answersLogoWhite

0

Chevy Camaro RS

This category covers questions about the RS custom option for the first generation (1966-1969) Chevrolet Camaro. The RS package included hidden headlights, revised taillights, RS badging, and exterior rocker trim.

2,274 Questions

Where is the transmission mount on a 91 Camaro RS?

The transmission mount for a 91 camaro rs is near the tail end of the transmission. It is connected on the top portion of the cross member. If you do not know what the cross member looks like, look underneathe the car and find the tail end of the transmission, where the drive shaft is inserted, and you will see a bar going underneathe the transmission connecting to the frame on either side of the transmission. The transmission mount sits right on top of the cross member. You will have to take the cross member off to get to the mount.

Will a 700R4 transmission fit a 92 Chevy Camaro 3.1 V6 engine?

Yes it will. My GMC S15 has 3.1 v6 Camaro engine stuffed into it with the original 700R4 tranny.

What size rims can you put on a '92 Stanza?

THE LARGEST RIMS THAT YOU CAN PUT ON A 92 STANZA ARE 17'S. BEFORE YOU PURCHASE THE RIMS,...ASK A WELL RECOGNIZED TIRE/AUTO REPAIR SHOP TO CHECK YOUR "BOLT PATTERN" AND "BACK SPACING" SO THAT YOU CAN BUY THE PERFECT RIMS FOR YOUR CAR. WITH OUT THE 2 SPECS KNOWN. YOU WILL END UP WITH A SET OF 1,500 RIMS THAT DONT FIT YOUR CAR!!!! PEACE AND IF I CAN HELP YOU AGAIN..E-MAIL ME!

How do i get a replacement key for a 96 Mazda?

29's - i have a 97 millenia and i had to visit the parts dept. at my local Mazda dealership with my registration in order to have an extra key made. my dealer had to send out for the key because it is cut differently from other keys and it cost me about 75 dollars.

Can you put steel bumpers from 1977 Camaro on a 1978 Camaro?

No, the steel bumpers from a 1977 Camaro will not fit in a 1978 Camaro, As the 1978 "Bumper" is part of the front end. Taking off the 1978 "Bumper" would mean cutting it off, which would make the car look like something else.

How are the pistons numbered in a Chevy Camaro?

before this question can be answered we will need to know what type of engine your camaro has.

What is the best coolant antifreeze for Chevy Camaro 1999?

Originally it would have had "Dex-Cool". Dex-Cool is fine as long as it is replaced every 5 years or 100K miles.

How much horsepower does a 1998 camaro ls1 have?

305hp at the crank for z28

That was the underrated notion so it wouldn't hurt the corvettes'. I say at least 320 to the crank; probably more.

What should you do when driving down a sleep grade in a car with standard?

i usually turn up the hypo-accelerator drive on the head gasket which the thrusts the cars chassis up over the dehumidifier which reduces the braking but it helps you to drive down the sleep grade

What is faster 2002 Camaro z28 or 2010 Camaro ss?

Well, lets think about this? The 2002 camaro z28 came with an 5.7 liter LS1 v8 motor putting out 305 hp. The 2010 camaro ss came with a 6.2 liter LS3 v8 with 426 hp....do the math.............

First off get out of the magazines.

2nd The Ls1 was about 340 at the crank (proven in dynos at stock form).

3rd Many 2002 Ls1 were able to pull 12.7-12.8 in stock form.

4th Ive seen 2010 SS all over the board. From 13.6-12.7 stock.

5th Horsepower is NOT everything. The 02 weighs a LOT less. Put that 6.2 in a 02 and that 02 will SCREAM. Put it in a 3rd gen and you got a literal rocket on your hands.

6th The fastest car with things MOSTLY equal is always the better driver. Ive beaten 2010 SS in a bolt-on 95 Z28 and have had my ass handed to me by some 2002 WS6.

But if you're looking at paper-statistics, the 2010 SS is about .3 seconds quicker in the 1/4

Where is the turn signal flasher unit on a 1990 Thunderbird?

Don't go to schucks or other auto parts places. They will give you the wrong part. You will either need to go online to order the right part or go to your ford dealership and ask for part #SF-585 E8OY-13350-A Signal flasher module by Motorcraft. Is is a square black box, not the regular round one most of us are used to. You will find it on the right side of the steering column, under the dash. You will need to remove the bottom plastic cover of your dashboard and the metal plate under it to facilitate the swap. You will need to first unhook it from the metal prong that holds it under the dash to lower it so you can unhook the plug, and then unhook the wiring harness/plug from the bad module. It is a pain to do and you will need to pry up on the two little plastic tabs that ironically say "push" with a small screwdriver while pulling the plug. It will take quite a bit of force, but if a wimp like me can get it... I am glad to be able to post this because this was the only question addressing my problem of intermittant turn signal problems, and there was no answer...till now.

Can you change the fuel pump on a 1991 Camaro RS 3.1 without removing the gas tank?

drain the tank, remove the trim and carpet in the trunk, remove rear seats.then you can kinda make a hatch by cutting into the metal sheeting that's above the tank. voila, a hatchay to work on the tank from above. youll have to make brackets so you can place the hatch back in, i'd use tzus clips.

AnswerNO NO NO NO

Why is the security light staying on in your 1998 camaro?

If your security light is staying on, it's a good indication that you VATS system is mulfunctioning. At some point your car randomly will not start. Most likely the case is that the wires that run from your ignition to your VATS module are loose or broken up. It's a really easy cheap and easy fix. Just search VATS on GM vechicles.

Where is the fuel filter located on a 1998 Camaro rs 3.8?

underneath the driver side between the rear tire and the door.

How fast is the 1992 Camaro rs campared to a 1988 Camaro with a 305 v8 and how much is it to install a v8?

Well the 1992 RS automatic is like 170 HP. I had a V6 Swapped out for a V8 on my camaro, I don't know how much it was. My car was a 1983 Camaro with 107HP V6, replaced it with a 1992 RS V8 170HP.

Remove voltage regulator on a 68 camaro?

Unplug it, remove the two screws and take it out.

Why does your car feel like its floating left and right?

That is usually a sign of bad ball joints and/or tie rod ends.

How would you get a battery bolt off that you can't turn with a socket or wrench on a 92 Camaro RS?

I assume you are referring to the side mounted terminals on a battery. They are very easily stripped if the wrong wrench is used or more commonly when pliers are used to tighten or remove. I have found that the best tool to use in this and similar situations is a 6" pipe wrench. It will damage the bolt but that's already the problem. It will remove a bolt that is completely rounded off. Just put it on the stripped bolt and apply a little counter-clockwise pressure and the bolt will loosen. Be careful as it is possible to actually loosen the entire terminal block requiring a new battery. It is probably stuck because it was overtightened in the first place.

What is a real 1969 Camaro z28?

It varied from a standard camaro in many ways. The Z, had a special motor, all to itself, no automatics, special suspension, ect. Ya know those little Cobra's that sell in the millions today? The cars that were for sent out in force to defeat those ferari's? Well, these, Z/28"s, were sent out kill the cobra's. To answer your question, they were factory built race cars.