0
Chevy Camaro RS
This category covers questions about the RS custom option for the first generation (1966-1969) Chevrolet Camaro. The RS package included hidden headlights, revised taillights, RS badging, and exterior rocker trim.
2,274 Questions
Where is the knock sensor located on a 1991 rs camaro?
Under hood, passenger side, lower engine area, front of starter, mounted in engine block.
Where is the throttle position sensor located on a 1999 v6 camaro?
On the top of the engine right behind the large rubber air intake hose. It is a 3" black peice held with two screws.
What is the dwell setting on a 1980 Chevrolet v8?
to my knowledge 1980 Chevy v8 engines didn't have ignition points, and dwell settings are for points.
Why would a 1991 camaro rs 305 tbi stall out when you try to take off?
needs a carbureator tune up, air and fuel mixture is off.
1991 camaro RS won't start fuel OK no spark what are common causes?
check the battery and connections. make sure the automatic transmission is in the park position. could be the starter is faulty
What would cause a 4Runner to start cold but not when warmed up?
i need a year on this one.......there are different reasons for different systems.if it has a "check engine" light on though, have that fixed first!
AnswerIt could be a crack or hole in the air intake hose. Look in between the MAF and the throttle body. When there is a tear in the hose, the MAF gets all out of whack and will start when the motor is cold, but will die when it gets warm. Another symptom is if the motor is warm and you try to start it, it will start fine, but will not idle and will die very quickly. If you do find a tear or hole, all it takes to repair it is some electrical tape to seal the hole.=It took me almost a year to figure this one out! And not one mechanic could help me.My 1990 4runner would start great when cold, but after running a few miles (like going to the grocery store) when I would try to restart it, I would only get a single click from the passenger side of the engine compartment. I went over the entire starting circuit. Main areas to look are- ignition switch, neutral safety switch, and the starter and selenoid on top of the starter.After replacing the starter (not cheap) and a lot of frustration I found that the wire running from the battery to the main fuse box was corroded under the insulation. I slit the rubber with a razor blade, and found it corroded.I replaced it with a cheap battery ground wire (around 4 bucks) and it solved my problem.Note- You may want to get a replacement wire from Toyota, since it has a special connector attached to the fuse box. I just spliced mine where it was bad.
Which car is faster between Chavy Camaro vs infiniti g37s?
The new camaro has 426hp and the G37 has 330hp. The camaro is much faster!
What are the factory colors for a 1974 Nova?
Go to NAPA auto parts and they have a catalog of all the colors for that year of nova.
What is the firing order for an 6-cylinder 89 camaro?
The firing order for a six cylinder 3800 cc 1989 Chevrolet Camaro engine is 1-6-5-4-3-2. The firing order is specified on the distributor cap.
Why won't my 88 Chevy camaro start after I replaced my distributor and my coil on a 2.8L V6?
Seeing you had the distriburetor out I would bet it's out of time, make sure the rotor is pointing to #1 plug when the engine is at top dead center on #1 cylinder.
Where is the fuel pump relay for a 1988 iroc?
driver side firewall should be 3 relays in a row ,middle relay i believe
How do you change the window motor?
WINDOW MOTOR REPLACMENT.
One quick point first. If you are having problems with rolling up the drivers side window, (or down) it is most likey the window switch in the center console. These go bad all the time.
First you have to remove the inner door panel. Which is done by removing the outer cover on the inner door handle, where you will find a couple screws behind it. Use a plastic wedge if you have one. Next you need to pop off the "SRS" cover on the side airbag. There is also a screw behind this cover. Then all you do is pop the door panel off the door. There are numerous plastic clips that hold it to the door.
Once the door panel is off, the motor should be accesable. You will want to have the window all the way up, and use some masking tape to run over the window, from side to side, to hold the window up/from falling. Once you take the window motor out the window will want to fall down.
There should just be about 3 torx screws, remove the screws and pop the motor out of the regulator. Intall in reverse order.
ALSO CHECK THE LOOM BETWEEN THE CAR DOOR AS THEY HAVE A TENDENCY TO BREAK SO PULL BACK THE RUBBER AND CHECK THOROUGHLY.
What causes a 2000 camaro to have reduced engine power?
IS the check engine light on? The computer has the capability of putting the car in a "limp home mode" if somethign is wrong. If no check engine light, your fuel filter may be clogged and blocking fuel or the fuel pump is getting weak.
At idle my 1989 Chevrolet Camero runs rough and dies what could cause the problem?
If you have a check engine light "on" then you need to have it scanned for codes. It could be numerous reasons such as a vacuum leak, loss of fuel pressure, flooding,and the beat goes on.
Which sensors have you replaced, these cars have 2 of them. One located on the thermostat housing, and one located on the rear of the block under the exhaust manifold.
Will a 1968 Camaro rear end fit on 1974 Camaro?
In the 70, the camaro got a little bit wider. The 70, and up rearend is a half inch per side, wider. 1 inch total. So, your 74 will gain a little bit of much needed wheel well space, for a slightly wider tire. However, if you are running a deep dish wheel now, that could lead to a wheel change. Now, check the leaf spring pad, to make sure that the 68 did not have a mono leaf. And, the front yoke, where the drive line connects. There are two types of yokes. One uses two straps, with bolts, to secure the u-joint. The other uses u bolts. If the yoke is threaded where the bolts go, then it takes the straps. If it is blank, then the u bolts, with nuts on the back. Brake wise, everthing should be the same.
How many seats does a Camaro 2010 have?
The car has 2 bucket seats in the front, leather or cloth, and a full seat in the back. In total there can be 4 people in the car at once.
How do you replace the muffler on a 1989 Camaro RS and how difficult is it to do?
to change the muffler is really easy as long as u don't have to much rust unger it. all u need to do is take off the clamp that comes from the exhaust pipe and then the one clamp on the other side on the tail pipe. which is easier if u take it right off from the car and put back on later then if the rust isn't to bad the pipe would slide right out of the muffle. leaving u to put on a new one
What is the base engine size of the 2012 Chevrolet Camaro?
The 2012 Chevrolet Camaro has a 3.6 L base engine size.
How much does a blown head gasket cost to fix?
Well if you have the time to do it yourself then its pretty inexpensive but it can take many hours to tear the engine down. If you take it to a repair shop you moght spend around $1200
pistons are worped
What is the proper spark plug gap on a 1992 Chevrolet Camero RS with a 3.1 liter engine?
For best results you should us AC Delco spark plugs. The gap should be .035 of an inch. Do not substitute. .045 on auto light...you should have a sticker under the hood nere the radiater
How do you loosen and or tighten the drive belt on a 1990 Ford Thunderbird?
You can't, the belt is called a serpentene belt, you have to replace the belt.
Is the filler tube detachable from the gas tank on a 1991 Chevy Camaro RS?
There are 2 different- detachable and non detachable.... Thanks Chevy.
