0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
Where is the location of fuel pump relay of Nissan Sentra 2006?
lift the rear seat bottom ouut of car.when removed you will see a 7 inch plate screwed to the floor the bolt heads are 10 mm. disconnect battery first.also use a led flashlight no,light bulbs.lift the plate and wires loosen fueul feed and return hoses. then unscrew fuel pump and fuel in one piece.make sure you use a newdealer pump aqnd new gasket so you have no leaks
78 Corvette C3 AUTO transmission fluid capacity?
According to Haynes, Automatic tranny fluid capacities for C3 'Vettes are as follows:
350 engine (1968 - 1977): routine change, 5 pints; fill from dry, 20 pints
350 engine (1978): routine change, 6 pints; fill from dry, 20 pints
400 engine: routine change, 7-1/2 pints; fill from dry, 22 pints
700 R-4: routine change, 10 pints; fill from dry, 23 pints
(page 1-2, Haynes Chevrolet Corvette Automotive Repair Manual, 9L10-24040)
sounds like there is a vacuum leak under the dash or at the slide controls, and the plenum door is not able to move to change selection.
Can you manually crank up the headlights on a 69 Corvette?
the vaccume lines are disconnected and I cant drive at night
The headlights are held in the open or closed position by an over-center spring. You can push the headlight up from underneath and it will stay in the open position.
Fluid capacities for 1976 Corvette?
Corvette Specifications 1953 - 1982
http://corvette-world.com/corvette_specifications.php
Per the title of the early 1960s TV series what road did Tod and Buzz cruise in their Corvette?
Route 66
How do you replace the ammeter on your 1966 Corvette?
You will literally have to dismantle the entire instrument cluster to access the ammeter. that includes separating the steering column from the steering box ( under hood) and lowering it down onto the drivers seat. I.E. It's also better to remove the steering wheel and set it aside. You will need room to work as you dismantle the cluster, P.S. Label all the bulb and instrument wiring as you go or you'll be real sorry when you reassemble it and find out that you've put bulbs in the wrong locations. Remedy: you guessed it. Take it apart again. Overall time to R & R gauge, approx. 5 to 6 hours. Good luck !!!
Where is the location of 1978 dodge sportsman fuse box?
Fuse box is located on the left side under the glove-box lid.
The key is worn out , u need to try pulling out w/pliers ,use a newer key
The unit seems to be broken, it's just a nylon cord that forces the antenna up, then it pulls the ant. down once the signal is lost. The nylon cord came a loose from the tip of the antenna, which is not repairable. By a new one.
Once you have repaired any and all leaks in your brake system, press the brake pedal very very hard to reset the balance valve. You may have to press so hard that you will think you are going to hurt something (or yourself), but you won't. Just increase the pressure applied till you see the light go out.
How to remove ignition switch on 89 berretta?
the ignition switch is commonly caled the key lock clyinder
If you have tilt steering then you need to take it to a dealership they will have a specail tool to remove the pivot pins in the steering column housing. this makes key lock cylinder replacement impossible for the home auto repair technician.
if it is not tilt steering 1) remove negative battery cable 2) remove steering wheel: probably need steering wheel puller for this. 3) remove turn signal switch assembly 4) place lock cylinder in RUN position 5) remove turn signal switch housing screws 6) remove turn signal switch housing and steering shaft assembly : as complete unit: 7) lift the switch tab with a screwdriver then GENTLY pull on the buzzer switch wires and remove the buzzer switch 8) place the lock cylinder in the accessory position 9) remove retaing screws fro lock clyinder and remove the lock cylinder. 10) reverse to install.
hope this helps wolverine
Where is the horn relay located on a 1995 Oldsmobile Achieva S?
It Is located in the convenience center left side of I/P above fuse block
== ==
How do you remove the heater core on a 1991 Chevy Corvette?
Sounds liek a job you may need some real help on so...I
How to replace Power window motor 1974 corvette?
Begin by carefully removing the door liner. There may be an assortment of screws and bolts holding the liner in place. Once all have been undone, gently left the liner up-wards and it should pull free from the door. Remove the tech screws that hold the large access panel and remove the panel. This will allow access to the electric motor and it's connections. Remove the electrical connector, reach into the door cavity behind the motor and feel for the three retaining bolts hold the motor in place. Undo the three bolts - the window motor should now be free to move. Carefully, wrestle the motor free of it's position and remove from door. Replace the motor by following the reverse of these brief instructions.
What is the firing order and distributor cap for 1992 corvette convertible?
All V8 Chevrolet's are 1,8,4,3,6,5,7,2 with 1,3,5,7 on the left bank and 2,4,6,8 on the right with the distributor rotating clockwise.
How do you remove a radio from a 1981 Chevy Corvette?
Begin by removing the decorative radio cover from your 1981 Chevy Corvette radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
Where can you find a spark plug wiring diagram for a 1996 gmc sonoma?
If the coil packs have not been replaced then they will be labeled 1-4 in
white numbers next to the terminal. The pack located on the lower side of
the ignition module should be 2 / 3 and the top 1 / 4.
What is the name of the silver Corvette from transformers revenge of the fallen?
The silver corvette stingray concept car in the movie is called sideswipe :)
