0
Mazda Protege
Also known as Familia in some markets, the Protégé was a compact car produced by Mazda Motor Corporation from 1964-2003 for the North American market. The Protégé was one of the company’s best sellers and was manufactured in eight generation models.
1,312 Questions
What is the cost to replace the clutch in a 1997 Mazda Protege?
I have a 1997 Mazda Protege ES and the Replacement Clutch cost about $125 from Advanced Auto Parts. The labor charged was around $350 at a local shop. I also had a broken Clutch Fork (the reason I had to get it fixed) which cost me only about $25 from Mazda's dealership. All together I had to pay around $500, but I believe I got a relatively good Labor cost; just shop around for the best price.
Where is the oil filter located on a 2001 Mazda protege lx?
It should be at back of the engine about 8 inches above. It is mounted on a slight angle so the oil drains back in the engine so it doesn't drip back on you taking it off. This is based on my 2001 2.0 ES.
How much to change a valve cover gasket?
Valve cover gaskets will age over time and become brittle and once that happens ... first time so you don't have to slide it around much and disturb the sealer. ... How to Change the Valve Cover Gaskets on a New Beetle · How to Change ..
Where is the egr valve located on a 1997 protege 1.5?
The EGR valve is located between the firewall and the engine about 2 inches below the intake. Two 12 mm bolts hold it in position. I found it helped to take the rubber intake boot off between the flow sensor and the engine. The bolt heads point toward the master brake cylinder nad the battery.
02 Mazda pro 5 e brake cable loose?
HOW DO I TIGHTEN EMERGENCY BRAKE CABLE ON A 2002 MAZDA PROTEGE 5?
Where is turn signal and hazard flasher on 2002 Mazda protege?
Turn signal is on the left of the steering wheel its the wand thing that sticks out of the steering column that also has your lights and high beam controls. You flick the wand thing up or down for the turn signals and back for the high beams, and the hazard flasher is in the middle of the dash above your radio should be by itself between the vents
Is a 1999 Mazda protege 1.6L a rotary engine?
No. It is, however, a reciprocating 4 cylinder, water-cooled 4-cycle (Otto cycle - spark ignition) piston motor. From the 1980's, the Mazda rotary (nee Wankel) engine has only been available in the RX- series (RX : Rotary Experimental). There currently exists a JDM rotary engine hybrid Mazda5 model, leased in very small numbers for research purposes.
What is the correct procedure to get at the EGR valve in a 1990 Corvette?
the only way i know of is to pull the upper plentum mabely with swivel sockets and luck you could pull one set of the intake runners
How do you remove a broken key in a 93 Mazda Protege?
== == You need to call a professional lock smith, who has the training and the proper tools to do this for you. try a thin coping saw blade, cut off end at an angle with wire cutters, slide it in along side key twist and pull
For the AC where is the freon refill part for the Mazda Protege 1997?
Buy a kit at Wal-Mart or auto parts comes with instructions
What is Wrong when there is iol on the spark plugs on a 95 mazda protege?
this could be valve stem seals or oil control ring,s
Where is the transmission shift solenoid located on a 1994 mazda protege?
On the top of the transmission, with a harness headed to it, should be about 3 bolts to take off, then valve comes off... shift solenoids are in there
What weight oil does a 2002 Mazda Protege 5 take?
For a 2002 Mazda Protege 5, the recommended oil is a 10w 30. 5w30 is recommended in temps below 30 degrees f.
Where is the fuel pump reset button on a 1997 Mazda Protege?
It is not equipped with a fuel pump reset button. Check the fuse and relay.
Where is the downstream oxygen sensor on a 1998 Mazda protege?
This is not under the car, but under the front hood. It's actually right next to the fan. This is not under the car, but under the front hood. It's actually right next to the fan.
How do you remove the driver's side seat in a 2001 Mazda Protege?
Most likely the same way you remove any bucket seat in a car. 4 bolts holding the seat rails to the bottom of the car, and if it's an electrical seat, an electrical wire plug.
Where is the oil drain plug on the 2001 Mazda Protege?
If you are under the car. Look to the rear of the engine and you will see a bolt (I think that it is a 19mm) in the oil pan.
Where is the transmission dipstick located on a 1997 Mazda Protege?
It is the center to the right of the engine...
How do you change the light bulbs that illuminate the dash on a Mazda Protege 5?
Remove 2 screws above the black trim bezel surrounding the Instrument cluster.
Insert a hard plastic or nylon prying tool into the crevice surrounding the trim and gently pry evenly all around the bezel until it pops off, or use a hook tool to grasp and pull the black bezel off.
Now you will have to remove 4 screws that hold the instrument cluster in place. Gently pull cluster forward and tilt down to expose electrical connectors. Carefully remove connectors by pushing in on the release tab and pulling up on the wires, this will remove the connector, repeat this procedure for the remaining connectors. Lower the steering column and gently remove the instrument cluster. You will notice little lamp holders at the backside of the cluster, genly grasp the holder(s), turn and pull up using a plier. Make a note where each lamp was removed. Purchase replacement part at your favorite Mazda dealer. Now just put everything back together and reinstall the instrument cluster.
