0
Chevy Camaro RS
This category covers questions about the RS custom option for the first generation (1966-1969) Chevrolet Camaro. The RS package included hidden headlights, revised taillights, RS badging, and exterior rocker trim.
2,274 Questions
What is the size of the distributor hold down bolt on a 88 Chevy camaro 2.8L V6?
It's either a 9/16 or a 1/2 ".
Sounds like a sensor
How do you change the oil pan on a GMC Vandura 3500 6.2 diesel?
Put slick 50 in the oil and don't worry about it.
Painfully, the motor's got to be lifted, unbolt the motor mounts and try to keep the swearing to a dull roar.
What does an Error code MAF or VAF circuit low input mean?
i have replaced the maf and i still get the code what is the vaf circuit on a 1998 kia sportage my check engine light still is on VAF is the vacum airflow of the engine....if u have already replaced the MAF sensor and still are having the same problems , it could be a collasped hose on the PCV, crankcase ventilation, its generally located under the throttle body and runs towards the front.....a very cheap fix
Where is the starter located on a 1995 Chevy Camaro?
The starter is located on the passenger side of the car attached by 2 bolts to the bell housing.
How do you remove transmission from 2000 z28 camaro?
The easy was is through the front with engine. Or you get a trans jack, support pan & unbolt from block. You have to remove driveshaft/crossmember first & keep it level with engine then just roll it backwards off of convertor which will still be attached to flywheel. Take care not to damage input shaft. Front of car will have to go pretty high to roll it out.
What are symptoms of bad oil sensor?
A bad oil sensor can cause the oil light to come on while pressure is still ok. The sensor could also confuse the computer, causing it to send wrong information to the engine.
over 10,000 have been pre ordered at my neighbors Chevy lot hope that helps 'Hayden'
Does the accumulator dryer have to be replaced when the compressor is replaced?
Compare the weights of the old and the new dryers. The new one probably is much lighter. That means you need to install the new one, because the old one is loaded with crud and moisture.
most manuals recommend that you replace the accumulator whenever you replace the compressor.
How do you tell the engine size by looking at the motor not the VIN?
the only other way to tell the motor size is by counting the number of spark plugs on the vehicle. unless it is a mustang the years that they had the four cylinders they had 2 spark plugs per cylinder
Where is the flasher on a 1986 Chevy Camaro?
it is under the dash in a panel above the gas pedal . you must remove two screws to let box down.gmjim
What are opinions on the best oil filter?
FRAM makes garbage oil filters, I cut one open and the inside was cardboard.
I will only use pennzoil oil filters because It keeps the oil clean and they are very strong filters.
The WIX filters are the best in my opinion.
i had a problem may be similar to that, the problem turn out to be that i had a loose ground connection at the battery, i had 2 thick wires and a skinny wire between them, so the skinny wire was not as thight as the other 2 fat ones. and with the vibration from the vehicle it used to separate for a split second causing my engine to shut off.(that wire was the only path that my engine had for its ground) but after the vehicle stoped moving it would just start again like nothing ever happened.and yes the oil and engine light would come on too.
check your ground conections.if you were making a turn then you may want to look at another reason for that for ex, broken/corroded gas tank bafles. when the bafles go and you make a turn the gasoline would be sent to the side of the gas tank away from the fuel pump causing your vehicle to shut off until the gas returns to the center of the tank .it happens.
Can you put a ls1 out of a 2000 in a 1995 Z28?
You can put just about any engine into any car if you have the time, money and know how. It certainly wouldn't be a direct swap. You'd need the LS1 computer, sensors, wiring etc.
An 1988 Camaro won't start fuel pump doesn't kick on if ignition is in run but works when tested?
What should happen when you turn the key to run is the fuel pump relay should enable to pressurize the fuel system. And then if you do not start the car immediately it will shut off once it has pressuriezed the system. Once you start the engine the pump should kick back in to supply fuel to run the car. If everything has worked so far and once you start the car and it dies right after it starts running check the oil pressure sender. If that sensor does not detect oil pressure it will not allow the fuel pump to keep running and the engine is supposed to die. This is great if you ramp a railroad crossing and take the sump of the oil pan but not any other time. Get that sensor replaced and all should be well
If they are standing up, they are not parking. That indicates that there is a problem. It is not a matter of changing a setting. It is a matter of finding out what is wrong and fixing it. Chances are that you need a new wiper motor, because the park switch has probably gone bad.
What makes a car start overheating when its idlesbut when you start going again it cool down?
Low coolant?
Cooling fan not working?
Radiator air flow restricted?
Radiator clogged?
Water pump not working properly?
Radiator cap defective?
