answersLogoWhite

0

Oldsmobile Ninety-Eight

The Oldsmobile Ninety-Eight (98) was a full-size automobile manufactured by General Motors from 1941 to 1996. This model featured the highest-grade exterior and interior trim, as well as the Twilight Sentinel.

500 Questions

How do you replace the voltage regulator in an 98 Olds regency 1986 model?

User Avatar

Asked by Wiki User

It's inside the alternator. If you haven't already done one (and evidently you haven't) it would probably be best for you to just replace the whole thing. Some special tools are required and it can get a little overwhelming for the first timer.

Where is the blower motor relay located on Oldsmobile 98 1991?

User Avatar

Asked by Wiki User

on the right side of the engine firewall on a relay brackt.

which one?

Driver side blowing hot air and passanger side blowing cold air on a 95 0lds nine eight?

User Avatar

Asked by Wiki User

its your blend door actuator behind the glove box most likely Mine did the same until i replaced it

What fusible link would stop 1996 98 Oldsmobile from starting?

User Avatar

Asked by Wiki User

there is a fusible link on the starter solenoid somewhere

What is the belt diagram for a 1985 Oldsmobile Ninety-Eight?

User Avatar

Asked by Wiki User

answer to Olds belt diagramits hard to put a diagram into words..my husband has a diagram for a 1985 Oldsmobile Royale Delta 88..here it is...hope it helps and good luck

belt # 15436 which is a small belt goes to the alternator & fan pulley ,belt # 15445 which is a small belt also goes to the center pulley behind the fan pulley then the power steering pump and on the bottom outside crank pulley below the fan-water pump pulley.the final belt # 15585 which is a larger belt goes to the air condition compressor fan pulley far inside groove t,crank pulley far inside groove toward engine block and then emission pump. I bought one belt @ AutoZone and the 2 small ones were made by Goodyear,But as long as the numbers & belt size match you should be able to get them anywhere. I hope this helps as I had to track down another Delta 88 Royale as none of the parts stores were of much help either.

Why does Oil pressure sender keeps coming on?

User Avatar

Asked by Wiki User

I've got a 92 98 road touring and it did this and all it was, was the sending unit. It is got an end cap on it and it was broken

What is gm part?

User Avatar

Asked by Wiki User

It's an AC Delco Knock Sensor Module

Where is the 02 sensor on a 1992 98 Oldsmobile and how easy is it to replace?

User Avatar

Asked by Wiki User

It mounts in the rear manifold at back of motor just after the 3 cylinders piping converges into the single outlet - there will be a silver cover on it and a wire (usually black that comes to a connector about 6 " away. You can use a wrench (about 1" size) or a specific tool to remove it. Do this with engine cold or the threads will risk being damaged. The new sensor comes with special beaded lubricant for thethreads on the O2 sensor. Be sure to use it BUT be careful not to get any on the sensor itself. The job can be bit aggravating but not too terribly difficult.

Where is power train control module located on olds 98?

User Avatar

Asked by Wiki User

Power train or ECM? Most have been behind the passenger side kick board between door and firewall. you may have to remove cover beloe glove box first.

Where is the heater core on a 1986 Oldsmobile 98?

User Avatar

Asked by Wiki User

By the firewall, up and under the dash.

How do you get your trunk to close when the electronic motor goes out on a 1990 Oldsmobile 98?

User Avatar

Asked by Wiki User

We took the electric unit out of the trunk, disassembled it and wound the screw jack to the position needed to keep the trunk closed. This took a couple of times to get it right. We left the unit unplugged and now it operates as a regular, non-self-closing trunk. The electric release still works fine.

What are the speaker size on an 1991 Oldsmobile Ninety-eight?

User Avatar

Asked by Wiki User

i have an '83, not sure if theyre the same but probably are

6x9 for the rears

3 1/2" for the dash

6 or 6 1/2 for door

youll have to measure for urself to be 100% sure, just take the speaker out and measure straight across, speaker sizes go by 1/2" so if it measures something like 3 3/4" it would be a 3 1/2

My power windows for your 1989 ninety eight Oldsmobile no longer work any suggestions?

User Avatar

Asked by Wiki User

it might be something as simple as a fuse but it sounds to me since the car is 20 years old that its probably the power window motors located in the doors.

How much does an 89 olds 88 weigh?

User Avatar

Asked by Wiki User

at the very least 5000 pounds:)my 1983 98 weighs 5150!

Can a car stop running if the starter goes bad?

User Avatar

Asked by Wiki User

No, I would seek another answer to the problem. If the starter starts while the car is running, it may grind the bendix or the starter into a toothless nub and the starter will quit functioning alltogether.

How do you change the headlight on a 1994 Oldsmobile ninety eight?

User Avatar

Asked by Wiki User

Open the hood and look down at the top of the head light assembly, there should be two round "dials" unscrew these and the headlight should tilt forward and allow access to the bulb replacement port.

Where is the pass-key module located on a 1992 Oldsmobile Eighty Eight?

User Avatar

Asked by Wiki User

in the dashboard,remove the glove box then it is just above the ecm.

How do you change the headlight on a 1989 Oldsmobile ninety eight?

User Avatar

Asked by Wiki User

You have to stick your hand behind the headlight. And there is a piece of plastic on the back side if the lamp. Twist it to the driver side fender and it out and you will see the light bulb.