0
Chevy Impala
Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.
4,997 Questions
Why does serpentine belt on 2002 impala keep shredding?
belt tensioner is bad or one of your pulleys that the belt rides on is bad or out of alignment.
Where is the radiator drain plug for a '02 Chevy Impala 3.4?
== == It is located at the lowest level of the radiator, and it looks like a miniature water tap. Be careful not to try to drain it when the coolant is very hot, you could get burned. You will need a very large container to hold the coolant, at least 6 gallons in size.
How do you remove the interior door panel on a 1995 Toyota Avalon?
i have a 97 Avalon and just took the door pannel off so i could get a better look at the speakers. there are 3 screws on the bottom of the door, 2 under caps near the hinges, and another under a cap near the handle. once you remove these, you must take out the pannel that holds the window switches, locks, ect. you will see a screw near the rear of the opening, that is the last one. you may then slide the whole interior pannel up and thus remove it. you will also have to unplug a few wires
On the '95, there are two screws at the very bottom, two under the caps on the arm rest, and then on the sides you have two little plastic peices. Push in the center of them, and pull up on the panel. The right side will prob stick down, so pull up the left side first. I just walked back in from taking off my '95 panel.
What type of power steering fluid and engine oil does a 1995 Pontiac transport se minivan take?
ordinary run of the mill good quality power steering fluid oil depends on the temperature above 0 degreesF 10-W-30 is recommended below 0 degreesF 5-W-30 is recommended should change your oil every 5000 km or 3 months anyway
How do you remove the door panel in a 2002 Mazda Familia?
remove screw in door handle latch and the main big handle.depends what sort of door it is, you might have to prise off the outer plastic trim of the handle.think theres more screws in the door bin.then get big screwdriver and prise the door panel off, starting at the bottom.if its holding anywhere, check for screws in that area. when its hanging off the top window strip, lift the panel upwards to free it.
Where is the cooling sensor located on 2000 impala 3800 V6 engine?
It is located on the radiator. Go to the link on the right there is a procedure posted there with pictures that will walk you through the process
Where are the spark plugs located in a 2002 Grand Am GT and how do you replace the spark plugs?
they are three in front and three in back just below the valve covers 5/8 wrench should fit them. unscrew them out and replace with new ones and your done. would be a good time to change plug wires also
How to replace the flasher on a year 2000 Chevy impala?
Flasher is incorporated with Hazard module. Remove front of dash to replace
Why do the blinkers go out on a 2001 Chevy Impala and then come back on?
ON MY 01 IMPALA MY TURN SIGNALS STOPPED WORKING SOMETIMES AND THE PROBLEM GOT WORSE UNTIL THEY FINALLY QUIT ALL TOGETHER . THE DEALER TOOK PART OF THE DASH OUT AND INSTALLED A NEW 4 WAY FLASHER AND IT FIXED THE PROBLEM FOR 85 BUCKS .
go have your car serviced at the dealership. they can fix it.
Where is the radiator drain plug for 200 Nissan altima located?
On the bottom of the radiator, driver's side. It's a plastic phillips-head screw.
How do you replace the cooling fans on a 1999 LHS?
There are two ways, each with benefits. The first is to locate the four mounting bolts of the fan shroud on the back (engine side) of the radiator, remove them, disconnect the electrical supply to each of the fans and wrestle the shroud containing the fans out of the car. It may be necessary to loosen the belt tensioner and move the serpentine belt out of the way. I have done it like this, but getting to all of these shroud bolts can be frustrating. The second way is to drain the radiator from the petcock located on the lower passenger side of the radiator, remove the radiator hoses (being careful when coolant wants to drain from the hoses still attached to the block), remove the transmission cooler lines, remove the four mounting bolts securing the radiator to the frame and lift the entire unit out. Remove the fans and shroud and replace. These two methods are close, because the shroud bolts can be difficult to get started once they are out while everything is still in the car. Irregardless of which method you choose, be very careful of things bumping the radiator as it is easily damaged.
Why did the cigarette lighter stop working on your 2004 Chevy impala how do you fix it?
Check power to receptacle if none Check fuses If you have power maybe lighter element replacement available at Wal-Mart or auto parts
on the my 2002 impala there is a fuse on the passenger side just above the aux fuse that controls the driver side cigarette lighter. the fuse that is listed in the manual on the driver side fuse panel does not connect to the lighter. a continuity check between the fuse panel and the lighter confirms that.
Let Me tell you friend... My '03 impala has a bad cig/ltr socket. After half my hair came out I replaced it and stopped letting pennies and dimes fall into it. The aux pwr. socket won't work without the cig/ltr socket in the circuit or it's fuse being blown. Why the two circuits are tied in this manner.?. I don't know.
Not if you claim you're an eccentric millionaire.
How do you reset the abs light on a 2001 Chevy Impala?
The ABS light is on because there is a problem with the system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself.
Is there a fuel pump safety switch on a 2002 impala?
GM vehicles do not have a fuel shut off/inertia switch
Can you turn a 1968 Chevy Impala into a 1967 Chevy Impala and How can i do that?
No you cannot, unless of course, you are wanting to spend several tens of thousands of dollars in mods. The 1968's body lines are not as pronounced, the tail lights are completely different, and the front end is as well. Sorry, it's not a reasonable expectation to be able to convert between the two.
The above response is from a different person.
I, actually being a proud own of one unlike the guy above, can say yes you can. You will spend some money, but not in the 10s of thousands. I have a 67 4 door hardtop and am about to wrap up the restoration in a couple weeks, (turned it into a metallicar clone like the one from the show supernatural, which I'm assuming you are trying to do with a 68.) What do you need? You need a donor 67 for the front end. You need the grill, fenders, bumper, lights, radiator support, etc. For the rear, you will need the rear from a 4 door or convertible. It could be a caprice, impala, biscayne, etc. There were a bunch of models, but basically the same car. Most of these parts are not reproduced, hence why you need a donor car in order to do this. That will take care of the exterior. You will need to swap out interiors if you are to copy the 67's interior because they ARE different. One more note, if you are building a metallicar clone and do not have a 4 door HARDTOP SPORT SEDAN, do not waste your time. The regular 4 doors are not worth a cent, and they look nothing like the one from the show. They have a different roofline, pillars where there should be none, and the rear windows at the top corners are different. It took me 2 1/2 years to find a 4 door sports sedan. They are extremely rare, but you will find one. I know a guy who has a couple for sale right now. He's on cardomain. Look up mpick on car domain in the 67 impalas. talk to him.
What is the maximum cargo capacity of the 2013 Chevrolet Impala?
The maximum cargo capacity of the 2013 Chevrolet Impala is 18.6 cu.ft..
How many miles is to mamy for a used Chevy impala?
I would not buy one with over 150,000 miles on the odometer
How come your ABS and traction light came on 2000 grand marquis?
If the lights come on and stay on, there is a failure in the abs/trac system. Most abs failures (on average) are caused by a bad wheel speed sensor. Someone will need to hook up a scan tool and retrieve any diagnostic trouble code set in the system. I am not a Ford technician but I imagine that any reputable repair shop should have a generic OBD scanner capeable of retrieving the code.
