0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
Is it possible to fit a 1982 or 1976 Corvette rear bumber on an 1984 Corvette?
NO. Do not attempt to do so, as the bumper will be extremely unstable.
How do you replace a tail light bulb in a 1988 corvette?
Remove license plate, dissconnect backup light wire, remove bolts to backup light, pull backup light sideways, reach hand to tail light, twist socket.
Where is the ignition module 1984 Corvette?
The ignition module is located in the distributor under the rotor, it plugs in.
Why won't 1969 Corvette shifter go into reverse?
The linkage that connects the shift lever to the transmission could be out of adjustment or the reverse gear in the transmission itself could be bad. Usually it's the linkage.
check the altinator
Which is the fastest Corvette?
The fastest Corvette is the Chevrolet Corvette ZR1 with a top speed of 225 mph.
How do you replace left fender on 1976 corvette?
ANSWER: Well, go buy a new one, paint it to match the color of the car, unbolt the old one and bolt the new one in. There.
Where is the ecm located on a 1995 Chevrolet Corvette?
ithe ECM is located under the hood just above the battery, cant miss it
How do you replace the battery in a 1994 Corvette?
To remove the battery on the 94 Vette, the side panel needs to be removed.The battery will slide out the side once the hold down bolt is loosened.
I have a 1994 caprice wagon with a 350 in it and I just removed the oil pan. It was a hard job to do.First of all the oil pan bolts were hard to get to. Then I had to remove the starter and the oil cooling lines and the oil filter housing with a Allen wrench (metric). then I had to remove the motor mount bolts and jack the engine up as far as it could go and I barely had enough clearance to get the oil pan off.So I guess if you had to do it it could be done... Hope this info helps you out.
How do you reset the dual climate control on a 2000 Corvette?
You can try this: press the AUTO button, the current settings should be displayed, note that the system will default to MANUAL if the driver temperature settings are at the extreme, example 60 degrees F or 90 degrees F. Set the temperature you want by rotating the driver knob. The set temperature will be for driver and passenger and will be remembered each time you turn the ignition off and restart in the same settings. To start out on the passenger side, set the passenger knob in the 12 o'clock position so it will be the same temperature as the drivers side setting, you can adjust from there later. The AUTO settings will affect the fan speed and the air delivery mode. Keep in mind if you have the optional MEMORY setting, located on the drivers door, it will recall the settings for the climate control in the memory setting which is activated when you use the key fob set for it.
Pull the lower dash panel to get access to the lever better. Tough to do but I layed on the floorboard, looking up, and slid the cable end back into the lever. I then tie-wrapped both cables (L & R hood release) together to prevent one of them from shifting around and coming back out.
How do you install a cargo shade in a 1995 corvette?
the cargo shade has loops on it, and if you open the hatch you will see how the loops go around the posts that keep it anchored == ==
It will probably run around 210 or a little higher. If it starts getting close to 240 or 250, your nearing the to hot for very long range. Answer
The coolant should be within a few degrees of the thermostat value. If you have a 190 degree thermostat, the temperature should be within 10 to 20 degrees.
Another way to cool down is to put the defroster on or the ac. This turns the fan on without waiting to get to the danger zone. If it doesn't go on you might be low on freon.
I use the defroster mode when I'm in line for inspection or stuck in traffic.
What is the alternator clock position on a late 1986 corvette?
If driver side mounted 2 clock if pass side 10 oclock veiwed from front
Why won't the headlights close down on a 98 Pontiac Firebird?
This happened to me also. My problem was the plastic gear inside the motor had broken teeth. I bought brass gears and had both gears replaced. You may have blown a fuse also. The fuses are located under the hood on the drivers side. The owners manel or fuse panel will tell you the location of the fuses.
How many quarts of oil for a 1965 327 Chevy motor?
5 quarts with filter change if it is a stock oil pan.
Where is the inertia switch located on a 2001 Chevy Corvette?
there is not an inertia switch on a corvette, or for that matter any Chevrolet product. I am an ase master and have been with gm for 16 years.
Will Corvette LS3 engine fit in c5 Corvette?
Yes it will, to get the details on the swap feel free to drop by Smokinvette.com and just ask the question in the C5 section! Good luck!
Where is the fuel filter on a 74 corvette?
It is actually located in the carburator. Find the fuel line going to the carb. Where it attaches to the carb you have a small (Probably 9/16) fitting that screws into a larger fitting. The filter is behind the larger fitting. It is about the size of your thumb and has a small spring with it.
Did Chevrolet build a convertible Corvette in 1984?
No,the Corvette convertible premiered in 1986 for the 1st time since 1975.
