0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
Where can you find a wiring diagram for the spark plugs on a 1987 Chevrolet Camaro 28L V6?
Firing order is 1-2-3-4-5-6 Distributor rotates clockwise. Number 1 plug is located on passenger's side front of engine. Number 2 plug is on front of engine driver's side and so on.
How do you troubleshoot a horn that doesn't work on a 1996 corvette?
it may be the horn relay..it may be a fues it may be the horn itself....but im just 16 what do i know
Do you know where to find the fuse box on a 1974 Corvette stingray?
Should be up under the dash on the drivers side just left of the steering column.
I can' help with a diagram. I can just suggest you do them one at a time, so as to not need a schematic.
What is normal coolant temperature on a 2000 Buick Le Sabre?
Normally 180 On hot days it might go to 200
How do you program a key fob on a 1998 corvette?
Hold down the lock and unlock buttons together for 5 seconds or until you hear the horn/hear the locks. I have a new fob (correct part number) but it does not set with the above instructions.
Does the ignition key have to be in, should the auto lock on the fob be in the on position?
If that did not work you may need to match your transmitters by doing the following:
To match transmitters to your vehicle:
1. Turn the ignition key to ON.
2. Clear any warning messages on the Driver
Information Center (DIC) by pressing the
RESET button.
3. Press the OPTIONS button on the DIC several times
until the blank page is displayed, then press and hold
the RESET button for two seconds.
4. When the message FOB TRAINING is displayed,
push the RESET button once. The message
HOLD LK + UNLK 1ST FOB in the DIC will
be displayed.
5. Press and hold the LOCK and UNLOCK buttons on
the transmitter simultaneously for 15 seconds.
6. When a transmitter is learned (matched), the DIC
will display FOB LEARNED and then prompt you
to learn the next transmitter.
7. Repeat Steps 5 and 6 for each additional transmitter.
8. Remove the key from the ignition.
The programming mode will shut off if:
You don't program any transmitters for two minutes.
You take the key out of the ignition.
You have programmed three transmitters.
Why would a 2000 Corvette not start after the battery is changed?
i had this problem with my 2004. It has to do with the antitheft system. that and shutting down when you hit 7 mph. I forgot what it said to do, but it had something to do with the key. Unfortunatly mine had half broke off in ignition and other i used to start. coulndt remove whole key, so i had to pay big buck for computer to be reset.
Why does my 1996 Corvette LT1 over heats at idle?
The fan engagement threshold is set high in those cars. I have a 96 myself and it gets above 220 before the fans kick in. I would by a programmer for the car such as hypertech to set the fan engagement to a lower level. Or a cheaper solution would be to hook up a toggle switch for the fans to come on when you need them. This is all assuming your fans work at all. Next time it heats up, turn on your AC. If the temp falls, your fans are in working order :).
Where is the fuse panel on a 1970 Corvette?
It is under the dash on the driver's side near the hood release.
Where is the car from Corvette Summer?
The Corvette from corvette Summer is in Effingham, IL at Mid America Motorworks. Mike Yager has it.
What does hzh mean for a Corvette?
The HZH designation for the Chevrolet Corvette signifies a limited production run especially for Hertz Rent A Car...they're all yellow with a black accent stripe and have the LS3 version of the engine rated at 436 hp...
How do you tell a turbo 350 transmission from a turbo 400?
The TH 400 has the vacuum modulator attached to the passenger side of transmission.The TH 350 has the vacuum modulator attached to the rear of transmission.
The transmission oil pan on the TH 400 is anything but square.
Why did they not make a 1983 Corvette?
they did make an 83 vette but they were all recalled due to all kinds of problems in the metal and paint and body of the car.
Where is VIN location in 1965 Corvette?
I believe that it is underneath the passenger side glovebox welded onto a metal bar. Both are there. If you need to decode it, I found a website that will help you out tremendously. http://vettehead.com/how-to-decode-a-corvette-vin-1965-1971/. Just copy and paste it. If you are just researching it or just curious I found another website that will help you out will options and specs.http://www.vettefacts.com/C2/1965.aspx. Just copy and paste that too if you want. I found on that website that "The "Vehicle Identification Number" (also VIN or serial number) is located on a stainless steel plate welded to the right side hinge pillar cross-brace under the glove box. The "Vehicle Identification Number" (also VIN or serial number) is located on a stainless steel plate welded to the right side hinge pillar cross-brace under the glove box.
Where are oxygen sensors on c5 Corvette?
There are four of them. Two of them are before the cats and two of them are right after the cats. For a nice diagram of the 02 sensors, jump on over to Smokinvette.com! Good luck!
Where is the ALDL connector on a 1984 C4 Corvette?
There is a schematic diagram of the connectors for all the Corvettes over at Smokinvette.com. Feel free to jump on over and check them out. Good luck!
What kind of fuel does the 2003 Chevrolet Corvette use?
The 2003 Chevrolet Corvette runs on premium unleaded (required).
Where can one purchase Corvette brakes?
You can purchase Corvette brakes at the v band p website. They have good prices on Corvette brakes and they have a variety of brands to buy. Visit their website for more information.
Why does my 1981 corvette's battery keep dying?
Short in the electrical sytem. A reputable garage should be able to trace it down to the component that is causing the problem.
Where is the trunk release on your 2007 ford mustang convertible?
There is no trunk release in the car the only way to open trunk is with key or your key fob
Where is the oil pressure switch located on a 1988 corvette?
There are two factory locations for the switch. One could be located on the back of the intake manifold next to the distributor, or right behind the oil filter close to the transmission bell housing. If it's an idiot light, the sending unit (switch) will be a single blade conector that is over all 1 3/4 inches long. If its a pressure gage, then it will be a bell shape, aprox. 2 1/2 inches long with a single or duel blade conector
From several thousand degrees at the centre of stars to about three degrees above absolute zero in the background radiation. Take your pick
Do any corvettes seat four people?
Not from the factory.
Unless you're talking about midgets. Then you can probably seat six.
How do you remove front license plate cover 2000 corvette?
Lay down on the ground in front of the cover,look between the cover and the bumper and you'll see two Phillips head screws.remove them and your cover will be off.I just did this.
