0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
a prom code is a id number stamped on a prom chip to identify the make and model the chip is for and also what commands and parameters are burned into the chip prom stands for (program read only memory) it tells the car when to shift what fuel mixture to use,when the cooling fans turn on,speed top limit and so on, the prom chip plugs into the cars pcm and controls input output parameters.
What Chevrolet parts are interchangeable with Corvette parts?
2010 back end with a 2001 corvette back end
How do you remove seat bucket from 1979 corvette?
there are bolts through the seat tracks both front and back. Move the seat back to access the front bolts and back to access the front. You should be able to use a 3/8 ratchet and extension -- I think the bolt size is either half inch or 9/16. Once you have the seat assembly out of the car it's pretty much self explanatory. The cushions are held in by a simple retainer and snap out fairly easily. If you are replacing the hard (bucket) part you'll need to take the three screws out of the hinges on each side to get the top part off. This is a fairly easy procedure -- just becareful with the hardware. Good luck! Jack
Code 72- VSS signal circuit error. Check the VSS and circuit for short to ground or open circuit, a bare wire can cause an intermittent problem. Verify this first. Also check the VSS to make sure no excessive material has built up on the magnetic end, such material from the transmission wearing over a period of time cause deposit fine shavings on sensor head interfering with sensor operation. Wipe clean with paper (not cloth) towel to remove material and reinstall. A newly rebuilt transmission can deposit these quick enough as the transmission is "breaking in". If all else checks out, replace sensor.
How do you release the trunk of a 1999 convertible corvette?
There is a button on left side of the dash with a little truck lid on it.
How do you change the battery in a C4 corvette?
open the hood and remove the little side skirt next to the battery. i believe its one bolt on top, one hidden bolt on bottom and like 3 alen skrews in the wheel weld.
Remove the dash panel cover. Remove the speedometer retaining ring. Remove the cable from the back of the speedometer. Reverse the process to install the new speedometer.
Where is the fuse box in the 1988 928 s4?
Passenger side, against the firewall, under the floor mat, you can't miss it.
Where are the fuel injectors located on a 1989 f-150 5.0 V8?
lower intake manifold and the fual rail.
How do you change the oil pressure sensor on a 1999 Corvette and where is located?
I have a 2001 and I have had to replace the sensor 3 times in the last 2 years. If you have a mechanic with reasonably small hands there is no need to remove the intake. My Intake has never been off.
Where is the VIN located on a 1959 Chevy Corvette?
check on the drivers side door, that's where its located on my 77 Ford Pickup
========new answer headline========The VIN should be located on a plate on the left front door hinge pillar post. For 1959 the numbers were: J59S100001 to J59S109670 according to STANDARD CATALOG OF CORVETTE, the first symbol (J) indicates Corvette. The second and third symbols (59) indicate the model year. The fourth symbol indicates the assembly plant (S) = St. Louis, Mo. The last six symbols indicate the sequential production number. The body number plate was located on the engine side of the cowl. The Fisher Body Style Number 59-867 identifies a Corvette. The Body Number is the production serial number of the body. The Trim Number indicates the interior trim color and material. The Paint Number indicates the color combination.
How do you reset the corvette service engine light 1986?
Disconnect the battery for about 10 seconds, then reconnect.(Note...when the service engine light comes on, it means that the computer has set a fault code indicating there may be an engine sensor bad, you may want to have that checked out and have someone read the code before you reset it.
Does a 1990 corvette have another fuses box other than the one by the passenger door?
under passenger side of dash remove panel were interior light is and you will see fuse holder with four fuses
How do you Change 1978 corvette valve cover gasket?
Remove the valve cover.....scrape off old gasket.....clean gasket surface on valve cover....apply gasket sealent to valve cover gasket surface.....set gasket in sealent.....reinstall valve cover.
Does a 1970 Corvette have a removable transmission crossmember?
'70 corvettes do have a removable crossmember, independent of transmission type.
'68 and '69 corvettes have a welded crossmember for manual transmissions and removable crossmember for automatic transmissions.
Where is the Turn signal relay location on 2000 corvette?
It takes about an hour to install and you need to remove the console and radio to install (at least this is the easiest way I have done and seen)
Can c4 corvette wheels fit a prelude?
No they will Not, Vett is too big too wide, not enough turning radius
Why will your ignition on a 1976 corvette not return to the locked position?
Could have something to do with the shifter not going all the way in to park. The key may be excessively worn, the pin that locks the steering wheel may be hung up, the lock and tumbler may be bad....
What is ignition timing for 1978 Chevy Corvette?
6 degrees for the stock engine, or 8 degrees for California emissions, or 12 degrees if it came with the high performance engine. Standard or automatic transmission is the same.
How do you reset the change oil light on a 2008 Chevy Corvette?
after changing your oil, press the TRIP function by the steering wheel until oil life is displayed. It should be at 0%. Then hold the RESET button for a few seconds and it will clear it and put your oil life at 99%.
