Why does water run out of your shower head even when the valves are shut off?
You may have a broken pipe or have not paid your water bill and they turned it off at the main. Check the main for a tag from the department of water and power.
How do you change bathroom sink?
# When you replace a countertop sink, the replacement sink should be the same size or slightly larger than the original sink for a secure fit. Double-check the measurements of your old sink before purchasing the new one. Measure the length, width and depth of the old sink.
Measure the critical dimensions of the countertop. # Measure the width of the countertop.
# Measure the distance from the front of the sink to the edge of the
countertop (F), and from the back of the sink to the wall or backsplash (B).
Breakdown of pipe assembly # Bring the sink and countertop
measurements with you to the store.
# List the hardware you need or plan to replace: faucet, trap, tailpiece and supply lines. Disconnecting the Plumbing #
Always use padding between
wrenches and couplings to
avoid damaging the finish. # Turn off the water supply. In most bathrooms, the shutoff valves are located under the sink. If not, turn off the water at the main water-supply valve. Test the faucets to make sure the water is off.
Cutaway of a sink clip # Place a bucket under the trap. Loosen the slip nuts on the trap and remove it. Empty the water from the trap into the bucket. If there is a tailpiece connected to the drain assembly, remove it as well.
# Disconnect the supply lines from the faucet. All of the plumbing should now be disconnected from the sink. Removing A Counter Top Sink # If the sink has clips, loosen them from underneath the counter. If the clips won't detach, break them off and throw them away. Be careful not to damage the counter.
# There should be a bead of sealant between the counter and the sink rim. Cut the seal along the rim with a utility knife or wedge it apart with a small pry bar. If you use a pry bar, put cardboard or a rag under it to protect the counter.
# Lift the sink straight up out of the counter. You may need a helper if the sink is too heavy.
# If the sink and countertop are a one-piece unit, there should be sealant holding the countertop to the vanity. Use a utility knife to cut the seal. Be careful not to chip the vanity when breaking the seal. Remove the countertop and sink. You may need a helper if the unit is heavy. Removing a Wall-Mounted Sink # The sink may be heavier than you realize, so ask a helper to hold the sink while you disconnect the plumbing. If the wood behind the sink is rotten, the plumbing may be the only thing holding it up and disconnecting the plumbing could cause it to fall.
# If the sink is mounted in a bracket, you should be able to lift it out as soon as the plumbing is disconnected.
# If the sink is bolted to the wall, have a helper hold the sink while you remove the bolts. Once the bolts are removed, the sink should be free. Installing the New Sink # Install the faucet in the new sink.
# Put a ring of plumber's putty on the drain flange inside the sink. Insert the drain assembly and install any washers provided. Tighten the locking nut until putty squeezes out from the drain flange. Wipe away excess putty.
# Turn the sink upside down on a towel or other nonabrasive surface. Run a 1/4" bead of silicone or latex caulk under the sink rim.
# Carefully lower the sink into position. Press down firmly until caulk squeezes out around the rim of the sink. Wipe off excess caulk.
# If the new sink requires clips, install them at this time.
# To install a wall-mounted sink, see Installing a Pedestal Sink. Connecting Plumbing to the New Sink # Make a final tightening of the drain assembly.
# Connect the supply lines to the faucet tailpieces.
# Connect the stopper assembly according to the manufacturer's instructions. If you are using the old fixture, see Repairing a Pop-Up Stopper.
# If the drain requires a tailpiece between the trap and the drain assembly, install it now. Install the trap. Check all of the connections for tightness.
# Turn the water back on and check for leaks at the faucet. If leaks appear, shut off the water and re-check the connections. Tighten the connections slowly until the leak is stopped.
# Turn on the faucet and check the drain for leaks. If leaks appear, tighten the slip nuts carefully until no leaks are evident.
How much does a cast iron double basin kitchen sink weigh?
It all depending on how big ,but they will weigh at least 10x more
Where can you find wallpaper borders?
i believe a shop in lichfield called Decor sell all kinds of wallpaper, apparently they did have wrestling paper last year, but cannot find number to confirm decoratetoday.com
Is it better to buy furniture online?
You might save some money, and you're probably okay buying things like end tables and bookshelves online, but if you're wanting to sit or even SLEEP on this furniture, you should go to the store and try it out.
if I was you I would by a new house unless you like your house flooding Many things must be taken into cosideration. One is the location you are at. You may have local codes that must be met to ok the work that needs to be preformed. After checking into that, use a builders level and shoot grades to see the land fall of the property and just where the water is going. If there is room to fill in the low area from the house to the furthest point out without covering the foundation too deep you can try that. Keep in mind that the spot under the house will be deeper at that point and you my have the result of water building up underneath the house. Another thing you might be able to do is to shoot a grade to the lowest point closest to the house and then find the point frathes fron the house that is at a lower point. Dig a trench from point to point with the grade slope going away from the home. Place a pipe that is suitable to carry the water, this will act as a storm drain. Any water that might be building in the area could also be drained away by putting in feild lines in the same way septic lines are installed, only they will act in reverse and drain the water from the ground instead of putting water in the ground.
How big is a queen size matress?
It's kinda bigger than 60inches /80inches.
If you would like to purchase, I will recommend
Dreamcloud has a lot of variety and comfortable mattress
htt ps://bit. ly/3impoO5 (Remove spaces and copy and paste link)
Are there online college courses for interior design?
Sheffield school offer interior design courses online.
What size pillow fits a euro sham?
Hey, everyone, the answers of this question is soo good that's why I am not giving the related answer in other hands I am giving the information about "How to wash Fellows" Visite the article below for more information
Home to Wash Pillow
What is the best computer for Interior Design?
Design of Productsis generally done by skillful Artisans. The finished works are very beautiful and worth appreciation. Nowadays COMPUTER AIDED DESIGN softwares facilitate speed toDrawing & Designingprocesses. Various tools have been developed to feed INPUT of DRAWING & DESIGNS to Computers like Graphic Tablets, Drawing Boardsand Drawing Mouse PENS.
The Essentials Characterstics of Computers (Do and Undo) make DESIGNING fast, more organised, providesquick access to Drawings Libraries stored on Media, portability and mobility of Designs get them closer to prospective Buyers and Appreciators. This makes designing process more streamlined and generate revenues for its creators.
How do you attach PVC to plywood?
Clevis hangers attached to threaded rod with a rod coupling to give the proper amount of pitch
How do you remove a toilet paper holder from the wall?
Do you mean from the toilet (as in you flushed it down)? Well, if this is what you mean, I'll tell you how. If it was recently and it's STILL in there, then ATTACK IT WITH THE PLUNGER!!! If this isn't what you mean, then I can't aswer that... but in terms of the other answer, if it's still in the toilet and it hasn't caused any problems, then either A) by some MIRACLE it managed to get past the toilet loop and is stuck in another spot, allowing the "logs" to get past, or B) the first one (A) did happen, but the toilet thing went down into the rest of the toilet system. I hope this helped!
Will a full comforter fit a queen bed?
They may, but not very well a queen is bigger than a full, and therefore the smaller fullsize sheets will either not fit at all or only partially fit.
is there a bed sheet extension that i can get for full size sheets on a queen size mattress
Can you put ceramic tile over ceramic tile?
You can, but you want to be sure the ceramic tile is not cracked or broken, make sure it is even, and not loose. It is reccomended that you you always remove any old tile before tiling. You can always lay a subfloor on top of the old tile to ensure your new tile was crack or pop out.
What causes the toilet seat lid to be covered with condensation?
This is similar to the problem of condensation appearing on the outside of a water glass. Water vapor condenses on a surface that is cooler than the temperature of the water vapor.
I had been wondering the same thing about my own toilet seat (it affects the seat in my case, and not just the lid, which was quite disconcerting the first time I noticed it!). The explanation I have puzzled out is this:
* The water in the toilet bowl has had all day to warm up. Considering the density of water, it will take it quite a while to cool back down.
* However, the toilet seat and lid are relatively thin pieces of plastic, so they cool down more quickly than the water.
* I'm guessing there is somewhat more water vapor in the toilet bowl than anywhere else in the house, and considering it is trapped by the (now cool) closed seat lid, the water vapor decides that the toilet seat lid looks like a great place to settle down for a while.
If you wish to avoid this, I'm going to hazard a guess that leaving the seat lid open would do wonders, since the vapor would then have a much easier time leaving the vicinity and many more places to settle.
I usually turn my a/c down (to a lower temp) when I get home at night, which I initially thought was causing the above. I think it's just as likely, though, that the natural cooling that occurs with the onset of evening would cause the same result.
What materials are soundproof?
No materials are soundproof. Only the absence of air (a vacuum) prevents the transmission of sound.
Many materials can absorb most of the energy of sound and minimize sound reflections or sound being transmitted through it.
Check out building materials offered by Sonex, Auralex and Primacoustic.
Can you buy a shower door frame?
Sower doors will normally come as a complete unit. In many situation contact the original manufactures of the one you have issue with to see it they will or able to supply for the model you have
What is the square footage of a room with the dimensions of 216 feet by 6 feet?
Just multiply the two numbers together.
216 ft X 6 ft = 1296 sq.ft.
NB Notice the change of units.
How many people can sit at a 52x70 table?
It is not enough to describe a table as 50x70 because you have not included any units of measurement. It might be 50x70 inches, or centimeters, or if you have a really big table, feet, meters, etc. There are lots of units of measurement.
It depends on the sise and grade of the joists.
What is the length of a sofa seat?
They often vary widely ... some are 5' long, 6' long or even 9' long. Some have recliners at both ends, some do not ... some have sleepers, some do not. There are lots of variables and as many manufacturers.
timber frame work to hold up the ceiling and and straw or grasses for the roof