracket.. of course unless it is broken. the bracket is in two pieces. you only remove the front bracket.
Transmission mount. Remove the air filter box..disconnect all wires in your way. there is a bolt you can see under the drivers side wheel well. This bolt is located behind a rubber grommet. Remove the rubber and there is the bolt. This bolt loosens the transmission mount. I removed the entire bracket to replace mine. There are three bolts that are clearly visible under drivers side wheel well. These bolts have to be removed to take the bracket out. This took a little time to put back in... just be patient with all the mounts or you will be one frustrated individual.
How do you replace a headlight on a 2000 Honda Odyssey?
Just finished this harder-than-it-should-be task. Most of the work is blind and you need to feel your way around the bulb housing to find the clip end of the holddown wire cage. Observe Halogen Bulb practices. Clean off any grease or fingerprints on new bulb with alcohol before installing...otherwise hot spot will develop and kill bulb.
Passenger Side
Step 1: Remove Wire Harness. Find the wires and their harness connected to the back of the bulb. To make sure you have the right harness, wiggle it while looking through the clear lens. If the bulb moves while wiggling the the harness, you have the right one. To remove the harness, simply pull it straight back away from the bulb and off the bulb prongs.
Step 2: Remove Rubber Seal Boot. Note the orientation of the boot (typically, the two rubber tabs extending out the back are at the 12 and 6 o'clock positions). The most exposed edge of the boot is underneath the bulb when viewing from above. Feel underneath for the edge and peel it back away from the bulb housing. Work your way around the bulb housing peeling more of the boot back as you go. You may have to work your way around a few times to complete disengage the boot from the bulb housing. Don't worry about the part of the boot around the bulb prongs. It will slide off easily once the boot is disengaged from the bulb housing.
Step 3: Open Wire Clip. The bulb is held in place by a wire clip. DO NOT unscrew this clip! Find the tab opposite the screw, push it toward the front of the vehicle then pull it up vertically. The wire clip will pivot back. It pivots on the anchor held by the screw. NOTE: The screw merely retains the clip in its mount. The screw does not have to be loosened or tightened during this procedure. In other words, don't touch the screw.
Step 4: Remove Bulb. Once the wire clip is open, the bulb is just resting in the bulb housing. Note the bulb orientation since the new bulb will have to go in the same way (typcially, the three prongs are in the 9, 12, and 3 0'clock positions). Simply pull it out and maneuver it out of the bulb housing and past the wire clip.
Step 5: Install New Bulb. Practice closing the clip and opening the clip without a bulb in the housing. Once you get a feel for it, move the clip out of the way and place the new bulb in the bulb housing. WARNING: KEEP BULB CLEAN -- no contaminants and no fingerprints. Handle the bulb by the metal prongs and maneuver it into the bulb housing in the same orientation as the old bulb.
Step 6: Close Wire Clip. Close the wire clip over the new bulb as you practiced in Step 5 ;p
Step 7: Install Rubber Seal Boot. Maneuver the boot into the same orientation it was in before removal. Place the center hole of the boot over the bulb prongs. Push the bottom edge of the boot onto the bulb housing and work your way around until it is fully engaged with the housing.
Step 8: Connect Wire Harness. Align the wire harness to the bulb prongs and push it on.
Step 9: Test. Turn on the headlights and make sure it works.
Step 10: Drink.
Driver Side
Same procedure as passenger side now except that space is VERY TIGHT and the housing over the air intake must be removed before starting. The two fasteners on the air intake pull straight out with a little tug by pliers. Save the fasteners, you will need them to reinstall cover later.
Good luck. I am sure the dealers charge at least $100 to do this paininthea** job. So you are saving some dough for the aggro. Owners manual actually has a reasonably good diagram and I recommend looking at it.
Howard
With Howard's guidelines, I was able to cut his time in half. Thx. One piece of advice on the clip wire that holds the light in place; put the square end of the clip under the screw and tighten the screw half way, then press down on the opposite end of the wire to "hook" the wire under the bracket. Tightened the screw completely after the wire clip is in place. Definitely worth doing it yourself.
NOTE: The above 10-step procedure does not require any adjustment to the screw that retains the wire clip. The screw simply holds one part of the cage's wire frame in place and allows the clip to pivot around the retained wire. Practice opening and closing the clip in Step 5 and it all makes sense.
What do you do if the emission light comes on in a Honda Odyssey?
We have a 2003. The owner's manual says to check the gas cap -- tighten it or take off and put it back on again. (This was our problem.) Owner's manual says, once problem is fixed, light will go off in 3-4 times of staring the van, but ours did not. So, I called the dealership and he said it's more like a week of driving the van before it goes off.
The headlights on a Honda Odyssey wont work for some reason.?
I'd check the fuse first. Maybe the fuse has blown.
Can you change the timing belt and water pump yourself on a 2003 Honda odyssey?
Not unless you know what you are doing. This is an interference engine. Do this incorrectly, start the engine, and you will have internal engine damage.
How do you program a new key on Honda Odyssey?
It all depends on the year. I have a 98 Accord and have found out that they can offer me a new Honda key for 15.00 and then you pay 80.00 to 100.00 to program it so your car can start with it. The dealer also offered me an after market key for 30.00 and then they read your original key's transponder and then clone it to the new key. The programmong of the key to the car other than cloning must be done with a Honda PGM tool or some other after market equivelant.
Anyone who tells you that you can do a procedure like playing with the door lock buttons or swapping keys rapidly means well but thay are wasting your time. good luck.
What is the curb weight of the 2007 Honda Odyssey?
The curb weight of the 2007 Honda Odyssey is 4384 lbs..
When should you replace the water pump on a Honda odyssey?
The water pump should only be replaced when you hear signs of the pump failing, i.e: bearings on the pulley are squeaking.
Honda odyssey directions for change head light bulb 2002?
changing a head light bulb in an odyssey is real easy. first remove connector from back of bulb. then remove rubber cover by pulling on one of the tabs. then remove retaining clip which holds bulb in place. remove old bulb, replace with new bulb, replace retaining clip, then replace rubber cover, and reconnect connector. all done. each light takes about 2- 5 minutes
What temperature does a 1996 Honda Odyssey thermostat open?
180 degree F is listed as original equipment spec by most auto supply houses.
The actual factory service manual calls for start to open at 169-176 degree F and open at 194 F. The specification for "full open" is a gap on this unit is > .32 inches.
Does a 2006 Honda Odyssey exl have a timing chain?
The 2006 Honda Odessey has a timing belt not a time change and it is critical that you change the belt around 115,000 miles.
How many gallons does the gas tank in the 2002 Honda Odyssey hold?
The gas tank on the 2002 Honda Odyssey holds 20 gal..
What was the meaning of 2001 A Space Odyssey?
The most common interpretation is that the meaning is all about how man abuses its tools. In the beginning, millions of years ago, when the monkey hit the other monkey with its tool (the bone) was the first step. The black monolith (rectangle) represents man's challenge to be able to actually get smarter and/or progress as we grow. It means evolutionary knowledge. HAL is man's machine, a computer, four million years later in 2001. Man developed machine to be as advanced as themselves. The machine defended himself and ended up harming man, just like the monkey used its bone to kill another monkey.
So, in the end, it tells us that we depend on our tools so much that they become too advanced and that they can eventually destroy us.
Lots of people actually just overlook an entire hour of the film and just say the message is "Don't trust electronics", but if you "go into it" a bit more, you'll realize that the real meaning also has to do a lot about evolution.
How do you remove Honda Odyssey dashboard storage box?
A '97 Odyssey has a timing belt, not a chain. The belt needs to be replaced at 100K intervals.
How do you change the front brake pads on a 1992 Plymouth Voyager?
Brake work should be performed ONLY by trained professionals, NOT the Saturday afternoon "shadetree mechanic"......brake work should NOT be an experiment....a vehicle that won't go is one thing, but a vwhicle that won't stop is another. Just let an ambulance chasing lawyer find out that the reason your vehicle slammed into another vehicle due to your "brake work experiment" and you will loose everything, including the shirt on your back.
Why does my drive light blinks on your Honda Odyssey?
It's a warning to have your transmission checked. May need a fluid change, or worse. It happens with my '04 Odyssey after I get on the freeway, but only if I have to floor it which engages the passing gear.
I just had a problem with my 2007 Honda Odyssey where the front driver-side door half-locked (became stuck), when it wasn't supposed to lock at all. It took three fire trucks, two ambulances, and two police cars to unlock the door and my 2 1/2 year old son was locked in there in 95 degree weather!
