Where is the thermostat located on a 1998 Chrysler Concorde lxi 3.2L?
Under the motor on the drivers side towards the front of the car. Follow the lower radiator hose from the radiator to motor to locate it.
Sorry, but that is wrong. The thermostat is under the cover where the TOP radiator hose attaches to the top of the engine block...
Location of water pump in a 1998 Chrysler concord 3.2 engine?
It is located in line with the crank pulley and cam gears, behind the stamped and cast covers. Always advisable to replace the pump when changing the t-belt.
Where is the thermostat on a 3.5 engine in 2004 Chrysler Concorde?
It is under the housing where the lower radiator hose hooks to on the engine.
It is under the housing where the lower radiator hose hooks to on the engine.
Where is the fuel cut off switch for a 1997 Concorde?
A Chrysler Concorde does not use a cut off switch.
Where is the thermostat located on a 1989 Mercury Sable?
Follow the top radiator hose back to the engine. There is where the t-stat housing is. Remove the hose, remove the housing, remove the old t-stat, clean gasket surfaces install the t-stat into the housing with the spring side sticking out toward the engine, use spray adhesive to attach the gasket(DO NOT USE RTV), reinstall everything and be careful to evenly tighten the housing bolts until they are snug(DO NOT RAUNCH HARD ON THE BOLTS). Fill the cooling system with a 50/50 mix of coolant and water, and burp the system.
How do you fix a 1994 Chrysler Concorde that won't restart at normal temperature?
Parts fail sometimes when hot. Check to see if theres spark when it hot and doesn't start. This may be the ignition coil/pick up assembly(inside the distributor)... D
Where is the fuel pump located in a 1998 Chrysler Concorde?
if its the same as my 93 Chrysler Concorde its in the trunk, you first have to pull the lining out of the trunk, than it should be right under that on the right side. pretty convenient and genius if i do say myself puting the fuel pump that easy to access.
What makes your 94 Chrysler Concord keep dying?
There is a recall on that car because of an electric system malfunction. See if your vin is on the recall list. Dealer will fix for free.
Where do you add transmission fluid on a 1994 Chrysler Concorde?
Go to Wal-mart (Target, etc...) but a long funnel with a small end on it, remove dipstick place end of funnel in dipstick opening (yes, where the dipstick usually inserts) add fluid. (don't over-fill) MAKE sure you use the right fluid!!! Chryslers take ATF + 4 from the dealer!! or you might create a problem!!!
How do you get to the battery on a 1998 Chrysler?
You need to talke out the airfilter and its box first than you replace the battery. hope this help...
The transmission computer uses it to know the rotating speed of the input shaft.
Speaker size for 1999 Chrysler Concorde lxi?
6 3/4 inch get some 6 1/5 inch and buy adapters to fit. ebay its a beautiful thing.
What could be the cause of an engine running rough in a 1997 Chrysler Concorde?
i had the same problem, had tried everything and finally found out that the intake gaskets were prone to leak water around the number 5 cylinder. It would cause the gasket to leak around the intake port and make the engine run ruff. Also do you have a coolant leak and have to keep adding coolant this is were it will be at. hope this helps.
Where is your crank sensor in your Chrysler concord 93?
Passenger side of the bell housing, just behind the engine.
What would cause the heater in a 1998 Chrysler Concord to blow cool air?
Check the coolant level...if the level is too low, it will not flow through the heater core. Next, check the thermostat. If it is sticking, it will not let the coolant heat up. These are inexpensive, and easy to change by the owner. If none of these work, have the heater core checked by a mechanic. An obstruction in the core, or the heater hoses, will keep coolant from flowing through the core, thus not heating the air.
Where is the speed sensor located on a 2004 Chrysler Concorde lxi?
There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.
Hello has any body have a way to check a water pump to see if its working ?
--------------------------------------------------------------------------------------------------------
I'm not a mechanic / technician but what I do is with the engine warmed up , so
I know the engine cooling thermostat is open ( the top radiator hose is warm )
and without catching any clothing etcetera in the moving parts , I gently squeeze
the top radiator hose and than let it go slightly , if the water pump is working
I can feel a surge of engine coolant going through the hose