Where is the Idle control valve on a 2005 Kia Rio?
Look in the back, behind the motor on the right side. It looks like a screw sticking out.
Are Kia and Hyundai owned by the same company?
Yes and no. Hyundai bought KIA in 1995 and owns 51% of KIA. However, the other 49% of KIA is owned by Ford.
How do you replace tail light bulb on a 1998 Kia Sephia?
You have to remove the tail light first, and to do this you have to take the 3 screws on the tail light, open the trunk, remove the 3 screw and pull the light toward the outside (slide it to the side, if you are taking the left taillight out slide the tail light toward the left, if you are doing the right side slide it toward the right side).
Change the bulbs, and install on the reverse.
Where is the accumulator drier on a Kia Rio?
Usually against the passenger side firewall
answer
you can find it near a/c fittings.
There is a bent or dropped valve that is hampering it, The Rio 1.5 is a zero tolerance engine if the belt breaks than its pooched
Will a 2003 Kia Rio engine fit a 2004 Kia Rio?
Yes, you can use all 2001-2005 1.5 or 1.6 Liter Kia Rio 4 cyl. engines they are interchangeable and should be plug and play, just swap no need to change computer or anything...
How do you remove and replace 2003 Kia Rio Cinco manual shift knob?
turn the handle counter clockwise and remove the leather boot, screw on a new one. if using an oem shift knob the boot probably will not snap back on, and you'll need some kind of adapter to match the threads, usually a plastic insert secured by a hex screw.
turn the handle counter clockwise and remove the leather boot, screw on a new one. if using an oem shift knob the boot probably will not snap back on, and you'll need some kind of adapter to match the threads, usually a plastic insert secured by a hex screw
Are the Kia Sedona's any good?
No. Too many people, including myself, have had WAY to many problems with them. Wish I would never have bought it. One Big NIGHTMARE!
answer
Kia Sedona for 2011 can conveniently accommodate seven people in its interior.
This comes with a traditional V-6 drive-train and is available in traditional LX and upgraded EX trim levels.
Anyways, competitors of this vehicle are Dodge Grand Caravan, Toyota Sienna, and Honda Odyssey.
Where is the crankshaft position sensor located in a 2003 Kia Rio?
how to replace the crankshaft position sensor located in a 2003 kia rio
How much torque does the engine in the 2007 Kia Rio have?
The 2007 Kia Rio's engine produces 107 ft-lbs. @ 4500 rpm.
Where do you find the place to add transmission fluid in a 2001 Kia Rio 5 speed?
If it is a manual, then you add lube under the car on the upper side of the transmission. under the hood on fire wall side there is the speedometer cable. you must remove lock down bolt with # 10 socket and lift straight up. that is where you add/check your tranny fluid on a 5 speed. clean first. fairly simple.
How do you change the valve cover gasket on a Kia Rio?
ok, if you have this problem im going to guess your plugs are bad too. they will get oil on them. you take off the valve plastic cover, then all the plug wires, mark them or remember were they go.. then all the top bolts that hold it on, remove cover take a straight screw driver or gasket scraper and get all the old gasket off, wipe clean. parts you should need(gasket sealer or maker) gasket. make a bead line around the top of the head, place new gasket in place with all bolt holes matching. put top back on check and see what torq puunds the bolts need and let set for 24 hrs in room temp. might wannt check all plug wires for oil as well. might wanna check the bolts after a week of driveing it and see if they need tighting. hope it helps ya i had to do it for the first time 2 years ago and still on the road.
Where is drain plug for transmission fluid on a 2003 Kia Rio car manual located?
If its not on the transmission pan ,you have to remove the pan to change the oil
Where is fuel pressure regulator located on 2001 KIA RIO?
The fuel pressure regulator, on a 2001 Kia Rio, is located near the fuel injector pump. The pressure regulator can be found on the top of the engine.
How do you replace a tail light bulb on a 2005 Rio Kia?
You have to remove the tail light first, and to do this you have to take the 3 screws on the tail light, open the trunk,and remove the plastic cover on the side to have access to the back of the tail light remove the 3 screw and pull the light toward the outside (slide it to the side, if you are taking the left taillight out slide the tail light toward the left, if you are doing the right side slide it toward the right side, this is the only way to have access to the bulb, the first time I did take like 3 minutes
Do 2003 kia Rio 1.5ltr head gasket the same as 2002 kia Rio 1.5ltr head gasket?
No the 2002 had a 1.5L DOHC I4 and the 2003 had a 1.6L DOHC I4
Torque specs for axle spindle nut for 2001 KIA RIO?
First down to 20 ft lbs then back off to allow thrust washer to move freely with finger pressure. Then recheck in 300 miles (I checked mine every 100 up to 300) for abnormal tightness or loosness. Any abnormalities? Just repeat the first steps until bearing is worn-in. Note: Cape chisel is required to remove indent in lock nut made when installed. Additional lock nuts may be required during adjustments as the process for getting them to lock does them in.
How do you replace timing belt 2004 Kia Rio?
This type of work is normally entrusted to an expert, if you choose to have a go yourself, I would recommend that you buy a workshop manual and look at what tools and equipment you may need. The cost may outweigh having the belt replaced by a local garage, try getting some local quotes to see how much you would be charged to have the job done professionally.
Sending unit on a Kia Rio 2001?
its in the tank with the fuel pump but i would check your grounds as is very common with these