Infiniti Q45

The fuse box in most cars and INCLUDING my 98 infiniti q45 is located by the feet of the driver.

For the Q45 it is to the left of the parking brake.

Look and you will see only one hatch covering the fuse box.

It is also shown in your Manual.

Yes it does work! make sure the positive , feed, ground are correct!

To replace the alternator on a 2000 Infiniti Q45, first disconnect the negative battery terminal to ensure safety. Remove the drive belt by loosening the tensioner, then unbolt the alternator from its mounting brackets. Disconnect the electrical connectors and the battery cable from the alternator. Finally, install the new alternator by reversing the steps, ensuring everything is securely fastened and properly connected before reconnecting the battery.

To replace the knock sensor on a 1999 Infiniti Q45, first disconnect the negative battery terminal and remove the intake manifold for access. Locate the knock sensor, which is typically found on the engine block, and disconnect the electrical connector. Remove the old sensor using a socket wrench and install the new sensor, ensuring it is properly torqued to specifications. Reconnect the electrical connector, reassemble the intake manifold, and reconnect the battery.

Yes, 22-inch rims can fit on a 2002 Infiniti Q45, but it's important to ensure they are compatible in terms of bolt pattern, offset, and overall diameter. Upgrading to larger rims may require adjustments to the suspension, wheel wells, or tire size to avoid rubbing and maintain proper handling. It's advisable to consult with a professional or refer to specific fitment guides for optimal results.

The AC low-side port on a 2000 Infiniti Q45 is located on the accumulator, which is positioned near the passenger side of the engine bay. To find it, look for a small service port that usually has a blue or black cap. It's typically near the firewall and connected to the larger AC lines. Ensure the engine is off and the system is not pressurized before attempting to locate or service the port.

The fuel reset switch on a 1993 Infiniti Q45 is typically located in the trunk area, near the right side, behind a small access panel or near the fuel pump assembly. It may be a small button that you can press to reset the fuel system after a collision or fuel pump issue. If you're having trouble locating it, consulting the vehicle's owner's manual can provide specific guidance.

To install the cam sensor on a 1996 Infiniti Q45, first disconnect the negative battery terminal for safety. Remove any engine covers or components obstructing access to the cam sensor, then unplug the electrical connector from the sensor. Unscrew the old cam sensor using the appropriate socket, install the new sensor in its place, and tighten it securely. Finally, reconnect the electrical connector, replace any removed components, and reconnect the battery.

To locate the fog lamp fuse for a 1997 Infiniti Q45, first, open the driver's side door and locate the fuse box, which is typically found under the dashboard or near the driver's side kick panel. Refer to the fuse box cover or the owner's manual for a diagram that indicates the specific fuse for the fog lamps. Once identified, check the corresponding fuse for any signs of damage or breakage, and replace it if necessary.

To replace the air conditioner condenser on a 1997 Infiniti Q45, first, ensure the vehicle is safely elevated and that the AC system is properly evacuated to remove refrigerant. Disconnect the battery, then remove the front grille and any components obstructing access to the condenser, such as the radiator. Detach the refrigerant lines from the condenser, remove any mounting bolts, and carefully extract the old condenser. Install the new condenser by reversing the removal process, ensuring all connections are secure, and recharge the AC system once reassembled.

To change the clock light in a 2002 Infiniti Q45, you'll need to remove the dashboard trim around the clock area. Start by carefully prying off the trim using a flat tool to avoid damage. Once the trim is removed, access the clock assembly and replace the bulb. Finally, reassemble the trim to complete the process.

Yes, but it will cause serious problems in the long run. The perferct & proper pattern is the 5X115 for the 300C

Ford uses the 5 x 4.5", or 5 x 114.3mm, same thing.

Your local auto store. I use O'Rally.

Timing chain

no it will fit up to 18" rims without rubbing but you have to wrap it in low pros or it will be a really tight fit I had a 93 with 20"s on it. get low profile tires and u also can get the lips on the car cut out. Answer I have a 93 Q-45 with 22's... with 245/35's..So 20"s will fit no problem..12522876262.. Anythings possible

It shouldn't be that hard to install fog light. If you cant find the wire hardness in the same location. You may have to run new wires to a separate switch.

yes they will i have 20's on mine

the oil pump is located behind the cranckshaft pulley and takes its drive from the crank itself, search for this file 6g72.pdf it will help

when the ray of light enters a medium in bends a come out this is known as refliction of light

no, they do have a 5x115mm pattern. 4.5= 114.3 so it is very close. close enough to work in most cases.

I just bought a 91 Q45 and the tranny don't work, there is no garbage in the fluid and someone said it might be the module. Can you tell me where it is located. Thanks