What is the lug pattern on a 1996 ford bronco?
The bolt pattern on a Ford Bronco or 1/2 truck (F150) is 5 on 5.5 (5/5.5).
Where is the fuse for a factory alarm on a 1993 Grand Cherokee Limited?
on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps
16
What is the bolt pattern pcd for a 2004 Jeep Cherokee?
The PCD is 5 x 114.3mm or 5 x 4.5 inch Regards wizard
Where is the tps sensor located on 1990 Jeep Cherokee 4.0?
The tps (throttle position sensor) would be found on the throttle body, opposite side where the throttle cable is connected.
How do you remove a power steering pump bracket on a 94 jeep Cherokee?
bolts are accessed through the holes in the power steering pulley, use a long socket and line up the holes in the pulley with the bolts, spin it around to get all 4
Then the bracket mounts to the front of the engine in 2 places and one below the exhaust manifold. Removing these bolts will be easy once the pump is out of the way.
sounds like you have a shorted wire somewhere in the circuit. If your jeep has a trailer harness or has rust at the rear of the jeep, look for wires that may be grounding out. Could be easy or a nightmare but this is a good place to start.
What is the color of each wire connected with the radio of a Jeep Cherokee?
http://www.installdr.com/Harnesses/DCP-Wiring.pdf
change calipers and brake lines. flush brake system. measure rotors for thickness. the rotors on your particular vehicle are composite, which usually warrants replacement rather than to turn them. do all of this due to the age of the vehicle. change calipers and brake lines. flush brake system. measure rotors for thickness. the rotors on your particular vehicle are composite, which usually warrants replacement rather than to turn them. do all of this due to the age of the vehicle. change calipers and brake lines. flush brake system. measure rotors for thickness. the rotors on your particular vehicle are composite, which usually warrants replacement rather than to turn them. do all of this due to the age of the vehicle. change calipers and brake lines. flush brake system. measure rotors for thickness. the rotors on your particular vehicle are composite, which usually warrants replacement rather than to turn them. do all of this due to the age of the vehicle.
Where is the thermostat located on a 1989 Jeep Cherokee?
http://wiki.answers.com/Q/Where_is_the_thermostat_located_on_a_1989_jeep_cherokee"
Could you get diagram for 1999 Jeep Cherokee fuse block?
E-mail me and I will send you a wiring diagram ernestw@xtra.co.nz : Here is the link to a site where you can find a fuse block diagram for Jeep Cherokees (XJ) 1997-2000. : http://www.lunghd.com/Tech_Articles/Electrical/1997_UP_Fuse_Identification.htm
check the plug at the back of switch it may be loose
How do you install fuel pump for 1998 Jeep Cherokee Limited?
The fuel pump is in the gas tank. You have to empty the tank and drop it in order to get to the fuel pump. It's a bum deal; not to mention slightly dangerous. Be sure to disconnect the battery as to avoid any possibility of sparks. Good luck!
How do you put windshield washer fluid in the back window of a jeep Cherokee?
it's pumped from your washer fluid jug under the hood , if you aren't getting fluid to the back , check to see that it isn't plugged at the wiper , or the pump may not be working.
Where is the turn signal relay located on a 1999 jeep wrangler?
Front seating area, under the left hand side of the instrument panel, right hand side of steering column.
Curtorsey Auto Zone.
Does a 1990 Jeep Cherokee have interchangeable parts with a 1989 Jeep Cherokee?
Most parts are interchangeable as long as it's the same engine type.
How much fuel is left after the yellow light comes on in a Jeep Cherokee 2000?
The low fuel light comes on at about ten percent tank capacity.
1999 Jeep Cherokee fault code p0320?
Trouble code P0320 means: Ignition/Distributor Engine Speed Input Circuit
You will have to change the coolant temperature sender that's directly by the firewall.
There are two coolant temp senders - the other one, by the water pump, controls the electric fan.
You will also have to change the oil pressure sending unit.
I'd highly recommend getting brand-new sending units - they are relatively inexpensive and have a warranty.
How do you replace a Jeep Cherokee neutral safety switch?
On the passengers side of the trans about even with the front of the door fan shaped switch held on by two bolts.
I suggest taking it apart and cleaning it before you think about replacing.
The switch is nearly $300
To remove, flatten out the retaining washer side, remove large nut, remove smaller ( 14mm ) bolt on the adjustment side.
cleaning is easy, 6 screws in back, pull apart, clean out all that old grease, pay special attention to the two contacts on the sweeper arm, they should move in and out easily as they have springs underneath and are the man contacts, apply new di-electric grease and reassemble.
reassemble and align before tightening, easiest way is to put trans selector in R and move switch until reverse lights come on.
What kind of rear brakes do you have on your 2000 jeep Cherokee sport?
A 2000 Jeep Cherokee would have rear drum brakes.
If it is deep in the engine, the engine may need repaired/replaced.