answersLogoWhite

0

🚗

Chevy Impala

Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.

4,997 Questions

What does the code code PO135 and PO0420 Chevrolet impala?

Trouble code P0135 means: HO2S Heater Performance Sensor 1 Trouble code P0420 means: Catalyst System Low Efficiency (Bank 1)

How to Program keyless remote 2004 impala without factory radio?

go to programyourremote.com........ i dont have a owners manual. yes i can get one. but i need alillte more info.

How do you remove the radiator plug on a 2001 Chevy Impala 3400V6 engine?

I am trying to drain old antifreeze and replace with new and cannot figure out how to remove the radiator plug on my 2001 Chevy impala 3400V6 engine?

How Reset engine code 2006 impala?

Disconnect positive battery cable and step on the brake the after 10 mins reconnect the battery cable andthe computer will be reset

How do you remove the door panel on a 1999 Daewoo Lanos?

have to remove the glass mechanism handle the three bolts in the bottom of the panel the rest are clips pull them

The Daewoo Lanos 1998 has only 2 screws at the bottom and one in the handle. I tried the shoe string thing to remove the window crank, without successs but managed to get the circlip out using a flat trowel to separate the window crank from the inner spacer and then hooking the circlip out with something thin with a hook. Getting the circlip back on again afterwards proved a lot more problematic. Mark

There is a small black plastic piece that surrounds your door handle. You MUST take that off, I find a small flat tip screw driver works best. The plastic cover that goes on the inside part of the door where your mirror is should be removed, makes it a lot easier to remove door trim: No screws on that part just grab from both sides and pull. 3 screws on bottom and 1 screw inside the armrest. The window crank, easiest way tried and true, shoestring, pull handle towards inside of car until you have enough room to fit the shoestring between crank and plastic washer. Give it a pull back and forth and it'll pop right off; clip should stick to shoestring as an added bonus.

Robert Cravens_Robert@yahoo.com

To put the handle back on simply clip the circlip onto the handle and then push the handle onto the spindle

How do you remove door panel to replace speakers 2002 beetle?

I just removed the drivers side panel the other day. There are 3 torques type screws on the bottom of the panel and 2 on the handle. I didn't realize they were there at first, not until I noticed the panel pulling away on the sides and not the center. Anyway, you must remove the handle cover to access the 2 screws. Simply pry it out, it just pops inplace with clips. Once you have the all the screws out, lift up slightly on the panel to clear it of the window trim and lock rod now pull it back and disconnect all the wires and door latch cable and you are done. Removing the speakers is a different animal all together. I hope this was some help.

How do you remove the right rear door panel on a 2001 ford focus?

find yourself the correct bit for your drill or driver and go along the outer edge of the door panel and you will find the first screws to remove, then you have to remove the plastic cover on the armrest handle where you will find another screw and you will also have to remove the black plastic piece that houses the door handle.

What is wrong with my 2001 Corvette if my service active handling service abs and service traction system indicators are on?

I had the same problem on my 2001 corvette coupe. It was a pinched wire that was causing an elctrical problem. It was all labor to have it fixed. I think it cost me about $300

FM: canonjohnr - lay under front of car, locate front sway bar. Large elec conduit parallels sway bar. two lines go to fans and one line goes to bottom of steering unit. The steering unit line has a blue tipped connector. Somewhere in this connector and the line into the main conduit is a corroded connection (oxidized), a loose connection or bad connection. I found mine today(04/11) and will repair soon.

2001 impala you hear a eeerrrhhhmm sound as your brake pedal forces itself upwards for about 2 seconds that's when the message system displays service your traction then disables it?

the traction light comes on telling you there is a low traction condition, not that the system needs service. the anti-lock brake system is the noise you hear. it is a series of hydraulic pumps that is cycling the brake pressure on the locking wheel. that is also what you feel on the pedal. the system is working as it should.

How do you change a thermostat on 04 Chevy Impala?

Partially drain the radiator into a container. Remove the upper hose at the engine end. Remove the 2 bolts that hold the thermostat housing and remove the thermostat. Clean both surfaces and install the thermostat, install the housing and the 2 retaining bolts. install the upper radiator hose and top off the coolant. It is located at the engine end of the top radiator hose in the thermostat housing.

What is the cargo capacity of the 2011 Chevrolet Impala with all seats in place?

The 2011 Chevrolet Impala has 18.6 cu.ft. of cargo capacity with all of its seats in place.

What AC refrigerant 'freon' is required in 1999 Chevy Impala?

A 1999 model year vehicle uses R134a refrigerant (it's only Freon if it's manufactured by DuPont, who trademarked the name).

What could cause a 2002 Chevrolet Impala abs light to come on?

There are numerous things that can set an ABS light. You need to have it scanned for codes and have it diagnosed. If the speedometer is not working then the speed sensor in the transmission will cause it.

How do you change bulb on instrument panel of 2000 Chevy Impala?

you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.

Where to put freon inside a 2002 Chevy Impala?

The air conditioning system of a 2002 Chevy Impala does not use Freon; HFC-134a is now the refrigerant of choice, Freon was made illegal as of January 1, 1996.

The 2002 Chevrolet Impala Repair Manual is available for about $35.00; you will need this as I don't believe the procedure can be adequately described, and the diagrams are not legally available on the internet. However, if you can find the air conditioner's coils on your own, or in the owner's manual, there will be a valve somewhere on or adjacent to these coils where coolant can be injected. You can download an owner's manual for free from GM, but you have to register.

http://www.gm.com/gmownercenter/

Rear speaker wire which is the positive in a impala ss 1994?

It will be the wire without the black line on it. Usualy the black line on a solid color will mean negative (-)

How do you change the wiper blade on a 2007 Impala?

The 2007 Chevrolet Impala has the most common hook-end wiper arms. See the Sources and Related Links section below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.

Where is radiator drain plug for 2004 Chevy Colorado?

There isn't a radiator drain plug. Instead, you have to loosen the lower radiator hose and drain the fluids. Be careful and don't do it after running the motor. Do it when the fluid is cold/cool. Also, wear eye protection, as the fluid tends to go everywhere!!

Where is 2002 Chevy impala zerk fitting where to lube?

there are no grease fittings on the newer cars, all ball joints and steering parts are permanitly sealed.

How do you replace the thermostat located on a 2000 Chevy Impala 4 cylinder?

The 2000-2005 Chevrolet Impala only came with a 3.4 and 3.8 V6 (6 cylinder) engines. Are you sure that you don't have a Malibu instead?

at the emd of the upper rad hose you will find the thermostat housing. Take the 2 bolts out and remove it. When reinstalling it make sure the spring on the thermostat goes toward the engine.